Hydrodechlorination of CCl<Subscript>4</Subscript> on Pt–Au/Al<Subscript>2</Subscript>O<Subscript>3</Subscript> Catalysts

A series of Pt/Al₂O₃ catalysts were prepared by the impregnation method and were characterized by TEM, XRD, H₂ and CO chemisorptions, and investigated in the hydrodechlorination of tetrachloromethane. Three Pt-rich, Pt–Au/Al₂O₃ catalysts (Pt₁₀₀, Pt₉₅Au₅ and Pt₉₀Au₁₀) showed a similar metal particle size (~2.5–2.7 nm), so observed changes in the catalytic behavior are ascribed to alloying effect, especially because a considerable degree of Pt–Au mixing was achieved in the bimetallic samples. It appeared that by introducing very small amount of gold (10 at.%) to platinum, the catalytic activity is increased. It is argued that the occurrence of this moderate synergistic effect is associated with a decreased tendency of surface chloriding when platinum is alloyed with gold. Zbigniew Kowalczyk—deceased.     

Bimetallic Pd–Cu/ZnO–Al<Subscript>2</Subscript>O<Subscript>3</Subscript> and Pd–Cu/ZrO<Subscript>2</Subscript>–Al<Subscript>2</Subscript>O<Subscript>3</Subscript> catalysts for methanol synthesis

Monometallic copper and bimetallic palladium-copper catalysts supported on ZnO–Al₂O₃ and ZrO₂–Al₂O₃ were prepared by conventional impregnation method and tested in methanol synthesis reaction under elevated pressure (3.5 MPa) in gradientless reactor at 220°C. The physicochemical properties of prepared catalytic systems were studied using BET, X-ray, TPR-H₂, TPD-NH₃ techniques. The promotion effect of palladium on catalytic activity and selectivity of copper supported catalyst in methanol synthesis reaction was proven. The highest activity of this system is explained by the Pd–Cu alloy formation.     

Mechanical,Structural and Thermal Properties of Transparent Bi<Subscript>2</Subscript>O<Subscript>3</Subscript>–Al<Subscript>2</Subscript>O<Subscript>3</Subscript>–ZnO–TeO<Subscript>2</Subscript> Glass System

Oxide based optical glass materials has important potential material in many applications from fiber optic to sensor due to the high transparency and amourphous structures. The objective of this study is to synthesize the novel optical glass materials based on the bismuth and aluminum contents to be able to determine the physical, chemical and mechanical properties by considering the systematic experimental steps. In this study, Bi₂O₃–Al₂O₃ based tellurite optical glasses have been prepared by using conventional melt quenching method as a function of the both Bi₂O₃ and Al₂O₃ compositions. There is a strong interactions between the glass former and modifier ions that might effect on the structure and mechanical properties. During the experimental steps, thermal, structural and mechanical properties of the prepared glass materials have been determined considering the DTA/DSC, FT-IR spectroscopy, SEM and Vicker’s hardness techniques, respectively. Thermal parameters, like glass transition, T_g, onset, T_x, crystallization, T_p, and melting, T_m, temperatures were obtained by using DTA scan.     

Enhancement of the Activities of γ-Ga<Subscript>2</Subscript>O<Subscript>3</Subscript>–Al<Subscript>2</Subscript>O<Subscript>3</Subscript> Catalysts for Methane-SCR of NO by Treatment with NH<Subscript>3</Subscript>

Abstract  

The precursor particles for γ-Ga₂O₃–Al₂O₃ solid solutions were prepared by the coprecipitation method from aqueous solutions of Ga(NO₃)₃ and Al(NO₃)₃ with (NH₄)₂CO₃ as a precipitant. The γ-Ga₂O₃–Al₂O₃ solid solutions were obtained by calcination of the precursor at 700 °C. In this paper, the performance of the catalysts treated with NH₃ was investigated for the selective catalytic reduction (SCR) of NO with methane as a reducing agent, and it was found that γ-Ga₂O₃–Al₂O₃ catalysts treated with NH₃ and subsequently annealed in air showed higher activities than the γ-Ga₂O₃–Al₂O₃ catalysts without NH₃ treatment. NH₃ treatment of the catalyst caused partial rearrangement of Ga³⁺ and Al³⁺ ions and increased the population of tetrahedral Ga³⁺ ions in the defective spinel structure.     

