输入具有齿隙非线性特性的周期系统的自适应控制

针对一类输入含齿隙非线性动态特性的周期时变系统, 在周期不确定性可时变参数化的条件下设计自适应控制器. 对周期时变参数进行傅里叶级数展开, 并采用微分自适应律估计未知傅里叶系数和齿隙动态特性参数, 通过鲁棒方法消除截断误差和齿隙模型的有界误差项对系统性能的影响. 采用双曲函数替代符号函数确保控制器可微, 同时能有效抑制颤振. 引入Δ函数, 避免参数估计发散, 并保证系统输出渐近跟踪理想轨迹. 理论分析与仿真结果表明, 闭环系统所有信号有界.     

Adaptive control of linear time-varying systems

Single-input single-output uncertain linear time-varying systems are considered, which are affected by unknown bounded additive disturbances; the uncertain time-varying parameters are required to be smooth and bounded but are neither required to be sufficiently slow nor to have known bounds. The output, which is the only measured variable, is required to track a given smooth bounded reference trajectory. The undisturbed system is assumed to be minimum-phase and to have known and constant relative degree, known sign of the ‘high frequency gain’, known upper bound on the system order. An adaptive output feedback control algorithm is designed which assures: (i) boundedness of all closed-loop signals; (ii) arbitrarily improved transient performance of the tracking error; (iii) asymptotically vanishing tracking error when parameter time derivatives are L₁ signals and disturbances are L₂ signals.     

含间隙非线性的Wiener-Hammerstein系统复合补偿控制

针对含非对称间隙环节的Wiener-Hammerstein系统提出了一种新的由输出反馈和间隙动态逆补偿构成的复合控制方案.首先应用参数化分段线性表达式设计了未知参数的整体估计模型,可同时估计线性参数和间隙的特征参数,然后提出了一种新的误差有界的间隙动态逆模型,该模型可使得驱动信号能在间隙的不同线性段之间快速切换,在此基础上设计了鲁棒补偿控制律,同时对输入线性环节采用输出反馈控制构建了复合控制器,通过李亚普诺夫方法证明了闭环系统的稳定性.带减速器的单电机伺服系统模型的仿真结果表明该方法在跟踪精度良好的同时可使系统动态响应满足要求.     

非线性系统的一种加权自适应控制方法

非线性系统的一种加权自适应控制方法１）许向阳祝和云（浙江大学工业控制研究所杭州３１００２７）关键词自适应控制,非线性系统,间隙非线性．１）国家级工业控制技术重点实验室资助课题．收稿日期１９９５－０３－０７１引言由于非线性系统的多样性,不能用统一的模型...     

Adaptive dynamic surface control for MIMO nonlinear time-varying systems with prescribed tracking performance

In this paper, an adaptive dynamic surface control scheme is proposed for a class of multi-input multi-output (MIMO) nonlinear time-varying systems. By fusing a bound estimation approach, a smooth function and a time-varying matrix factorisation, the obstacle caused by unknown time-varying parameters is circumvented. The proposed scheme is free of the problem of explosion of complexity and needs only one updated parameter at each design step. Moreover, all tracking errors can converge to predefined arbitrarily small residual sets with a prescribed convergence rate and maximum overshoot. Such features result in a simple adaptive controller which can be easily implemented in applications with less computational burden and satisfactory tracking performance. Simulation results are presented to illustrate the effectiveness of the proposed scheme.     

Adaptive inverse control for parametric strict feedback systems with unknown failures of hysteretic actuators

An adaptive compensation control scheme is proposed by using backstepping techniques for a class of uncertain nonlinear systems preceded by m hysteretic actuators, which exhibit unknown backlash nonlinearity and possibly experience unknown failures. An estimated smooth inverse of the actuator backlash is utilized in the controller design to compensate for the effects of the backlash and actuator failures. It is shown that the designed controllers can ensure all signals of closed‐loop system bounded for any failure pattern of hysteretic actuators and tracking performance is also maintained. Simulation studies confirm the effectiveness of the proposed controller, especially the improvement of system performances. Copyright © 2013 John Wiley & Sons, Ltd.     

