共查询到19条相似文献,搜索用时 125 毫秒
1.
2.
3.
常压储罐底板腐蚀具有随机性,腐蚀类型往往是均匀腐蚀加上点腐蚀,在最近几年中常压储罐的腐蚀检测技术已引起重视。本文对常压储罐罐底的腐蚀形式进行了分析,对漏磁检测技术的检测原理、检测方法进行了介绍,并简要阐述了常压储罐底板漏磁检测系统的现场应用情况。 相似文献
4.
5.
6.
7.
探讨漏磁检测在大型原油储罐底板缺陷检测中的应用,具有检测速度快、准确可靠、操作方便等特点,尤其能检测罐底板下表面的腐蚀状况,漏磁检测、超声波测厚结果的对比分析证实了漏磁检测方法的可靠性。 相似文献
8.
9.
10.
针对大型原油储罐罐底腐蚀,分析了罐底腐蚀的原因,针对罐底板边缘板的易腐蚀情况采取有效防范措施,保证储罐在运行期间的完好,确保输油生产的安全可靠。 相似文献
11.
本文主要通过建立模糊物元评价模型。对油罐底部沉积液进行了腐蚀评价。模糊微元分析方法思路简单明了。不受沉积液分类标准的限制。只要有可靠的相关沉积液量化指标。就能有效地对沉积液腐蚀性做出评价,既适于现场手工计算又很容易程序化。为油罐设计腐蚀评价提供了简便的方法。 相似文献
12.
采用磷酸结合锆英石捣打料捣制锆英石流出口砖和捣打池炉底,明显地提高了池炉底和流出口的抗熔体侵蚀性能,延长了熔块池炉的大修周期,不但保证了所熔制的陶瓷熔块质量,而且降低了产品成本。 相似文献
13.
14.
15.
根据基于风险的检验(RBI)原理,对某储罐群进行了风险评估,得到了储罐壁板和底板的失效可能性、失效后果与风险等级。结合RBI分析结果,针对储罐的主要失效模式及损伤机理制定了相应的检验策略。选取中高风险储罐开罐实施底板漏磁检测,并与评估结果进行对比分析,验证了储罐RBI技术的可靠性,有效降低了罐群运行风险。 相似文献
16.
《Chemical engineering science》1985,40(3):385-392
Solids suspension in the classical flat bottom mixing tank was analysed phenomenologically in detail. Abrupt re-direction of the flow in the centre and the periphery of the flat bottom tank gives rise to induced recirculation loops which account for the formation of central and peripheral fillets of unsuspended solids. The extent of these recirculation loops has a controlling influence on the attainment of complete off-bottom suspension in this tank geometry. Therefore the use of the complete off-bottom suspension condition in the flat bottom tank as the sole criterion for scale-up is likely to lead to scale-up parameters which do not represent the behaviour of the bulk of the tank.A fully profiled tank bottom and its approximation, a “cone and fillet” bottom design were used as alternative geometries to mitigate recirculation loops. Streamlining of the mixing tank substantially improved solid and suspension efficiency and also produced a more homogeneous hydrodynamic regime in the bottom zone of the tank. This latter effect potentially simplifies theoretical modelling of solids suspension and further justifies the preference for profiled bottom mixing tanks rather than the flat bottom tank. 相似文献
17.
南堡35-2油田属于高粘重质油油田,油田CEP平台处理B平台热采井采出液的难度大。含油污水进入净化水缓冲罐后,造成顶部浮油聚集、底部沉积污泥。目前净化水缓冲罐内没有底部排污管线,只有固定式单管收油装置,且操作复杂,排油效率低。由于收油及排污不彻底,净化水缓冲罐净化水含油基本上比核桃壳滤器出口含油高4~7ppm。因此,需要对净化水缓冲罐内增加浮动式收油装置和底部排污管线,来达到提高注水水质的目的。 相似文献
18.