Ideality factor of extrinsic base surface recombination current in AlGaAs/GaAs heterojunction bipolar transistors

Various structures of npn AlGaAs/GaAs heterojunction bipolar transistor have been fabricated to examine the ideality factor for extrinsic base surface recombination. Comparison of the measured results indicates that the base surface recombination current increases exponentially with the base-emitter voltage with an ideality factor of 1, rather than 2. This finding agrees with a published theoretical analysis (see Tiwari et al., J. Appl. Phys., vol.64, p.5009, 1988).<>     

High-frequency characteristics of AlGaAs/GaAs heterojunction bipolar transistors

The fabrication and high-frequency performance of MBE-grown AlGaAs/GaAs heterojunction bipolar transistors (HBT's) is described. The achieved gain-bandwidth product fTis 25 GHz for a collector current density Jcof 1 × 10⁴A/cm²and a collector-emitter voltage VCEof 3 V.fTcontinues to increase with the collector current in the high current density region over 1 × 10⁴A/cm²with no emitter crowding effect nor Kirk effect. The limitation on fTin fabricated devices is found to be caused mainly by the emitter series resistance.     

Fabrication and characterization of AlGaAs/GaAs heterojunction bipolar transistors

The fabrication and characterization of MBE-grown AlGaAs/GaAs heterojunction bipolar transistors (HBT's) are described, A Be redistribution profile in the HBT epi-layer at the emitter-base heterojunction interface is investigated using secondary ion mass spectrometry, A relatively high substrate temperature of 650°C during growth can be employed by introducing a 100-Å undoped spacer layer between the emitter and base layer. A simple wafer characterization method using phototransistors is demonstrated for accurately predicting current gain in a three-terminal device. A dc current gain of up to 230 is obtained for the fabricated HBT with a heavy base doping of 1 × 10¹⁹/cm³. A gain-bandwidth product fTof 25 GHz is achieved with a 4.5-µm-width emitter HBT.     

Monte Carlo simulation of AlGaAs/GaAs heterojunction bipolar transistors

A first demonstration of one-dimensional Monte Carlo simulations of AlGaAs/GaAs heterojunction bipolar transistors is reported. The electron motion is solved by a particle model, while the hole motion is solved by a conventional hydrodynamic model. It is shown that the compositional grading of AlxGa1-xAs in the base region is effective to cause the ballistic acceleration of electrons in the base region, resulting in a high collector current density of above 1 mA/µm². The current-gain cutoff frequency fT reaches 150 GHz if the size of a transistor is properly designed. Also shown is the relation between the device performances and the electron dynamics investigated.     

High-frequency output characteristics of AlGaAs/GaAs heterojunction bipolar transistors

A model has been developed which generates the high-frequency i/sub c/-v/sub ce/ output characteristics of bipolar transistors from computed cutoff frequency against current density data. The presented results, which can be used directly for large-signal modelling are the first report of high-frequency output characteristics of bipolar transistors.<>     

GaAs/AlGaAs heterojunction bipolar transistors for integrated circuit applications

Molecular-beam epitaxy (MBE) and ion implantation were used to fabricate GaAs/AlGaAs heterojunction bipolar transistors with buried wide bandgap emitters. Inverted-mode current gains of ∼ 100 were obtained, demonstrating the feasibility of this technology for I²L types of digital integrated circuits.     

Planar AlGaAs/GaAs heterojunction bipolar transistors fabricatedusing selective W-CVD

The authors describe a planar process for the AlGaAs/GaAs HBTs in which collector vias are buried selectively, even to the base layers, with chemical vapor deposited tungsten (CVD-W) films. By using WF₆ /SiH₄ chemistry, W could be deposited on Pt films, which were overlapped 50 nm thick on the AuGe-based collector electrodes, without depositing W on the surrounding SiO₂ layers. Current gains of planar HBTs with 3.5-μm×3.5-μm emitters were up to 150, for a collector current density of about 2.5×10⁴ A/cm²     

Effect of exponentially graded base doping on the performance ofGaAs/AlGaAs heterojunction bipolar transistors

