共查询到20条相似文献,搜索用时 156 毫秒
1.
2.
火电厂除氧器汽水系统升温过程是锅炉给水处理的重要环节,在机组冷态启动过程中,除氧器汽水系统整体升温过程具有滞后、时变、非线性及控制难度大等特点。本文通过分析某机组启动过程中手动投入除氧器汽水系统的升温过程数据,分别对除氧器蒸汽加热控制阀开度、除氧器汽水系统温度进行数据拟合,结合基于时间的动态调整除氧器汽水系统升温控制策略,实现除氧器汽水系统升温全过程自动启动,解决了除氧器汽水系统升温过程中的耗时长、加热效率低、控制难度大等问题,为同类型除氧器汽水系统加热升温的自动启动提供了参考。 相似文献
3.
4.
5.
6.
7.
Umesh Singh 《电网技术》2009,33(15)
介绍了在设计实施集成配电系统的智能方法时应考虑的主要方面,其中包括:数据采集、监视控制及配电管理系统、停电管理系统与现场服务自动化,以及事故呼叫系统。提出使用IEC61968和公共信息模型等标准实施系统集成。在新老系统之间的集成过程中,这种方法可以有效降低成本,并使集成过程更加简单、快捷。此外,还阐释了目前在行业中存在的问题,提出将电力设备中的信息孤岛集成,讨论了中间件(消息总线)、业务流程自动化和工作流集成,并表明集成过程的标准化需要行业的共同努力。最后,指出集成过程中最重要的要求,并推荐了具体的集成技术和实施方案。 相似文献
8.
9.
介绍了国产100MW汽轮机的本体、轴封系统、抽汽系统及润滑油系统的改造过程,安装周期,同时分析了改造工作中存在的问题。 相似文献
10.
油纸绝缘热老化过程中含水量变化趋势及水分转移规律 总被引:4,自引:4,他引:0
根据某一具体时刻的油中含水量(即水的体积分数)来估算纸中含水量误差较大,且根据油、纸的含水量绝对值来进行变压器状态评估及受潮分析不全面。为此,在110°C和130°C下设计了初始含水量分别为1%、3%、5%的绝缘纸在矿物油中的加速热老化试验。系统研究了老化过程中绝缘纸平均含水量、油中含水量及油纸绝缘系统总含水量变化趋势;通过分析系统总含水量的变化及绝缘纸内部水分分布情况,探讨了油纸绝缘的水分转移规律;分析了老化过程中油中水分与纸中水分的关系。结果表明:老化过程中油中水分、纸中水分及系统总含水量均是波动的,且3者的波动幅度相互之间有较好的正相关性;初始含水量较高(3%、5%)时,油纸绝缘系统与外部氮气环境之间的水分转移起主导作用,初始含水量较低(1%)时,水分主要在系统内部油、纸二相间转移;老化过程中油中水分与纸中水分不能构成函数关系。因此提出应根据整个老化过程中油、纸及油纸绝缘系统总含水量3者整体上的波动趋势和波动幅度来进行变压器状态评估及受潮分析。 相似文献
11.
发电厂输煤控制系统的研究与改进 总被引:1,自引:0,他引:1
对可编程控制器应用于电厂输煤控制系统进行了研究。结合阳逻电厂原输煤控制系统 ,提出了一种建立基于可编程逻辑控制器 (PL C)的控制器网络的改造方案 ,改造后的输煤系统有强大的监控功能 ,同时也具备了与 MIS联网的能力。文章最后还介绍了阳逻电厂的配煤方案 相似文献
12.
13.
分析了山西柳林发电有限责任公司球磨机的现状,阐述了优化系统的原理。同时将改造后的磨煤机与未改造系统在节电和出力等方面进行比较,以此来检验改造效果和技术的可行性。 相似文献
14.
本文针对氧化铝沉降工序高温、高碱、物料易结疤等特点,介绍了根据沉降槽内物料密度不一致而运用浮力法进行泥屡高度检测的泥层界面检测仪,通过采用ProfibusDP现场总线的控制模式,实现了在线对中铝河南分公司改造的四台沉降槽泥层高度的自动检测,有效解决了生产中的“瓶颈”问题,给企业带来了可观的经济效益。 相似文献
15.
Nedal Al-Ababneh 《Electrical Engineering (Archiv fur Elektrotechnik)》2007,89(6):451-456
The capacity of free space optical interconnects (FSOIs) is analyzed. The interconnect capacity is expressed as a function
of signal-to-noise ratio (SNR), optical transmitted power, optical received power, optical crosstalk noise power, thermal
noise, and detector size and spacing. The dependence of interconnects capacity on SNR and on feature parameters of photo-detectors
array (fill factor, detectors spacing) is simulated. It is shown that feature parameters of photo-detectors array can be used
as design parameters to optimize and improve the interconnect capacity. The effect of increasing the power budget as far as
possible to improve the interconnect capacity is investigated as well. 相似文献
16.
17.
Armintor Kirk Mills Russell W. Stiffler Walter G. 《Industry Applications, IEEE Transactions on》1981,(6):581-586
The importance of the repairing of large induction motors by service (repair) centers is discussed. The major consideration is on turnaround time. Because of time constraints caused by emergency turnaround, not enough emphasis is generally put on returning the equipment to original factory specifications. Consideration should be given to the insulation system, mechanical parts such as seals, the bearing system, noise reduction, and possible improvements in efficiency, as well as tests to insure quality. The investment in new equipment as well as the high cost of energy and downtime often warrant a closer examination of the options. 相似文献
18.
本文基于颜色仿真的要求,设计了彩色亮度计并编制了计算机程序进行颜色存储,可作为颜色标准和物体色的计算机存储,介绍了设计的思路,描述了系统硬件,软件以及为检测微弱信号,提高系统可靠性所采取的各种措施,改进了色度修正的方法并给出了相应公式。 相似文献
19.
20.
Prieto G. Prieto O. Gay C.R. Yamamoto T. 《Industry Applications, IEEE Transactions on》2003,39(1):72-78
Methyl bromide is amply used as a fumigant for soil conditioning in greenhouses, as well as for storage grain conditioning. The treatment is carried out in a confined place, and after treatment the residual gas is vented to the atmosphere. Despite this gas being very toxic, it does not result in harm to human beings because it is vented in open places. However, it is harmful to the atmosphere because its reaction with high-energy photons in the stratosphere reduces the ozone concentration. Therefore, the present investigation is concerned with the study of the feasibility for destruction of the residual fumigant. One of the nonthermal plasma techniques, a packed-bed ferroelectric reactor, was applied for destruction of mixtures of methyl bromide in nitrogen or air. The performance of the process was studied by analyzing the influence and effect of the operating variables on the process efficiency. The results obtained showed the residence time and the applied voltage as the most significant variables. When nitrogen is employed as the carrier gas destruction efficiencies as high as 80% are obtained. 相似文献