氨化Si基Ga2O3／Al2O3制备GaN薄膜

研究了Ga2O3／Al2O3膜反应自组装制备GaN薄膜。首先利用磁控溅射法在硅衬底上制备Ga2O3／Al2O3膜，再将Ga2O3／Al2O3膜在高纯氨气气氛中氨化反应得到了GaN薄膜。用X射线衍射(XRD)，X光光电子能谱(XPS)、扫描电镜(SEM)、透射电镜(TEM)和荧光光谱(PL)对样品进行结构、组分、形貌和发光特性的分析。测试结果表明：用此方法得到了六方纤锌矿结构的GaN晶体膜。     

氨化硅基Ga2O3／Al2O3制备GaN薄膜性质研究

研究了Ga2O3／Al2O3膜反应自组装制备GaN薄膜。首先利用磁控溅射法在硅衬底上制备Ga2O3／Al2O3膜，再将Ga2O3／Al2O3膜在高纯氨气气氛中氨化反应得到GaN薄膜。用傅里叶红外谱仪(FTIR)，X射线衍射(XRD)和扫描电镜(SEM)对试样进行结构、组分和形貌分析。通过分析薄膜各方面的性质，得出了用此方法制备氮化镓薄膜的Al2O3缓冲层最佳的厚度为15nm左右，最佳氨化条件是在900℃下氨化15min。     

稀土金属Tb催化制备GaN纳米棒(英文)

利用稀土金属Tb作为催化剂,通过氨化磁控溅射在Si(111)衬底上的Ga2O3/Tb薄膜制备出GaN纳米棒。X射线衍射和傅里叶红外吸收谱测试结果表明,制备的样品为六方结构的GaN。利用扫描电子显微镜、透射电子显微镜和高分辨透射电子显微镜对样品进行测试,结果显示样品为单晶结构的纳米棒,直径为80～200nm,长度达几十微米。最后简单地讨论了GaN纳米棒的生长机制。     

高温氨化Ga2O3形成GaN粉末

采用NH3为N源，以Ga2O3粉末为Ga源高温氨化形成GaN粉末。用X射线衍射(XRD)、扫描电子显微镜(SEM)、选择区电子衍射(SAED)对粉末进行结构、形貌分析。结果表明：当Ga源温度为850℃时得到六方纤锌矿结构的GaN晶体颗粒。     

Preparation of GaN Nanorods by Rare Earth Metal Tb Catalyst-Assisted Process

利用稀土金属Tb作为催化剂,通过氨化磁控溅射在Si(111)衬底上的Ga203/Tb薄膜制备出GaN纳米棒.X射线衍射和傅里叶红外吸收谱测试结果表明,制备的样品为六方结构的GaN.利用扫描电子显微镜、透射电子显微镜和高分辨透射电子显微镜对样品进行测试,结果显示样品为单晶结构的纳米棒,直径为80～200 nm,长度达几十微米.最后简单地讨论了GaN纳米棒的生长机制.     

热壁化学气相沉积Si基GaN晶体膜的研究

采用热壁化学气相沉积工艺在Si(111)衬底上生长GaN晶体膜，并对其生长条件进行研究。用X射线衍射(XRD)、扫描电镜(SEM)、荧光光谱(PL)对样品进行结构、形貌和发光特性的分析。测试结果表明：用此方法得到了六方纤锌矿结构的GaN晶体膜。实验结果显示：采用该工艺制备GaN晶体膜时，选择H2作反应气体兼载体，对GaN膜的形成起着非常有利的作用。     

Preparation and Properties of GaN Micro-Ribbons on Ga-Diffused Si （111） Substrates

用射频磁控溅射工艺在室温扩镓硅衬底上沉积Ga2O3膜,然后在氨气气氛下氮化Ga2O3膜得到GaN微米带,用X射线衍射(XRD)、扫描电镜(SEM)、选区电子衍射(SAED)、X射线光电子能谱(XPS)及光致发光谱(PL)对薄膜样品进行了结构、表面形貌、组分及发光特性分析.SEM图像显示直径约为100 nm～300 nm微米带随机分布在GaN薄膜表面.XRD、XPS及SAED分析表明GaN微米带呈六方闪锌矿多晶结构,择优沿[001]方向生长.P1显示了可能由量子限制效应引起的发光峰,其相对于报道的GaN晶体发光峰有显著蓝移.     

Synthesis of GaN nanorods on Si substrates with assistance of the volatilization of ZnO middle layers

GaN nanorods have successfully been synthesized on Si(111) substrates via ammoniating ZnO/Ga2O3 films at 950℃. Ga2O3 thin films and ZnO middle layers were deposited in turn on Si(111) substrates by r.f. magnetron sputtering system. ZnO volatilized at 950℃ in the ammonia ambience and Ga2O3 reacted to NH3 to fabricate GaN nanorods in the later ammoniating process. The volatilization of ZnO layers played an important role in the fabrication. The structure and composition of the GaN nanorods were studied by X-ray diffraction (XRD) and Fourier transform infrared spectrophotometer (FTIR). The orphology ofGaN nanorods was investigated using scanning electron microscopy (SEM) and transmission electronic microscope (TEM). The analyses of measured results revealed that GaN nanorods with hexagonal wurtzite stxucture were prepared by this method.     

