RETRACTED: A likely role for a novel PH-domain containing protein,PEPP2, in connecting membrane and cytoskeleton

The published article titled “A likely role for a novel PH-domain containing protein, PEPP2, in connecting membrane and cytoskeleton” has been retracted from the BIOCELL, Vol. 36, Issue 3, 2012. Title: A likely role for a novel PH-domain containing protein, PEPP2, in connecting membrane and cytoskeleton Authors: Yi Zou and Wenping Zhong URL: http://150.109.118.215/uploads/attached/file/20190102/20190102065508_87612.pdf The article “A likely role for a novel PH-domain containing protein, PEPP2, in connecting membrane and cytoskeleton” (Biocell 36, 127-132, 2012) has been retracted after publication by decision of the Editor-in-Chief, after he received compelling evidence indicating that the article’s content was part of a doctoral thesis and that the supervisor had not been included as an author. Also, the published work is the legal property of the University of Adelaide, and the author has not properly recognized the origin of the actual funding but, instead, has falsely attributed the funding to Jinan University and the Science Foundation (Ministry of Education of the People’s Republic of China). Tech Science Press is fully committed to enforce strict ethical policies and follow the COPE Retraction Guidelines. The essential condition of submission of a paper for publication in BIOCELL is that authors must declare explicitly that their works are original and have not been previously published elsewhere. Re-use of any data should be appropriately cited. To set the record straight, we hereby announce the retraction of the paper, and would like to sincerely apologize to our readers for any inconvenience this may have caused.     

Chemical reactions and morphological stability at the Cu/Al2O3 interface

The microstructures of diffusion‐bonded Cu/(0001)Al₂O₃ bicrystals annealed at 1000 °C at oxygen partial pressures of 0.02 or 32 Pa have been studied with various microscopy techniques ranging from optical microscopy to high‐resolution transmission electron microscopy. The studies revealed that for both oxygen partial pressures a 20–35 nm thick interfacial CuAlO₂ layer formed, which crystallises in the rhombohedral structure. However, the CuAlO₂ layer is not continuous, but interrupted by many pores. In the samples annealed in the higher oxygen partial pressure an additional reaction phase with a needle‐like structure was observed. The needles are several millimetres long, ～10 µm wide and ～1 µm thick. They consist of CuAlO₂ with alternating rhombohedral and hexagonal structures. Solid‐state contact angle measurements were performed to derive values for the work of adhesion. The results show that the adhesion is twice as good for the annealed specimen compared to the as‐bonded sample.     

A class of slipline field solutions for metal machining with slipping and sticking contact at the chip-tool interface

In the present investigation slipline field solutions for orthogonal machining are presented when the plastically stressed region in the chip/tool contact length consists of both slipping (τk) and sticking (τ=k) zones. The interface friction in the slipping region is assumed to obey Coulomb's law and the fields are analysed using the linear approximation to the above non-linear boundary value problem as suggested by Dewhurst. The range of validity of the above slipline fields is examined from the consideration of overstressing of rigid vertices in the assumed rigid regions. Results are presented for variation of cutting forces, cutting ratio, chip curl radius and contact length with variation in rake angle and interface friction coefficient. Solutions incorporating elastic effects are obtained by the method suggested by Childs. Results from the theoretical analysis are compared with experimental values reported in literature.     

A finite element simulation of the two-dimensional head/tape interface for head contours with longitudinal bleed slots

The two-dimensional (2D) steady-state linear head/tape interface with surface asperity contacts and tape shear deformations is analyzed using the finite-element method. A non-uniform mesh is utilized to improve the computational efficiency and to simulate cylindrical heads with longitudinal slots. Numerical results for the head/tape spacing and contact pressure are obtained for 2D head/tape interfaces using cylindrical heads with longitudinal slots. In addition, numerical examples are presented for the head/tape spacing and the pressure distribution using heads consisting of triple arc elements with and without longitudinal slots.     

A new analytical method for characterising the bonding environment at rough interfaces in high-k gate stacks using electron energy loss spectroscopy

Determining the bonding environment at a rough interface, using for example the near-edge fine structure in electron energy loss spectroscopy (EELS), is problematic since the measurement contains information from the interface and surrounding matrix phase. Here we present a novel analytical method for determining the interfacial EELS difference spectrum (with respect to the matrix phase) from a rough interface of unknown geometry, which, unlike multiple linear least squares (MLLS) fitting, does not require the use of reference spectra from suitable standards. The method is based on analysing a series of EELS spectra with variable interface to matrix volume fraction and, as an example, is applied to a TiN/poly-Si interface containing oxygen in a HfO₂-based, high-k dielectric gate stack. A silicon oxynitride layer was detected at the interface consistent with previous results based on MLLS fitting.     

The biological reality of the interlacunar network in the embryonic,cartilaginous, skeleton: A thiazine dye/absolute ethanol/LR White resin protocol for visualizing the network with minimal tissue shrinkage

Third toe phalanges of chicks aged 8–13 days in ovo and 7-day post-natal rat femoral growth plate were examined to determine whether the interlacunar network (IN), a structure with no lipoprotein membrane component or cytoplasmic organelles, is a genuine component of young growth cartilage. In chick phalanges dehydrated by 70% (v/v) ethanol and LR White resin, variable metachromatic staining of the interlacunar network by toluidine blue and red staining by picro-Sirius red indicate the presence of glycosaminoglycans and collagen. The network in phalanges dehydrated by 80% (v/v) ethanol appears little different; however, the network is much less widely detectable in phalanges dehydrated by 90% (v/v) ethanol and, after dehydration by absolute ethanol, is almost completely undetectable. In contrast, when the young cartilage is permeated by a thiazine dye such as toluidine blue, using a solution of dye in the aldehyde fixative, the network is widely detectable, following dehydration by absolute ethanol, both in chick phalanges and in rat growth plate. Comparison of projected areas shows that the extent to which whole chick feet are found to have shrunk, by the time that they are photographed under LR White resin, is determined principally by the extent of dehydration, by 70% (v/v) or absolute ethanol; post-shrinkage areas are 33% or 35% of areas measured in buffer for 70% (v/v) ethanol/LR White resin and 71% or 75% for absolute ethanol/LR White resin (the higher value in each is for the toluidine blue treatment). The network is thus present in radically shrunk tissue, but, significantly, is also fully represented in tissue shrunk by only a conventional margin and is therefore not produced as an artefact by exceptional tissue shrinkage as has been suggested.