The authors have fabricated n-p-n GaAs/AlGaAs heterojunction bipolar transistors (HBTs) with base doping graded exponentially from 5×10¹⁹ cm^-3 at the emitter edge to 5×10¹⁸ cm^-3 at the collector edge. The built-in field due to the exponentially graded doping profile significantly reduces base transit time, despite bandgap narrowing associated with high base doping. Compared to devices with the same base thickness and uniform base doping of 1×10¹⁹ cm^-3 , the cutoff frequency is increased from 22 to 31 GHz and maximum frequency of oscillation is increased from 40 to 58 GHz. Exponentially graded base doping also results ill consistently higher common-emitter current gain than uniform base doping, even though the Gummel number is twice as high and the base resistance is reduced by 40%     

High-frequency performance of MOVPE npn AlGaAs/GaAs heterojunction bipolar transistors

Base doping densities near 10/sup 20/ cm/sup -3/ and emitter doping densities near 7*10/sup 17/ cm/sup -3/ have been achieved in MOVPE HBT structures and combined with self-aligned processing resulting in f/sub max/=94 GHz and f/sub t/=45 GHz. To the authors' knowledge, these are the first MOVPE HBTs demonstrated to operate at millimetre-wave frequencies.<>     

(GaAl)As/GaAs heterojunction bipolar transistors with graded composition in the base

The first fabrication and high-speed operation of a three-terminal (AlGa)As/GaAs heterojunction bipolar transistor with graded bandgap base is reported. Cutoff frequencies up to 16 GHz have been achieved in devices fabricated from material made by molecular beam epitaxy. This work demonstrates the feasibility of using a graded (AlGa)As base to enhance the speed of heterojunction bipolar transistors.     

Collector-top GaAs/AlGaAs heterojunction bipolar transistors for high-speed digital ICs

GaAs/AlGaAs collector-top heterojunction bipolar transistors with magnesium and phosphorus double-implanted external bases were fabricated. A cutoff frequency of 17 GHz and a gate delay time of 63 ps for DCTL were obtained. These results indicate the potential of collector-top HBTs for high-speed ICs.     

GaAs/AlGaAs heterojunction emitter-down bipolar transistors fabricated on GaAs-on-Si substrate

GaAs/AlGaAs heterojunction bipolar transistors with emitter-down structure were fabricated on GaAs-on-Si substrate for the first time. A maximum current gain of 25 was measured at a collector current density of 6250 A/cm². This value is comparable with that from similar devices fabricated on GaAs substrates. This result, along with previous work on large-scale integration of emitter-down transistors, demonstrates the potential for high-level integration of bipolar devices on GaAs-on-Si substrates.     

High-speed frequency dividers using self-aligned AlGaAs/GaAs heterojunction bipolar transistors

A divide-by-four frequency divider and ring oscillators have been fabricated employing self-aligned AlGaAs/GaAs heterojunction bipolar transistors (HBT's). Maximum toggle frequency of 13.7 GHz and propagation delay time of 17.2 ps are achieved in ECL gate circuitry. These values are the highest and the lowest in ECL circuits and in bipolar circuits, respectively, ever reported.     

Reduction of extrinsic base resistance in GaAs/AlGaAs heterojunction bipolar transistors and correlation with high-frequency performance

Improved high-frequency performance in GaAs/AlGaAs heterojunction bipolar transistors (HBT's) by reduction of extrinsic base resistance is demonstrated. A new self-aligned process which is very simple, yet capable of producing 0.25-µm emitter-to-base contact gaps, is described. By the use of AuBe, we have also been able to produce contact resistances to p-type GaAs (p = 5 × 10¹⁸) as low as 1.2 × 10^-7Ω.cm². This is the lowest value reported to p-type GaAs considering the relatively low doping levels used. By employing these techniques, we have produced HBT's with 2.5-µm-wide emitters having current gain cutoff frequencies fTthat appear to be greater than 35 GHz and maximum oscillation frequenciesf_{max}of 22 GHz.     