以磁控溅射＋自组装反应方式制备GaN薄膜

为了用简单的方法得到GaN薄膜，以射频磁控溅射方法将Ga2O3薄膜沉积到Si（111）衬底上的SiC中间层上，通过其同NH3的自组装反应形成了GaN薄膜。同样，利用磁控溅射方法把SiC层沉积到Si衬底。其目的是为了缓冲由GaN外延层和Si衬底的晶格失配造成的应力。为了比较中间层的作用，对按照两种方案（使用中间层和不使用中间层）实验样品进行了测试和比较。实验结果证实了SiC中间层提高了GaN薄膜的质量。     

氨化硅基Ga2O3／Al2O3制备GaN薄膜的发光特性研究

研究了Ga2O3／Al2O3膜氢化反应自集结制备GaN薄膜的光致发光特性，讨论了发光机制以及生长条件对其光致发光特性的影响。样品的荧光光谱在347nm有一强发光峰，在412nm有一弱发光峰，这两个峰的强度都随着氨化温度的升高和氨化时间的增长而增强，但峰的位置保持不变。我们认为347nm的峰是GaN的带边发光峰由于薄膜中晶粒尺寸的减小而蓝移造成的，而412nm的发光峰则来源于导带到杂质受主能级的辐射复合。     

Fabrication of hexagonal gallium nitride films on silicon (111) substrates

Hexagonal gallium nitride films were successfully fabricated through ammoniating Ga2O3 films deposited on silicon (111) substrates by electrophoresis. The structure, composition, and surface morphology of the formed films were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The measurement results reveal that the polycrystalline GaN films with hexagonal wurtzite structure were successfully grown on the silicon (111) substrates. Preliminary results suggest that varying the ammoniating temperature has obvious effect on the quality of the GaN films formed with this method.     

氨化Ga2O3 /Nb膜制备的GaN纳米线的光学和微观结构特性的研究

采用射频磁控溅射技术在硅衬底上制备Ga2O3/Nb薄膜,然后在900℃下于流动的氨气中进行氨化制备GaN纳米线.用X射线衍射(XRD)、透射电子显微镜(TEM)和高分辨透射电子显微镜详细分析了GaN纳米线的结构和形貌.结果表明:采用此方法得到的GaN纳米线有直的形态和光滑的表面,其纳米线的直径大约50nm,纳米线的长约几个微米.室温下以325nm波长的光激发样品表面,只显示出一个位于367 nm的很强的紫外发光峰.最后,简单讨论了GaN纳米线的生长机制.     

Preparation and characterization of GaN films grown on Ga-diffused Si （111） substrates

Hexagonal GaN films were prepared by nitriding Ga2O3 films with flowing ammonia. Ga2O3 films were deposited on Ga-diffused Si (111) substrates by radio frequency (r.f.) magnetron sputtering. This paper have investigated the change of structural properties of GaN films nitrided in NH3 atmosphere at the temperatures of 850, 900, and 950℃ for 15 min and nitrided at the temperature of 900℃ for 10, 15, and 20 rain, respectively. X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS) were used to analyze the structure, surface morphology and composition of synthesized samples. The results reveal that the as-grown films are polycrystalline GaN with hexagonal wurtzite structure and GaN films with the highest crystal quality can be obtained when nitrided at 900℃ for 15 min.     

氨化Si基Ga2O3/V膜制备GaN纳米线

氨化硅基钒应变层氧化镓膜制备了大量氮化镓纳米线,X射线衍射、扫描电子显微镜和透射电子显微镜观察发现,纳米线具有十分光滑且干净的表面,其直径为20～60 nm左右,长度达到十几微米.高分辨透射电子显微镜和选区电子衍射分析结果表明,制备的氮化稼纳米线为六方纤锌矿结构.光致发光谱显示制备的氮化稼纳米线有良好的发光特性.另外,简单讨论了氮化稼纳米线的生长机制.     

Catalytic Growth of Large-Scale GaN Nanowires

A novel lanthanon seed was employed as the catalyst for the growth of GaN nanowires. Large-scale GaN nanowires have been synthesized successfully through ammoniating Ga₂O₃/Tb films sputtered on Si(111) substrates. Scanning electron microscopy, x-ray diffraction, high-resolution transmission electron microscopy, and Fourier transform infrared spectroscopy were used to characterize the samples. The results demonstrate that the nanowires are single-crystal hexagonal wurtzite GaN. The growth mechanism of GaN nanowires is also discussed.