共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
根据高精度星敏感器地面测试任务中模拟无穷远处目标星体的实际应用需求,针对常规星模拟器体积庞大,装调及校准困难等实际问题,设计了一种大口径、长焦距、可实现自准直功能的离轴反射式星模拟器光机结构,用来模拟无穷远处的恒星所发出的平行光。采用离轴反射式光学设计,避免中心遮拦。采用光管焦面分光方式,通过半透半反式分光镜的反射与透射功能实现光路的传递,压缩了镜筒长度;通过探测器接收分光镜透射的光像可直接辨别光学系统的准直性能,便于装调,且方便后期使用与校准;采用顶丝调节姿态降低了装调难度。实际测试结果表明:光机系统的入瞳口径210mm,出瞳距离2100mm,整机的系统波像差(rms)测量值为0030 λ,可精确模拟0~7等星,工作波段500~800nm,满足当前对高精度星敏感器的标定技术指标要求,为星模拟器的高效快速研制提供了一种设计方法。 相似文献
3.
光轴平行性是多光轴光电设备的重要参数,对其进行检测十分必要。随着光电设备复杂程度的逐步增加,其光轴之间的距离不断增大,传统的小口径检测手段已经不能满足现有光电设备的检测需求。针对大间距光轴之间的平行性的检测,设计了一种基于双五棱镜结构的扩径组件,实现了平行光管的出射光束的平移,并利用双光楔结构对扩径组件进行修正,将平行光管的有效口径由300 mm扩展至1 200 mm。对扩径组件进行数学建模分析和实际装调,并对检测系统进行整体精度测试。实验结果表明:平行光管出射的光束经扩径组件后能够保持良好的平行性,其平行误差在11以内,满足大间距光轴检测的精度要求。 相似文献
4.
大型平行光管在进行空间环境模拟实验中由于受到温度、气压大幅改变的影响,离焦现象较为严重,为了解决该状态下平行光管离焦量检测难度较大、检测精度不高等问题,提出了一种针对大口径长焦距平行光管焦面位置检测的新方法,可以对平行光管的离焦量进行实时的监测。分析了由五棱镜引入的主要系统误差,并使用更新基准数据的方法将其修正。在口径为700 mm 焦距为18 m 的平行光管上进行了实验,结果表明该系统检焦精度在150 m 以内,满足实验室对大型平行光管焦面位置精度小于200 m 的指标要求。 相似文献
5.
大口径、长焦距离轴三反射镜系统的设计过程中会出现透镜的挡光问题.传统的优化方法降低了光学设计的效率,对成像质量有负面影响.实践表明用ZPL宏指令可以解决这个问题.反射式平行光管设计指标为:通光口径500 mm,焦距4000mm,波长范围为400~1400 nm,有效视场2°×1°,点列图优于6 μm.根据设计指标计算了同轴三反射镜(TMA)系统的初始光学结构参数,借助Zemax软件中的ZPL宏指令得出最终设计方案.结果表明:各个视场的点列图均优于6 μm,波像差均优于λ/25,满足设计指标.ZPL宏指令辅助设计在离轴多反射镜系统中能控制系统结构,避免挡光,提高设计效率和成像质量. 相似文献
6.
7.
8.
针对在平行光路中无法检测别汉棱镜光轴和机械轴之间的位移误差问题,提出了位移误差检测方案,设计了别汉棱镜光轴一致性检测系统,包括检测光路和对照光路,这两条光路总长相等,MTF均接近衍射极限,根据设计的检测系统搭建检测光路,对口径为25 mm的别汉棱镜进行装调,先后在传统平行光路和本文所设计的检测光路中检测并调整棱镜光轴和机械轴之间的角度误差和位移误差,并使其最小,最终测得别汉棱镜的出射光轴与入射光轴的光轴一致性精度为±48″,将装调好的别汉棱镜和旋转轴系装入正式系统中装调,测得光轴一致性精度为±0.8个像素,达到像素级精度。本文提出的检测方法提高了在系统中装调别汉棱镜光轴的效率和精度。 相似文献
9.
10.
11.
The article describes a model representation of radar probing data in form of a mixture of background and target samples, which is the sum of two random variables with very different parameters. For model development we research the behavior of the central moments of the distribution mix without assuming the distribution law form. An example it is described the detection of the signal at the output of compression system of chirp ionosonde. 相似文献
12.
解决IP网QoS问题是目前通信领域的研究热点之一.虽然研究已经取得了一定的进展,但人们对于IP 网QoS本身的含义及相关的问题还有着不同的理解.本文将从IP网QoS的定义入手讨论相关的一些问题以及解决IP网QoS问题所做的各种努力. 相似文献
13.
14.
《Proceedings of the IEEE. Institute of Electrical and Electronics Engineers》1968,56(6):1024-1032
Assuming that visual responses are due to the action of particles on the membrane of the visual cells, the stochastic variability of the response should be a function of the number of particles producing it. Quantitative predictions can be made with the aid of a model proposed in previous articles. It is found that responses produced in visual cells of Limulus by absorption of a single photon have the stochastic properties which would be expected if the response to one photon were brought about by 25 particles. It is concluded from this that the processes leading to visual responses produce multiplication of particles. The effects of temperature and of metabolic poisons suggest that these processes are of chemical nature. 相似文献
15.
16.
By means of exact conformal mapping method we have defined character of dependence of squares amounts of angular part of film
element on angled part dimension. We propose relations, approximating obtained dependence. Calculation results and experimental
researches of large-scale models are represented. 相似文献
17.
A. M. Emel’yanov 《Semiconductors》2010,44(9):1134-1139
A method for analyzing the luminescence spectra of semiconductors is suggested. The method is based on differentiation of
the spectra. The potentialities of the method are demonstrated for luminescence in the region of the fundamental absorption
edge of Si and SiGe alloy single crystals. The method is superior in accuracy to previously known luminescence methods of
determining the band gap of indirect-gap semiconductors and practically insensitive to different conditions of outputting
radiation from the sample. 相似文献
18.
“计算机组成原理”设计性实践教学模式研究 总被引:1,自引:0,他引:1
本文阐述了"计算机组成原理"设计性实验教学的重要性,对设计性实验教学的目的和基本特征进行了归纳,对"计算机组成原理"设计性实验教学的现状进行了调查,对存在的问题进行了较深入的分析;在此基础上.对组成原理设计性实验的教学模式进行了研究,对设计性实验的体系进行了初步设计,并对"计算机组成原理"设计性实验的实施方法进行了探讨. 相似文献