共查询到18条相似文献,搜索用时 156 毫秒
1.
2.
3.
阐述了伺服阀滑阀叠合量间接、气动综合和液动综合测量法的原理和数学模型,分析了它们的优缺点和应用情况.针对流量系数变化影响液动流量式综合测量法精度的问题,提出了根据阀口流态进行补偿的方法,以提高叠合量的液动测量精度. 相似文献
4.
5.
6.
7.
8.
9.
高压气动系统的自动化对于压力和流量的自动控制都有迫切的需求,而气体的可压缩性决定了其压力与质量流量的控制具有共通性,即都可以通过调节阀门开度来实现,这就使得在同一套装置上实现压力和质量流量的复合控制成为可能。基于此,该文提出一种高压气体压力流量复合控制数字阀,复合数字阀由八个二级高压气动开关阀组成,工作压力可达20 MPa以上,压力或流量控制精度可达1%以上。该文在介绍复合数字阀结构和工作原理的基础上,在AMESim中建立了仿真模型,并通过简单的仿真验证了该复合阀的可行性。复合数字阀的成功研制将解决现有高压气动压力阀存在的泄漏和结冰难题,填补高压气动阀进行质量流量控制的空白。 相似文献
10.
11.
与普通空气弹簧不同,高度阀内置空气弹簧是将高度阀设置在空气弹簧气囊内部形成的一体式结构。由于其结构较特殊,目前还没有专门针对这种结构空气弹簧的性能测试方法。为了得到高度阀内置空气弹簧的性能测试方法,防止因测试方法不当造成高度阀内置空气弹簧的损坏,针对一款汽车驾驶室悬置高度阀内置空气弹簧进行了性能测试。测试参照普通空气弹簧的性能测试方法进行。测定了高度阀内置空气弹簧和外置高度阀的普通空气弹簧的载荷-位移曲线和动刚度-加载频率曲线。依据测试结果的对比分析可以发现:高度阀内置空气弹簧和普通空气弹簧性能曲线的变化趋势一致,而且所测定的曲线比较符合实际行车情况。说明参照普通空气弹簧的性能测试方法对高度阀内置空气弹簧进行性能测试是可行的。由此可知,高度阀内置空气弹簧与普通空气弹簧的性能测试方法具有一致性。 相似文献
12.
等温容器放气法测定气动电磁阀流量特性的研究 总被引:1,自引:0,他引:1
对一种新的测试气动元件流量特性的方法进行了研究,即利用等温容器的放气曲线来测量气动电磁阀的音速流导C和临界压力比b。首先介绍了测试原理与测试方法;随后对4种等温容器进行了实验研究,结果表明:容器中填充丝的密度越大,等温性能越好,同时流阻越大;接着用这4种容器来测试同一电磁阀的流量特性,测量得到的数据表明:用等温容器可以成功实现电磁阀的流量特性测试,但并不是等温性能越好误差就越小。经分析可知容器的温度特性和流阻特性对测量元件流量特性时的误差有着不同的影响,温度偏差引起流量测量的正偏差,而流阻则引起流量测量的负偏差,存在一个最佳填充密度。采用等温容器这种新的流量特性测试方法比ISO6358省时省气,该研究进一步推动了等温容器的实用化进程。 相似文献
13.
When using a flowmeter to measure unsteady air flow in the pneumatic control system, problems such as high cost and pressure loss are often encountered. It is an available method to measure the unsteady flow rate using isothermal chamber through direct differentiation of pressure signal with a traditional fixed parameter differentiator, but the adaptability of this method is insufficient due to its narrow dynamic range. To this end, an improved adaptive tracking differentiator which can adaptively adjust the control parameters according to the changes of pressure signal and pressure tracking error was proposed for unsteady air flow measurement. The algorithm structure of the adaptive tracking differentiator was designed. Moreover, theoretical simulation and flow measurement experiments under multiple working conditions were carried out. The simulation and experiment results showed that the flow measurement method based on improved adaptive tracking differentiator effectively measured the unsteady flow in a wide dynamic range, and had the advantages of more simplified process and lower cost than traditional method. 相似文献
14.
介绍一种高压、大流量气动定差压力控制阀及其结构特点 ,对其性能进行了理论分析和实验研究。由于采用了直动膜片式放大结构和气体静压支承原理 ,该阀具有响应灵敏、控制精度高、自适应能力强等优点。目前 ,该阀已用于某发射装置 相似文献
15.
16.
《机械工程学报(英文版)》2020,33(2):87-99
When saving energy in a pneumatic system, the problem of energy losses is usually solved by reducing the air supply pressure. The power-matching method is applied to optimize the air-supply pressure of the pneumatic system, and the energy-saving effect is verified by experiments. First, the experimental platform of a pneumatic rotary actuator servo-control system is built, and the mechanism of the valve-controlled cylinder system is analyzed. Then, the output power characteristics and load characteristics of the system are derived, and their characteristic curves are drawn. The employed air compressor is considered as a constant-pressure source of a quantitative pump, and the power characteristic of the system is matched. The power source characteristic curve should envelope the output characteristic curve and load characteristic curve. The minimum gas supply pressure obtained by power matching represents the optimal gas supply pressure. The comparative experiments under two different gas supply pressure conditions show that the system under the optimal gas supply pressure can greatly reduce energy losses. 相似文献
17.
质量流量是静压气浮平台的一个重要性能参数。本文采用数值计算和有限体积法对静压气浮平台的质量流量进行了计算并对比分析。结果表明通过两种方法得到的质量流量变化趋势相同,均随着供气压力的增加而增大,且当供气压力增加时,两计算结果趋于一致。其中有限体积法考虑了更多实际因素的影响,所得结果更贴近真实情况。 相似文献
18.
高压大流量气动比例阀稳态气动力数值研究 总被引:1,自引:0,他引:1
该文针对高压大流量气动比例阀结构特点及阀芯动力学特性,建立阀芯所受稳态气动力数学模型。然而由于高压气体的可压缩性、阀口流量非线性等因素,难以采用传统气动力理论计算公式准确预测高压大流量气动力比例阀的稳态气动力,为此基于三维N-S方程,采用计算流体动力学(CFD)方法研究稳态气动力的变化特性。结果表明,该气动比例阀工作过程中最大稳态气动力达到气压驱动力的30%,成为影响阀芯响应速度与控制精度的主要因素,且稳态气动力与阀口开度呈强非线性关系。另外为减小稳态气动力的阻力作用以减小动力能源的消耗,应优化内流道结构,实现节能目的。 相似文献