光纤CATV用掺铒光纤大器的简化分析

在不考虑放大自发辐射（ASE）对掺饵光纤放大器（EDFA）饱和特性影响的条件下,推出了掺饵光纤放大器（EDFA）三能级系统功率传输的解析表达式,简化了理论分析,所得结果也适用于二能级系统。根据该简化分析方法具有计算了前向泵浦时光纤CATV用掺饵光纤放大器（EDFA）的信号增益曲线。计算表明,当信号增益约在25dB以下,即在光纤CATV用掺饵光纤放大器（EDFA）的工作范围内,简化分析所得的计算结果与较精确的数值计算结果一致。     

光纤CATV用实用化掺铒光纤放大器

本文从速率方程出发 ,利用 EDFA的大信号理论 ,采用加速迭代敛算法 ,对 EDFA进行了优化设计。在理论分析的基础上 ,设计出 CATV用 EDFA。经测试 ,各项性能参数达到较高要求。按此设计生产出的 EDFA已批量供应市场。     

掺铒光纤放大器在CATV中的应用

本文阐述掺铒光纤放大器的工作原理及在CATV中的应用,以及对光纤CATV系统的载噪比、非线性失真等参数的影响和解决措施     

一种分析掺铒光纤放大器性能的简单方法

掺铒光纤放大器的主要性能是它的饱和增益特性和噪声系数。本文首先用两个经验公式，介绍了一种用于模拟掺铒光纤放大器性能的简单方法，接着给出了一个超定方程组，对这种方法作了进一步的改进，最后分别给出利用改进前后的方法计算所得到的结果，同时对计算结果和测量数据作了比较，比较显示我们的方法有着更高的精度。     

掺铒光纤放大器

阐述掺铒光纤放大器(EDFA)的原理和结构，介绍掺铒光纤放大器在密集波分复用(DWDM)传输系统中的应用，掺铒光纤放大器的优缺点以及发展前景。     

掺铒光纤放大器的优化设计

讨论了在双级掺铒光纤放大器(EDFA)设计中,为了使放大器有高增益、低噪声和在宽带内有很好的增益平坦性能,提出了一种新的双级掺铒光纤放大器的结构,更好地提高了光纤放大器的综合特性。     

铋镓铝共掺的高浓度掺铒光纤及放大器

研制出了铋镓铝共掺的高浓度掺铒光纤,这种掺铒光纤在1 530 nm处的吸收系数达到了28.5 dB/m.利用这种铋镓铝共掺的高浓度掺铒光纤制成了C波段和L波段的掺铒光纤放大器(EDFA),测试这两种放大器的荧光谱和增益谱线.利用2.5 m的高浓度掺铒光纤制作的C波段EDFA就实现了高增益.利用10 m这种掺铒光纤制作的L波段放大器实现了有效的I波段放大.     

Study of distributed erbium doped fiber amplifier

Basing on analyzing distributed erbium-doped fiber amplifier(d-EDFA) of evenly doped density along propagating direction, we put forward two sort d-EDFAs of slowly and linearly variously doped density along propagating direction: one-variation and two-variation d-EDFA. By using convective equations, we study the propagating properties of signal and noise in three sort d-EDFAs. Noise figure, signal-noise ratio, necessary pump and optimal pump period also are studied, under both transparent transmission and optimal doped density.     

Noise figure of erbium doped fiber amplifiers in the saturatedregime

We have made an experimental and theoretical study of the noise figure of an erbium doped fiber amplifier in the saturated regime. The saturated amplified spontaneous emission at the signal wavelength was measured using a very accurate pulsed source technique. We have quantified the noise figure dependence on compression, in excellent agreement with theory, to be less than 1.5 dB for a gain compression as high as 15 dB when the small signal gain was 26 dB, and the 1.48 μm pump power was 27 mW     

L-band tunable erbium doped fiber ring laser using fiber loop mirror filters

We present a novel and efficient L-band wavelength-tunable Er^3＋ doped fiber laser of ring structure. In the cavity two segments of Er^3＋ doped fiber and a fiber Bragg grating are used to improve pump efficiency. Tunable filters based on fiber loop mirrors are also applied inside the cavity to act as both a wavelength selector and a line-width compressor. Using these techniques, a tunable laser with tuning range up to 42 nm, output power larger than 1 mW, power uniformity controlled within 1.75 dB and side mode suppression ratio about 40 dB is achieved.     

