共查询到20条相似文献,搜索用时 62 毫秒
1.
为了考察阴离子种类对掺杂Co2+纳米Ni(OH)2性能的影响,采用不同镍盐制备出掺杂Co2+纳米Ni(OH)2,并采用X射线衍射(XRD)、透射电子显微镜(TEM)、循环伏安技术(CV)和恒流充放电方法对材料物化性能和电化学性能进行了研究.研究结果表明,掺杂Co2+的纳米Ni(OH)2为β-Ni(OH)2,衍射峰发生明显宽化.样品颗粒的尺寸为60~100 nm,阴离子的变化对制得的Ni(OH)2的表观形貌有影响.恒流充放电实验表明,阴离子为NO3-时,样品的质量比容量较高,0.2 C放电达到了234.6 mAh.g-1.循环伏安测试表明,阴离子为SO42-时,样品有较好的可逆性,阴离子为NO3-或SO42-时有较高的质子扩散系数. 相似文献
2.
以草酸和乙酸镍为原料,通过低温固相法合成前驱体(NiC2O4.2H2O)粉末。用此前驱体粉末与固态NaOH混合并充分研磨制得纳米Ni(OH)2粉末。经SEM、XRD测试表明,制得的纳米Ni(OH)2粉末是平均粒径约为12nm的β-Ni(OH)2。用循环伏安法、恒流充放电测试和交流阻抗谱研究Ni(OH)2电极的电化学电容特性。结果表明在电流密度为1A.g-1时,其比电容高达2271F.g-1,且经多次循环后表现出较好的循环稳定性能。 相似文献
3.
4.
沉积钴镀层的球形Ni(OH)2的电性能研究 总被引:2,自引:0,他引:2
采用化学度的方法在球形Ni(OH)2表面包覆了金属钴,通过比较恒电流充放电实验和循环伏安实验结果,发现球形Ni(OH)2表面镀钴,可以明显提高电极的放电容量,活性物质利用率,增加电极反应的可逆性,用XRD法比较研究了包覆钴和掺钴球形Ni(OH)2正极在充放电过程中相的生成和变化,发现掺钴的球形Ni(OH)2可抑制γ-NiOOH的生成,这有利于提高Ni(OH)2电极的循环寿命。此外,本文还对镀钴层改进Ni(OH)2电极性能的机理进行了讨论。 相似文献
5.
6.
采用共沉积方法制备出掺杂Co的纳米β-Ni(OH)2,并对Co掺杂比例与材料性能的关系进行了研究.XRD、TEM测试结果表明,利用共沉积法可以制备出不同掺杂Co比例的纳米β-Ni(OH)2,随着Co掺杂比例的增大,材料的晶格缺陷明显增多,晶格参数和表面型貌也发生相应的变化.利用微电极的循环伏安(CV)行为研究表明,掺杂后材料的循环伏安性均较掺杂前有所改善,且Co的掺杂比例对材料的氧化峰电位(EP,a)、还原峰电位(EP,c)及质子扩散系数(D)均产生影响,当Co的掺杂比例为5%时,材料的质子扩散性能相对最好. 相似文献
7.
纳米Ni0.5Zn0.5Fe2O4铁氧体的制备及电磁损耗特性研究 总被引:10,自引:0,他引:10
采用NH4 HCO3与FeCl3·6H2O、Zn(NO3)2·6H2O、Ni(NO3)2·6H2O进行室温固相反应制得Fe(OH)3、Zn3(OH)4CO3·H2O、Ni3(OH)4CO3·4H2O混合前驱物,先经微波加热,再热分解制得纳米粉体.利用激光粒度分析仪、XRD、SEM和TEM对分解产物进行了表征,获得了形貌为球形、颗粒分布均匀、平均粒度为62nm、尖晶石结构的纳米Ni0.5Zn0.5Fe2O4复合铁氧体粉体.经测试样品的相对介电常数和相对磁导率后,发现该纳米铁氧体粉体在100~1800MHz内具有良好的电损耗和磁损耗性能. 相似文献
8.
9.
Al代α-Ni(OH)2的高温电化学性能 总被引:4,自引:0,他引:4
采用均相沉淀法合成了颗粒尺寸较小的Al代Ni(OH)2,并对Al代Ni(OH)2粉末的微观形貌、晶体结构、化学组成及高温电化学性能进行了研究.结果表明,实验制备的Al代Ni(OH)<.2>属于稳态α型结构,微观颗粒由纳米级纤维束组成,其化学式可表示为Ni0.70Al0.18(OH)1.6(CO3)0.1(SO4)0.07·(H2O)0.6,在MH-Ni电池中制备的正极具有较好的高温充电效率和循环性能,60℃时的析氧电位较高,放电容量比25℃仅衰减15mAh/g,晶型结构稳定,60℃循环95次后仍保持以α相为主的晶态结构. 相似文献
10.
11.
A method is proposed for estimating the parameters of a mixture of exponential and Weibull distributions for which the accuracy of preliminary estimates obtained by graphical analysis is refined in accordance with the criterion of maximum likelihood. The efficiency of the proposed method is supported by the results of statistical modeling. 相似文献
12.
An approximate analytical expression is derived for the velocity of the front of the wave of change of boiling modes on a
rod and on a plate. The impact of the Thomson effect and of the heater orientation in the gravity field is included. Adequate
agreement is demonstrated between the derived relations and experimental data. 相似文献
13.
Liebert A Wabnitz H Grosenick D Möller M Macdonald R Rinneberg H 《Applied optics》2003,42(28):5785-5792
A novel method for the determination of the optical properties of tissue from time-domain measurements is presented. The data analysis is based on the evaluation of the first moment and the second centralized moment, i.e., the mean time of flight and the variance of the measured distribution of times of flight (DTOF) of photons injected by short (picosecond) laser pulses. Analytical expressions are derived for calculation of absorption and of reduced scattering coefficients from these moments by application of diffusion theory for infinite and semi-infinite homogeneous media. The proposed method was tested on experimental data obtained with phantoms, and results for absorption and reduced scattering coefficients obtained by the proposed method are compared with those obtained by fitting of the same data with analytical solutions of the diffusion equation. Furthermore, the accuracy of the moment analysis was investigated for a range of integration limits of the DTOF. The moment analysis may serve as a comparatively fast method for evaluating optical properties with sufficient accuracy and can be used, e.g., for on-line monitoring of optical properties of biological tissue. 相似文献
14.
15.
16.
水三相点是开尔文热力学温度的唯一基准点,也是ITS-90国际温标重要的定义固定点。因此,水三相点不确定度分析对整个温标的建立、温度量值传递起着至关重要的作用。近3年来,中国计量科学研究院研制出一系列高质量的水三相点容器,加强了水三相点的研究,为不确定度的分析提供了更为可靠的实验依据。同时,不确定度的分析也是客观评价新研制容器性能的一个重要指标。因此,根据实验结果对新研制容器所复现的水三相点进行了不确定度评定。评定结果表明,其扩展不确定度为0.16mK(k=2.69,P=0.99)。 相似文献
17.
18.
19.