纳米La_2O_3粉晶的制备及其表征

以La(NO_3)_3·6H_2O、NH_4HCO_3和聚乙二醇为原料,利用沉淀法制备了纳米La_2O_3粉体,利用XRD,TG-DTA和TEM等测试方法对干凝胶热分解过程及最终形成的纳米La_2O_3粉体进行了分析和表征,XRD法考察了前驱体在不同热处理条件下产物物相和晶粒度的变化情况,实验结果表明,在适当工艺参数下,前驱体经720℃,1h焙烧所得产物为平均粒径小于50nm的La_2O_3粉体.     

Effect of La_2O_3 on the wear behavior of MoSi_2 at high temperature

Wear behaviors of MoSi2 doped with La2O3 against SiC under different loads at 1000 oC in air were investigated by using an XP-5 type high temperature friction and wear tester. The worn surfaces and phases of the samples were analyzed by scanning electron microscopy (SEM) and X-ray diffraction, respectively. Results showed that the addition of La2O3 could obviously improve wear resistance of MoSi2. Because of the formation of MoO3 phase on the worn surface, La2O3/MoSi2 composite mainly exhibited oxidation and abrasive wear, which was different from the wear form of MoSi2 such as adhesion, oxidation and abrasion.     

Effect of La2O3 on granular bainite microstructure and wear resistance of hardfacing layer metal

The purpose of this work was to investigate the effect of La2 O3 on the granular bainite microstructure and wear resistance of hardfacing layer metal. The hardfacing layer metals with different contents of La2 O3 were prepared. The microstructures of the hardfacing layer metals were observed by field emission scanning electron microscopy(FESEM) and transmission electron microscopy(TEM). The hardness and wear resistance of the hardfacing layer metals were measured respectively. The results indicated that with the increasing content of La2 O3, the amount of granular bainite increased, while that of martensite decreased and that of retained austenite did not change obviously. When the content of La2 O3 was 2.55 wt.%, the volume fraction of the granular bainite in the hardfacing layer metal was 73.2%. Meanwhile, the wear resistance of the hardfacing layer metal was the largest, which was 12100 min/g. The mismatch between the face(100) of LaAlO3 and the face(100) of δ-Fe was 7.1%. Therefore, LaAlO3 could act as moderate effective heterogeneous nuclei of δ-Fe and the granular bainite could be refined.     

Oxidation Behavior of La_2O_3 Oxide Dispersion Strengthened Aluminum－Diffusional Coating

ＯｘｉｄａｔｉｏｎＢｅｈａｖｉｏｒｏｆＬａ_２Ｏ_３ＯｘｉｄｅＤｉｓｐｅｒｓｉｏｎ　ＳｔｒｅｎｇｔｈｅｎｅｄＡｌｕｍｉｎｕｍ－ＤｉｆｆｕｓｉｏｎａｌＣｏａｔｉｎｇＰｅｎｇＸｉａｏ；（彭晓）；ＬｉＴｉｅ－Ｆａｎ；（李铁藩）（ＣｏｒｒｏｓｉｏｎＳｃｉｅｎｃ...     

A Study on the Thermal Stability of La_2O_3-TiO_2 Supports

In this paper,various techniques including BET,XRD,SEM and XPS were used to study the sintering ofpure and La_2O_3-doped titania.The experimental results show that sintering of titania proceeds via volume diffu-sion.Adding of lanthanum oxide decreases the rate of sintering and hinders the phase transition from anatase torutile crystal by strong surface interaction between the mixed crystals(La_4Ti_9O_(24),La_(0.66)TiO_(2.99))and TiO_2.     

High Temperature Oxidation Behavior of La_2O_3-Mo_5Si_3/MoSi_2 Composites

~~High Temperature Oxidation Behavior of La_2O_3-Mo_5Si_3/MoSi_2 Composites     

Growth and optical properties of Pr~(3+):La_2CaB_(10)O_(19) crystal

Pr3+ doped La2CaB10O19 crystal were grown by the top-seeded solution growth(TSSG) method.The absorption spectra,emission spectra and lifetime were measured at room temperature.The J-O parameters(Ωt,t=2,4,6),the radiative transition probabilities AJ,J',oscillator strengths PJ,J',radiative lifetime τ,fluorescence branch ratios βJ and the value of integrated emission cross section have also been calculated.Five main absorption bands,3H4 to 3P1+3P2,3P0,1D2,3F3 + 3F4 and 3F2,were observed in the absorption spect...     

Electron Microscopic In－situ Observation for Preparation of Ultrafine La_2O_3 Nanophase Powder

ＥｌｅｃｔｒｏｎＭｉｃｒｏｓｃｏｐｉｃＩｎ－ｓｉｔｕＯｂｓｅｒｖａｔｉｏｎｆｏｒＰｒｅｐａｒａｔｉｏｎｏｆＵｌｔｒａｆｉｎｅＬａ_２Ｏ_３ＮａｎｏｐｈａｓｅＰｏｗｄｅｒＧａｏＹｕｚｕｎ（高愈尊），ＬｉＹｏｎｇｈｏｎｇ（李永洪），ＺｈａｎｇＴａｉｓｏｎｇ...     

Effects of MgO on Properties of La_2O_3-TiO_2 Ceramics

Effects of MgO on Properties of La_2O_3-TiO_2 Ceramics     

Enhancement of secondary emission property of molybdenum cathode co-doped with La_2O_3 and Y_2O_3

La2O3 and Y2O3 co-doped Mo secondary emitters were prepared by three kinds of doping method combined with high temperature plasma sintering.The secondary electron emission property and microstructure of the cathodes were studied.It showed that the cathode prepared by liquid-liquid doping method exhibited the best emission property among all the samples prepared by liquid-solid doping,solid-solid doping and liquid-liquid doping methods due to a uniform distribution of different substances.RE2O3 existed unifo...     