Monte Carlo Design and Experiments on the Neutron Shielding Performances of B<Subscript>2</Subscript>O<Subscript>3</Subscript>–ZnO–Bi<Subscript>2</Subscript>O<Subscript>3</Subscript> Glass System

Neutron shielding properties of (90 – x)B₂O₃–10ZnO–xBi₂O₃ glass systems (where x = 15, 20, 25 and 30 mol %) were investigated by Monte Carlo simulations (FLUKA and GEANT4) and experiments. Neutron mass removal cross sections, number of inelastic scattering, elastic scattering, and capture interactions were estimated by simulations. ²⁴¹Am/Be neutron source was used for the neutron equivalent dose rate measurements. As a result, produced glass samples have fine neutron shielding capacity.     

Structural heterogeneity of SiO<Subscript>2</Subscript>–Na<Subscript>2</Subscript>O–Al<Subscript>2</Subscript>O<Subscript>3</Subscript> glass

It is shown that the phase heterogeneity of SiO₂–Na₂O–Al₂O₃ glass has a liquation and crystallization nature, the balance between which is determined by the conditions of their synthesis. An increase in the aluminum oxide content decreases the number of liquation and crystallization sites, and also the linear sizes of the crystalline formations without eliminating the phase separation due to the liquation. The area of metastable immiscibility in the SiO₂–Na₂O–Al₂O₃ system, which is determined by scanning electron microscopy, is probably wider than the area detected by the optical methods.     

Photon interaction parameters for some ZnO–Al<Subscript>2</Subscript>O<Subscript>3</Subscript>–Fe<Subscript>2</Subscript>O<Subscript>3</Subscript>–P<Subscript>2</Subscript>O<Subscript>5</Subscript> glasses

Some photon interaction parameters such as mass attenuation coefficient, effective atomic number, half value layer, mean free path and electron density for 15ZnO–(17.5–x)Al₂O₃–xFe₂O₃–67.5P₂O₅ glass system (x = 0, 7.5, 12.5, 17.5) and 15ZnO–(25–x)Al₂O₃–xFe₂O₃–60P₂O₅ glass system (x = 0, 25) have been investigated in the photon energy range of 1 keV to 100 GeV. It has been observed that all the photon interaction parameters for the selected glass systems vary with the photon energy. Among the selected glass systems, the sample 15ZnO–25Fe₂O₃–60P₂O₅ glass system shows maximum values for mass attenuation coefficients, effective atomic numbers, electron densities and minimum values for mean free path and half value layer in the entire energy grid.     

Conversion of 4-Methylanisole Catalyzed by Pt/γ-Al<Subscript>2</Subscript>O<Subscript>3</Subscript> and by Pt/SiO<Subscript>2</Subscript>-Al<Subscript>2</Subscript>O<Subscript>3</Subscript>: Reaction Networks and Evidence of Oxygen Removal

Abstract  

The conversion of 4-methylanisole, a prototypical bio-oil compound, was catalyzed by Pt/Al₂O₃, Pt/SiO₂-Al₂O₃, or HY zeolite at 573 K and atmospheric pressure. More than a dozen products were formed with each catalyst, the most abundant being 4-methylphenol, 2,4-dimethylphenol, and 2,4,6-trimethylphenol; toluene was also a major product when the catalyst was supported platinum with H₂ as a co-reactant. 4-Methylphenol was the only methylphenol isomer formed in significant yields, which indicates that migration of the methyl group on the aromatic ring is not significant under the selected reaction conditions. The data determine approximate reaction networks including reactions forming 4-methylphenol, 2,4-dimethylphenol, and toluene as primary products. The kinetically significant reaction classes were transalkylation, observed with all three catalysts, and hydrogenolysis (including hydrodeoxygenation) and hydrogenation, observed only with the platinum-containing catalysts operating in the presence of H₂. Data such as those reported here provide a starting point for predicting the conversion of whole bio-oils for removal of oxygen and upgrading of fuel properties.     

Porous ceramics based on the ZrO<Subscript>2</Subscript>(Y<Subscript>2</Subscript>O<Subscript>3</Subscript>)–Al<Subscript>2</Subscript>O<Subscript>3</Subscript> system for filtration membranes

The results of the studies of the process of fabricating ceramic filtration membranes in the system ZrO₂(Y₂O₃)–Al₂O₃ are presented. The phase compositions of the precursor powders and sintered ceramics have been investigated and their porous structures have been determined. Two stages of the implementation of the technology were demonstrated: fabrication of substrates with an open porosity ranging from 20 to 47% and pore sizes in the 100–300 nm range, as well as the deposition of nanocrystalline aluminum oxide layers on them. It has been established that the pore size distribution in the membrane layer of α-Al₂O₃ is unimodal (from 30 to 100 nm).