Adaptive compensation control for special actuator circumstances with input quantization

In this article, considering actuator constraints and possible failures, an adaptive compensation control scheme is developed to realize tracking control for a class of uncertain nonlinear systems with quantized inputs. A new variable is generated to evaluate the effect of actuator saturation and is used in the process of controller design to compensate for the influence of actuator saturation constraint. Moreover, the controller is able to show certain accommodation capability to tolerate possible actuator failures and input quantization error via integrating parameter update process of unknown fault constants into adaption of parametric uncertainties under the backstepping procedure. Specifically, actuator saturation effect and possible actuator failures as well as input quantization error can be dealt with uniformly under the framework of the proposed scheme and the control system has certain robustness to external disturbances. It is proved that all the signals of the closed‐loop system are ensured to be bounded and the tracking error is enabled to converge toward a compact set, which is adjustable by tuning design parameters. Finally, experiments are carried out on an active suspension plant to illustrate the effectiveness of the proposed control scheme.     

Adaptive actuator failure compensation for nonlinear MIMO systems with an aircraft control application

A direct adaptive approach is developed for control of a class of multi-input multi-output (MIMO) nonlinear systems in the presence of uncertain failures of redundant actuators. An adaptive failure compensation controller is designed which is capable of accommodating uncertainties in actuator failure time instants, values and patterns. A realistic situation is studied with fixed grouping of actuators and proportional actuation within actuator groups. The adaptive control system is analyzed, to show its desired stability and asymptotic tracking properties in the presence of actuator failure uncertainties. As an application, such an adaptive controller is used for actuator failure compensation of a twin otter aircraft longitudinal model, with design conditions verified and control structure and adaptive laws developed for a nonlinear aircraft dynamic model. The effectiveness of adaptive failure compensation is demonstrated by simulation results.     

Robust adaptive tracking control of uncertain systems with time-varying input delays

In this paper, the problem of robust adaptive tracking control of uncertain systems with time-varying input delays is studied. Under some mild assumptions, a robust adaptive controller is designed by using adaptive backstepping technique such that the system is globally stable and the system output can track a given reference signal. At the same time, a root mean square type of bound is obtained for the tracking error as a function of design parameters and thus can be adjusted. Finally, one numerical example is given to show the effectiveness of the proposed scheme.     

Adaptive variable structure control of MIMO nonlinear systems with time-varying delays and unknown dead-zones

In this paper, adaptive variable structure neural control is presented for a class of uncertain multi-input multi-output （MIMO） nonlinear systems with state time-varying delays and unknown nonlinear dead-zones. The unknown time-varying delay uncer- tainties are compensated for using appropriate Lyapunov-Krasovskii functionals in the design. The approach removes the assumption of linear function outside the deadband without necessarily constructing a dead-zone inverse as an added contribution. By utilizing the integral-type Lyapunov function and introducing an adaptive compensation term for the upper bound of the residual and optimal approximation error as well as the dead-zone disturbance, the closed-loop control system is proved to be semi-globally uniformly ultimately bounded. In addition, a modified adaptive control algorithm is given in order to avoid the high-frequency chattering phenomenon. Simulation results demonstrate the effectiveness of the approach.     

Adaptive state observation of linear time-varying systems with delayed measurements and unknown parameters

In this article, we address the problem of adaptive state observation of linear time-varying systems with delayed measurements and unknown parameters. Our new developments extend the results reported in our recently works. The case with known parameters has been studied by many researchers. However in this article we show that the generalized parameter estimation-based observer design provides a very simple solution for the unknown parameter case. Moreover, when this observer design technique is combined with the dynamic regressor extension and mixing estimation procedure the estimated state and parameters converge in fixed-time imposing extremely weak excitation assumptions.     

一类控制系数有界的时变非线性系统的自适应鲁棒控制

针对一类带有有界控制系数和有界扰动的时变参数严反馈非线性系统, 将Nussbaum函数增益及光滑投影算法与自适应逆推设计工具相结合, 提出一种自适应鲁棒非线性控制方案. 在此方案中无需知道控制系数的符号, 以及时变参数和扰动的界. 借助Lyapunov函数及相关引理证明了所设计的自适应鲁棒非线性控制器能保证闭环系统中的所有信号全局一致有界. 可以通过恰当地选取设计参数, 保证系统具有任意指定的控制性能. 仿真研究证明了所提出算法的可行性和有效性.     

