共查询到20条相似文献,搜索用时 109 毫秒
1.
2.
MnZn功率软磁铁氧体磁芯在开关电源中的应用 总被引:2,自引:0,他引:2
以天通公司生产的EC49型和ET35型磁芯在彩色电视机电源部分的应用为例,分析开关电源的工作原理及功率软磁铁氧体磁芯的主要性能对开关电源的影响。 相似文献
3.
郑秀峰 《卫星电视与宽带多媒体》2009,(3)
在卫星数字接收机的开关电源电路中,应用较多的是电源控制集成电路,由分立元件构成的开关电源并不多见。近年来,部分数字机生产厂家为了降低成本,采用以C5027为主要元件组成的分立元件式通用型开关电源,而高斯贝尔GSR-VD33数字卫星接收机则应用了另一类由分立元件组成的开关电源,如图为高斯贝尔GSR-VD33数字卫星接收机开关电源的电原理图,现就其工作原理及常见故障做一简要分析,供参考。 相似文献
4.
分析了单端反激式开关电源的工作原理,运用动态小信号平均模型分析法,对开关电源的主电路及控制电路组成的一个闭环控制系统进行数学模型的建立,并进行动态分析,以求达到最佳的控制效果。 相似文献
5.
从开关电源的思路出发,对双折射测试仪的可调直流电压电路部分进行了改进。用开关电源PWM控制芯片UC3842设计取代了原来的单管自激式直流变换器,并对差动输出电路进行了重新设计。阐述了电路工作原理,并对改进后的电压源进行了连机调试,结果性能良好。 相似文献
6.
7.
介绍了P350S卫星电视接收机开关电源原理,开关电源电流控制芯片IP3844N,着重对P350S开关电源的故障现象进行分析,辅以相应的维修程序及对策。 相似文献
8.
9.
本文从多年的维护实践出发,分析广播电视发射设备高频开关电源的工作原理,以及对主流PWM控制芯片的介绍,简明的概括了开关电源的分类和广播电视发射设备常用开关电源,对广播电视发射机高频开关电源维修与维护进行了总结并举例说明。 相似文献
10.
介绍了P350S卫星电视接收机开关电源原理,开关电源电流控制芯片IP3844N,着重对P350S开关电源的故障现象进行分析,辅以相应的维修程序及对策。 相似文献
11.
KR-200T型高频开关电源的研制 总被引:1,自引:0,他引:1
为了满足通信系统对于200W三输出特殊规格开关电源的需要,研制成功了一款基于正激变换的KR-200T型高性能开关电源。文中对该研究成果作了基本总结,内容包括:该电源的技术规格、工作原理、元件选择、控制电路设计和测试结果等。 相似文献
12.
13.
14.
In this paper, a wide input range multiple output flyback switch-mode power supply (SMPS) with its design aspects is presented. The implemented SMPS is intended to be used in various applications in industry requiring low power and operating under wide input voltage fluctuations. The SMPS is designed using TOPSwitch off-line switched integrated circuit and includes line protection, input filter, rectifier, switching control, output rectification and feedback circuitries. A 5 Watt prototype has been manufactured and is validated through measurements. Experimental results obtained from evaluation tests demonstrate distinct features like wide input range, multiple regulated output voltages, isolation and high efficiency. Technology challenges for the full integration of the presented SMPS are briefly discussed. 相似文献
15.
16.
为提高开关电源控制芯片使用灵活性,优化对开关电源效率、纹波等性能的控制,并方便噪声滤除,提出一种带锁相环的多模式时钟发生电路芯片的设计。该电路可提供选择1.7MHz或2.6MHz的固定频率模式或锁相范围500kHz~3MHz的外部输入模式,应用于开关电源控制芯片时,可根据开关电源的应用情况设置工作频率,达到性能最佳化。该芯片已在1.5μmBCD(Bipolar-CMOS-DMOS)工艺下设计完成。测试结果表明芯片工作正常,预期的功能均已实现,可作为模拟电路IP使用。 相似文献
17.
Tarateeraseth V. Hu B. See K. Y. Canavero F. G. 《Power Electronics, IEEE Transactions on》2010,25(1):111-117
18.
The application of the duality principle to nonplanar circuits 总被引:1,自引:0,他引:1
It is shown how the duality principle can be applied to nonplanar circuits such as three-phase bridge converters and their loads. While the direct duals have restricted utility, they provide some insight into the formation of three-phase conversion circuits that ultimately allow several new converters to be developed. These include new frequency converters, a three phase sinusoidal input current, switched-mode power supply (SMPS), and an SMPS with a three-phase high-frequency link. Some current techniques and supporting simulation results are presented 相似文献
19.
Switched mode power supplies (SMPS) with multiple outputs are commonly used for powering up personal computers and many other consumer electronic appliances. Multiple output SMPS circuits normally employ several DC/DC converters for regulating the voltage in each of the outputs. In this paper, a single single ended primary inductance converter (SEPIC) is used to obtain multiple isolated and regulated DC outputs from a single unregulated DC input, so that the reliability and cost effectiveness of the system can be enhanced. Considering that a large number of SMPS are being used in various applications, it is essential to maintain good power quality at the AC mains side of the SMPS circuit adhering to the international standards. Average current control mode has been used in this paper to achieve unity power factor and sinusoidal current at the input side. A novel weighted error approach has been proposed to achieve excellent voltage regulation at all the outputs of the SMPS irrespective of the load variations and input supply fluctuations. The proposed system has been designed and simulated in a PSIM environment and implemented in hardware. The results obtained show an enhanced performance of the power supply in terms of its output voltage regulation and input power quality. 相似文献
20.
In order to comply with the standards, the input current of the switch mode power supplies (SMPS) must be almost sinusoidal, i.e. the SMPS must achieve power factor correction. This requirement is normally reached with the use of an additional input converter, typically a boost, resulting in a two-stage SMPS with the inherent drawbacks: high cost and the necessity of high efficiency in each stageto obtain a reasonable global efficiency. This article introduces two simple techniques together with the control strategies that can be used to obtain single-stage SMPS, that allow the control of the output voltage and the sinusoidal input current wave shaping, without any additional stage. Another objective of this article is to investigate and to evaluate the performance of each topology that emerged from the chosen technique. Considering high-power applications, experimental results of two single-stage full-bridge topologies are also presented, in order to verify the concepts introduced in the article. 相似文献