共查询到18条相似文献,搜索用时 374 毫秒
1.
2.
3.
4.
5.
6.
7.
8.
药剂分子与矿物之间的作用机理是浮选应用的理论基础,在磷矿浮选药剂分子设计及改性基础上的浮选机理研究因原料油酸成分复杂而受制约。本文以化学纯硬脂酸为原料,通过化学改性合成了一种新型阴离子反浮选脱镁捕收剂HY-1,并用于云南海口某中低品位高镁胶磷矿(原矿P2O5品位23.11%,MgO品位5.13%)的浮选试验,结果表明,采用"一反一扫"简单浮选工艺流程,闭路试验精矿P2O5品位达29.79%,回收率92.51%;MgO品位为0.72%,排除率达90%,白云石与胶磷矿得到有效分离;尾矿P2O5品位5.98%,该改性药剂浮选性能比较优良,其与纯矿物的作用机理研究将在后续工作中完善。 相似文献
9.
10.
《化工矿物与加工》2017,(10)
远安磷矿属于中低品位硅钙质胶磷矿,且磨矿后有用矿物与脉石矿物在各粒级中分布较为分散,适宜采用常温正反浮选工艺处理。通过条件试验确定了适宜的工艺参数,即磨矿细度-0.074mm质量分数占87.81%,正浮选碳酸钠用量6.0kg/t,水玻璃用量6.0kg/t,捕收剂RC-10用量0.9kg/t,反浮选硫酸用量15.0kg/t,RC-10用量0.4kg/t。采用常温正浮选1粗1精1扫、反浮选1粗1扫工艺处理P2O5品位21.86%的远安磷矿,可获得最终精矿P2O5品位30.95%、P2O5回收率90.51%、MgO质量分数0.80%的闭路选矿指标,倍半氧化物(Al2O3+Fe2O3)质量分数由原矿的7.50%降低至2.82%,精矿品质得到了较大的提升。浮选产品的各粒级组分质量分数分布结果表明:捕收剂RC-10对0.038mm以上粒级具有较强的浮选性能,进一步提高磷矿资源利用率的关键在于微细粒浮选技术的改进。 相似文献
11.
某磷块岩矿石的双反浮选试验所采用的工艺是:先以磷酸作调整剂,用W-03作捕收剂反浮选白云石,然后以阳离子捕收剂月桂胺和两性捕收剂T-01浮选硅酸盐矿物,槽中产物为磷精矿。试验取得了精矿含P_2O_5 32.87%,MgO 0.65%和收率80.5%的指标。 相似文献
12.
本文对我国某磷铁矿磁选尾矿进行了磷矿物浮选试验,该矿组成复杂,上下层矿样中磷矿物可浮性差别较大,试验采用了选择性较好的磷矿物捕收剂PA-807A,有效回收了上层矿样和下层矿样中的磷矿物.开路试验中,上层矿样在磨矿细度-200目质量分数为50%时,经过一次粗选一次精选,获得了P2O5品位为31.28%,P2O5回收率为96.15%的磷精矿;下层矿样在磨矿细度-200目质量分数为80%时,经过一次粗选三次精选,获得了P2O5品位为31.76%,P2O5回收率为82.04%的磷精矿. 相似文献
13.
新华含稀土磷矿浮选实验研究 总被引:2,自引:0,他引:2
采用反浮选工艺,研究了抑制剂种类及用量、捕收剂WF-01用量、浮选时间、矿浆浓度和磨矿细度等因素对新华含稀土磷矿浮选效果的影响,并对较佳浮选条件下获得的磷精矿和尾矿进行了稀土分析. 结果表明,浮选剂选用WF-01,工业硫酸不适宜单独作为此矿样浮选时磷矿物的抑制剂,而采用工业磷酸作为抑制剂和矿浆pH值调整剂,在磷酸用量9 kg/t、捕收剂WF-01用量0.8 kg/t、浮选时间9 min、磨矿细度82%为-74 mm、矿浆浓度35%的浮选条件下,可获得较好的浮选和稀土富集效果,磷精矿的P2O5品位可从原矿的21.71%增加到32%以上,回收率达到90%;在浮选过程中稀土主要富集在磷精矿中,富集比为1.56,在精矿中的含量为87.09%. 相似文献
14.
富泉磷钾矿综合利用研究 总被引:1,自引:0,他引:1
介绍富泉难选磷钾复合矿的综合利用试验方法,影响因素,浮选工艺流程及实验试验和扩大连续试验的结果,试验表明,该矿的磷和钾可综合回收利用。 相似文献
15.
介绍了国内外由钾长石制钾肥的概况;阐述了在常压、低温下用硫酸、助剂分解钾长石制钾肥的扩试流程,K2O收率达70%,Al2O3收率达65%。 相似文献
16.
Joseph A. Martz 《Journal of the American Ceramic Society》1933,16(7):299-304
An investigation was made of the fusion behavior of the potash feldspar, soda feldspar, and soda-lime feldspar system, all materials being of commercial grade. The potash feldspar had a pyrometric cone equivalent of cone 9½, the soda feldspar, cone 6½, and the soda-lime feldspar deformed at cone 11½. Mixtures varying according to the triaxial diagram were made in the form of pyrometric cones. These were fired in groups along with standard Orton cones. The 30% commercial potash feldspar-70% commercial soda feldspar mixture reached 6 o'clock deformation when standard Orton cone 6 showed 2 o'clock deformation. The mixture of 62½% commercial potash feldspar with 37½% soda-lime feldspar reached 6 o'clock deformation when cone 7 showed 1 o'clock deformation, the deformation of the cone 9½ potash feldspar being reduced 3 cones by the addition of the proper percentage of the cone 11½ soda-lime feldspar. There was an increase in deformation temperatures (no indication of eutectic) in the plagioclase series, soda feldspar to soda-lime feldspar. The mixture of 30% commercial potash feldspar, 60% commercial soda feldspar, 10% soda-lime feldspar showed 6 o'clock deformation when cone 6 showed 1 o'clock deformation, this being the lowest temperature at which any member of the system showed 6 o'clock deformation. 相似文献
17.
钾长石除铁降硅选矿试验 总被引:4,自引:0,他引:4
本文采用浮地对河北某地钾长石进行了除铁降硅试验研究。结果表明,可得到含Fe2O30.2%长石精矿,再经隆硅富钾试验,可得到SiO2 68%,K2O+Na2O〉14%的长石精矿。 相似文献
18.
P.C.E. values of ternary mixtures of potash feldspar, soda feldspar, and flint were determined and results shown on a solid phase diagram. No eutectics were developed with either of the binary series of feldspar and flint. The soda feldspar-flint mixtures were more refractory than were those of the potash feldspar series. At least 20% flint variation with potash feldspar will show no change in P.C.E. values and at least 10% with the soda feldspar showing the unreliability of P.C.E. to indicate the amount of the quartz content. 相似文献