未知时变时滞非线性参数化系统自适应迭代学习控制

针对含有未知时变参数和时变时滞的非线性参数化系统,提出了一种新的自适应迭代学习控制方法.该方法将参数分离技术与信号置换思想相结合,可以处理含有时变参数和时滞相关不确定性的非线性系统.设计了一种自适应控制策略,使跟踪误差的平方在一个有限区间上的积分渐近收敛于零.通过构造Lyapunov-Krasovskii型复合能量函数,给出了闭环系统收敛的一个充分条件.给出两个仿真例子验证了控制方法的有效性.     

Adaptive second-order sliding mode control with uncertainty compensation

ABSTRACT

This paper endows the second-order sliding mode control (2-SMC) approach with additional capabilities of learning and control adaptation. We present a 2-SMC scheme that estimates and compensates for the uncertainties affecting the system dynamics. It also adjusts the discontinuous control effort online, so that it can be reduced to arbitrarily small values. The proposed scheme is particularly useful when the available information regarding the uncertainties is conservative, and the classical `fixed-gain’ SMC would inevitably lead to largely oversized discontinuous control effort. Benefits from the viewpoint of chattering reduction are obtained, as confirmed by computer simulations.     

Adaptive input matching control of structurally varying plants

Adaptive control using input matching can avoid the identifiability and/or exact model-matching constraints of the bulk of existing adaptive control methods. The focus on input matchability allows the use of general controller structures capable of controlling a plant whose structure may vary arbitrarily within an allowable class. The applicability of this technique is demonstrated for two simulated plants: a MIMO linear network increasing its complexity due to component failure and an unstable SISO plant controlled by an actuator which gradually develops a nonlinearity. The sole need for pre-specification of an allowable plant structure re-focuses the thrust of system identification from parameter estimation to structure determination.     

Adaptive neural control for uncertain systems subject to actuator failure

In this paper, the design of controller based on neural network is investigated for a class of uncertain systems subject to actuator failures. An adaptive neural controller is designed by utilizing the approximation technique of neural network. The key feature in this work is to remove the requirement on the boundedness of unknown nonlinear functions that is usually encountered in the existing works. Moreover, sufficient conditions are derived such that the closed-loop system is robustly stable. Finally, numerical simulation results are given.     

Adaptive tracking for MIMO nonlinear systems with Unknown fast time‐varying parameters

In this paper, we consider a class of MIMO nonlinear systems with fast time‐varying parametric uncertainties. First, the tracking problem of general nonlinearly time‐varyingly parameterized systems is solved. Then, a Lyapunov‐based singularity free adaptive controller is proposed for the considered system. Specifically, an estimation approach with a proportional plus integral adaptation scheme is utilized to update the estimations of the unknown parameters under a mild assumption that the signs of the leading minors of the input gain matrix are known. The asymptotic stability is achieved with full state feedback. Furthermore, we design an output feedback controller by utilizing a standard high‐gain observer and achieve uniformly ultimately bounded convergence. Simulation examples illustrate the effectiveness of the proposed methods.     

Adaptive output-feedback control for a class of nonlinear systems with actuator failures and input quantisation

In this paper, an adaptive output feedback control technique is proposed for a class of nonlinear systems with unknown parameters, unknown nonlinear functions, quantised input and possible actuator failures up to infinity. A modified backstepping approach is proposed by the use of high-gain K-filters, hyperbolic tangent function property and bound-estimation approach to compensate for the effect of possible number of actuator failures up to infinity, input quantisation and unknown nonlinear functions. It is proved both mathematically and by simulation that with the proposed controller, all the signals of the closed-loop system are globally bounded despite of input quantisation, unknown nonlinear functions and possible number of actuator failures up to infinity.     

Robust stabilisation of time-varying delay systems with probabilistic uncertainties

For robust stabilisation of time-varying delay systems, only sufficient conditions are available to date. A natural question is as follows: if the existing sufficient conditions are not satisfied, and hence no controllers can be found, what can one do to improve the stability performance of time-varying delay systems? This question is addressed in this paper when there is a probabilistic structure on the parameter uncertainty set. A randomised algorithm is proposed to design a state-feedback controller, which stabilises the system over the uncertainty domain in a probabilistic sense. The capability of the designed controller is quantified by the probability of stability of the resulting closed-loop system. The accuracy of the solution obtained from the randomised algorithm is also analysed. Finally, numerical examples are used to illustrate the effectiveness and advantages of the developed controller design approach.