AlGaAs/Ge/GaAs heterojunction bipolar transistors grown bymolecular beam epitaxy

An N-Al_0.22Ga_0.78As emitter, p-Ge base, and n-GaAs collector (AlGaAs/Ge/GaAs) heterojunction bipolar transistor (HBT) in the emitter-up configuration grown by molecular beam epitaxy is discussed. Devices exhibited common-emitter current gains of as high as 300 at a collector current density of 2000 A/cm² and a collector voltage of 4 V. As the device area is reduced from 50×50 to 10×40 μm, the current gain did not show significant changes, suggesting a low surface recombination velocity in the Ge base     

The effect of base grading on the gain and high-frequencyperformance of AlGaAs/GaAs heterojunction bipolar transistors

A comprehensive one-dimensional analytical model of the graded-base Al_xGa_1-xAs/GaAs heterojunction bipolar transistor is presented and used to examine the influence of base grading on the current gain and the high-frequency performance of a device with a conventional pyramidal structure. Grading is achieved by varying the Al mole fraction x linearly across the base to a value of zero at the base-collector boundary. Recombination in the space-charge and neutral regions of the device is modeled by considering Schockley-Read-Hall, Auger, and radiative processes. Owing to the different dependencies on base grading of the currents associated with these recombination mechanisms, the base current is minimized, and hence the gain reaches a maximum value, at a moderate level of base grading ( x=0.1 at the base-emitter boundary). The maximum improvement in gain, with respect to the ungraded base case, is about fourfold. It is shown that the reduction in base transit time due to increased base grading leads to a 30% improvement in f_T in the most pronounced case of base grading studied (x=0.3 at the base-emitter boundary). The implications this has for improving f _max via increases in base width and base doping density are briefly examined     

AlGaAs/GaAs heterojunction bipolar transistors fabricated using a self-aligned dual-lift-off process

This paper describes a self-aligned heterojunction-bipolar-transistor (HBT) process based on a simple dual-lift-off method. Transistors with emitter width down to 1.2 µm and base doping up to 1 × 10²⁰/cm³have been fabricated. Extrapolated current gain cutoff frequency ftof 55 GHz and maximum frequency of oscillationf_{max}of 105 GHz have been obtained. Current-mode-logic (CML) ring oscillators with propagation delays as low as 14.2 ps have been demonstrated. These are record performance results for bipolar transistors. The dual-lift-off process is promising for both millimeter-wave devices and large-scale integrated circuit fabrication.     

Numerical investigation of the effects of graded layer on the performance of AlGaAs/GaAs heterojunction bipolar transistors

The effects of grading on the performance of heterojunction bipolar transistors (HBTs) are studied by numerically solving the basic semiconductor equations. The numerical modelling is based on the extended drift–diffusion formulation with inclusion of thermionic emission current at the heterointerface of abrupt emitter HBTs. The results of the simulation show that the graded layer improves significantly the current driving capability of the HBT and lowers its offset voltage. However, owing to the increase in the recombination in the graded layer, the current gain of the graded HBT is lower and depends strongly on the bias at low and medium bias range. The simulation also reveals the presence of a potential minimum in the conduction band of the graded emitter HBT, which results in an electron accumulation in the region. This accumulation increases the emitter-base capacitance and its charging time, leading to a smaller unity-gain frequency f _T.     

High-performance p-n-p AlGaAs/GaAs heterojunction bipolar transistors: A theoretical analysis

The AlGaAs/GaAs P-n-p heterojunction bipolar transistor (HBT) is shown by a simple analysis to exhibit millimeter wave and digital switching performance comparable to similar N-p-n structures. For example, a P-n-p HBT with a 1-µm emitter stripe and 34-µm²total area yieldsf_{tau} = 31GHz,f_{max} = 94GHz, and an intrinsic switching speedtau_{s} = 8ps. A similar N-p-n structure exhibitsf_{tau} = 56GHz,f_{max} = 102GHz, andtau_{s} = 8ps.     

AlGaAs/InGaAs/GaAs strained-layer heterojunction bipolar transistors by molecular beam epitaxy

The growth and characteristics of the first AlGaAs/InGaAs/GaAs HBTs are reported. Layers with up to 10% indium content appeared to be free of misfit dislocations, and resulted in HBTs with good I/V characteristics which scaled with In content according to theory.