Nonlinear refractive index in erbium doped optical fiber: Theoryand experiment

An intensity-dependent refractive index in erbium doped optical fiber has been observed for the first time. The effect has been observed by an interferometric technique using a two-core fiber. The effect is analyzed theoretically, and the important nonlinear parameters for thin material have been determined and are presented     

掺Er3+光纤中利用非解析点的信息速度测量

针对光速可控情况下信息的传播速度问题,提出利用非解析点方法测量掺Er3+光纤(EDF)中慢光和超光速情况下的信息速度.实验结果表明,可以通过调节泵浦光功率来控制慢光或者超光速传播的群速度,由于信息的传递速度不受群速度的影响,在我们测量精度内,非解析点代表的信息速度不会超过真空中的光速.     

Stabilization of a superfluorescent fiber source with high performance erbium doped fibers

A high stability superfluorescent fiber source with mean-wavelength stability of 1.3 ppm/°C over a temperature range of 100 °C is proposed based on spectral shaping combined with a thermal management unit. A thermal tunable filter combined with an unpumped filtering erbium-doped fiber is used as the single-pass backward filter. Theoretical model of the filtering fiber’s temperature dependent gain spectra is presented which decides the filter’s central-wavelength with minimum thermal sensitivity for a specific temperature change. Power efficiency and spectral bandwidth of the superfluorescent fiber source are optimized based on three different erbium-doped fibers at room temperature.     

Widely tunable wavelength spacing dual-wavelength single longitudinal mode erbium doped fiber laser

A simple widely tunable wavelength spacing dual-wavelength single longitudinal mode (SLM) erbium doped fiber laser (EDFL) based on cascaded fiber Bragg gratings (FBGs) and birefringent fiber filter is proposed and demonstrated. Experimental results show that the lasing wavelength spacing is widely tunable in a range from 2 nm to 18 nm, which has potential to generate frequency tunable terahertz (THz) waves by beating the lasing dual-wavelength in a high speed photodetector. The birefringent fiber filter acts as an ultra-narrow bandpass filter and benefits the simultaneous oscillation of dual-wavelength in a single laser cavity. The output peak power of the lasing dual-wavelength is approximately equalized at room temperature, and a high optical signal-to-noise ratio (OSNR) is realized in the whole tuning range. The SLM operation of dual-wavelength fiber laser is verified by Fabry–Perot (F–P) scanning interferometer, and the clear eye diagram proves that the proposed fiber laser is effective in the application of fiber optic communication system.     

Analytical method for gain in erbium doped fiber amplifier with pumb excited state absorption

Analytical solutions to rate and propagation equations describing gain in terms of photon intensities, transition rates, and absorption and emission cross-sections is determined in radially symmetric and longitudinally uniform monomode erbium doped silica fiber in presence of pump excited-state absorption effect for a pumping wavelength of 514.5 nm under the steady-state conditions with the help of a homogenous four-band transition scheme.     

光电反馈抑制掺铒光纤激光器的低频强度噪声

通过光电反馈电路对掺铒光纤激光器的中低频噪声进行了抑制。根据速率方程理论,分析了影响掺铒光纤激光器强度噪声的因素,通过电路仿真分析优化反馈电路参数,重点讨论反馈信号的相位对噪声抑制的影响。实验表明：激光器的低频(小于20KHz)强度噪声平均降低了10dB,中频弛豫振荡峰处（30KHz附近）抑制达35dB,并且克服了光电反馈抑制强度噪声使弛豫振荡峰向高频移动,导致高频噪声增大的问题。优异的噪声特性使光纤激光器在光传感领域具有很高的实用价值。