离子交换树脂法制备纳米La_2O_3及表征

以La(NO3)3.6H2O为原料,用强碱性阴离子交换树脂为沉淀剂,制备了纳米La2O3。前驱物及产物进行了TG-DTA、XRD、TEM、HRTEM、SAED、BET等表征。实验结果表明,前驱物是La(OH)3,产物为宽约20nm~25nm、长约为80nm~200nm的板状或棒状La2O3纳米多晶体。     

Influence of dispersant on Y_2O_3:Eu~(3+) powders synthesized by combustion method

Y2O3:Eu3+ powders were synthesized by combustion method and the influence of dispersant was investigated.XRD analysis indicated that the particle size increased with a small amount of dispersant firstly and then decreased with a further increase of dispersant.The morphologies of the powders were studied by scanning electron microscopy(SEM) and high-resolution transmission electron microscopy(HRTEM).SEM images revealed that an appropriate amount of dispersant could reduce the agglomeration significantly.Due ...     

La2O3对激光熔覆TiC/Ni基复合涂层的组织和性能的影响

用5kWCO2激光器在A3钢表面激光熔覆添加有La2O3的TiC/Ni基复合涂层，研究了稀土对激光熔覆金属陶瓷复合涂层的组织，耐蚀性和耐磨性的影响。研究结果表明：复合合金粉末中添加0.4%的La2O3能够减少熔覆层的气孔，疏松，使熔覆层的组织致密。熔覆层中TiC分布均匀且细小圆滑，熔覆层的耐蚀性和耐磨性得到提高。     

Microstructure and high-temperature properties of Fe-Ti-Cr-Mo-B-C-Y_2O_3 laser cladding coating

Fe-based composite coatings were fabricated on 5 CrNiMo die steel by laser beam melting a precursor mixture of ferrotitanium,ferrochromium,ferromolybdenum,B4 C and Y_2 O_3 powders.Micro structure and properties of the coatings were studied by X-ray diffraction(XRD),scanning electron microscopy(SEM),energy-dispersive spectrometer(EDS),resistance furnace and high-temperature tribometer.The results show that(Ti,Mo)C particles with flower-like and(Ti,Mo)B_2 with block-like shapes are in situ formed during laser cladding.Volume faction of multiple ceramic particles increases with the increasing of Y_2 O_3.The cumulative oxidation mass of the coating with 2 wt% Y_2 O_3 is decreased by one-third than that of the coating without Y_2 O_3.The oxidation layer of the coating with Y_2 O_3 is getting smooth.Meanwhile,high temperature wear volume loss of the coating with 2 wt% Y_2 O_3 is about 40% that of the coating without Y_2 O_3.The coating with 2 wt% Y_2 O_3 shows a smoother wear scar and few flat grooves are observed after high temperature wear test.     

Preparation and Photocatalytic Property of Er_2O_3/TiO_2 Complex Photocatalyst

Preparation and Photocatalytic Property of Er_2O_3/TiO_2 Complex Photocatalyst     

Effect of refining slag containing Ce_2O_3 on steel cleanliness

The effect of pre-melting refining slag containing different contents of Ce2O3 on the absorption and modification of Al2O3 inclusion in an Al-killed steel was investigated through the slag/steel reaction experiment at 1600 oC.It was found that the replacement of 10 wt.% Al2O3 with Ce2O3 for 50 wt.%CaO-33 wt.%Al2O3-7 wt.%MgO-10 wt.%SiO2 refining slag promoted the slag absorption ability of alumina inclusion,which made the total oxygen content determined by infrared absorption method decrease from 100 to 25 ppm in 15 min.The Mg-Al-Ce-O type inclusion was also detected in the as-solidified samples by scanning electron microscopy(SEM).Thermodynamic analysis indicated that the Ce2O3.Al2O3 type inclusions would be formed with the cerium content in the range of 6.9 ppb to 3.6 ppm when the content of aluminum was 0.01 wt.%.     

纳米氧化镧对电铸电极材料抗电蚀性的影响

增强工具电极材料的耐电蚀能力,降低电极损耗是微细电火花加工技术可靠、稳定且高效制造高深宽比微结构和器件的研究关键之一。选用纳米量级稀土氧化物-氧化镧为电铸基液添加剂制备了微工具铜电极材料,探讨了它的作用机理,分析了电铸铸层的微观形貌,并实验研究了纳米氧化镧添加剂对电铸电极材料抗电蚀性能的影响,优选了电沉积工艺参数。结果表明:添加适量纳米氧化镧添加剂并在适当电沉积条件下,电铸铜电极材料表现出较强的抗电蚀能力,且综合机械性能优异。     

Growth of CeO_2, Y_2O_3 Buffer Layers for YBCO Coated Conductor

~~Growth of CeO_2, Y_2O_3 Buffer Layers for YBCO Coated Conductor     

Structure and Transport Properties in CMR Materials of La（1-x）2/3Ca1/3MnO3 with Rare Earth Vacancies

Samples of manganese oxides La（1-x）2/3Ca1/3MnO3（x 〈 0.10） with Lavacancy were prepared by standard solid-state reaction method. All the samples are single phase, with orthorhombic symmetry （Pnma ）, analyzed by XRD and with Rietveld Refinement. The effect of different La-site vacancies concentration on electronic transport of La（1-x）2/3Ca1/3MnO3 was investigated. The insulator-metal transition temperature （about 267 K） nearly remains unchanged with the increase of vacancy concentration, which indicates that small La-vacancy does not destroy the double exchange interaction. But the electronic resistance increases and MR value decreases with La-vacancy content x 〉 0.04. The maximum of the MR value （8 T） is about 220% at transition temperature （TMI）.