共查询到17条相似文献,搜索用时 199 毫秒
1.
2.
本文提出一种密闭爆发器中散热修正的新观点。它利用了电路模拟方法引入一个压强时变信号的“传递函数”概念,用以表述各种不同尺寸和形式的密闭爆发器的特征。通过一个“传递函数”补偿滤波器来复原无散热理想情况下的压强时变信号,可望对发射药在密闭爆发器中燃烧时气体生成与压力增长关系有更准确的表述。这种概念还可能进一步推广到火炮膛内气体变容而作功的情况,从而提供新的火炮弹道解法。 相似文献
3.
本文提出一种密闭爆发器中散热修正的新观点。它利用了电路模拟方法引入一个压强时变信号的“传递函数”概念,用以表述各种不同尺寸和形式的密闭爆发器的特征。通过一个“传递函数”补偿滤波器来复原无散热理想情况下的压强时变信号,可望对发射药在密闭爆发器中燃烧时气体生成与压力增长关系有更准确的表述。这种概念还可能进一步推广到火炮膛内气体变容而作功的情况,从而提供新的火炮弹道解法。 相似文献
4.
5.
6.
本文阐述了应用密闭爆发器试验方法对库存发射药的性能进行检验时,应把研究工作的重点放在燃烧性能方面,并应特别注意30~80MPa压力范围内燃烧性能变化情况。 相似文献
7.
8.
9.
为了研究DAGQ发射药在膛内的燃烧性能,以经典内弹道理论为基础,建立了发射药膛内燃烧测试系统和处理方法,通过密闭爆发器燃烧试验和微波干涉法发射药膛内动态燃烧性能试验,研究了DAGQ发射药的静动态燃烧规律及不同温度下的动态燃烧特性。结果表明,所建立的试验系统和处理方法,能够很好地获得弹丸在膛内的运动过程。DAGQ发射药的静动态燃速都存在转折现象,静态燃速在转折点前压力指数大于1,转折点后压力指数都远小于1,动态燃速压力指数基本都小于1。在膛内燃烧过程中,由于高速气流对发射药的燃面冲刷,使得膛内的动态燃速要大于密闭爆发器内的静态燃速,并且随着膛内压力的增大,燃速相差越来越大。 相似文献
10.
11.
分析了低温感发射装药燃烧过程,根据爆发器定容燃烧试验结果,阐明了火炮产生低温单发跳差的主要原因,叙述了一种消除低温单发跳差的装药方法。 相似文献
12.
Hand-made, charcoal-containing black powders exhibited higher heats of combustion than commercial black powders; the values were also higher than values previously reported in the literature. However, commercial pellets attained maximum pressure in a closed bomb upon ignition more rapidly and had better physical integrity than the char-coal-containing laboratory products. When channel and furnace blacks were used instead of charcoal, pellets with excellent physical integrity were obtained. These products had lower heats of reaction than commercial black powder and also developed maximum pressure in a closed bomb more slowly. Although adding a small amount of water before or during grinding of mixtures of carbon, sulfur, and potassium nitrate did not affect the heat of reaction of the product significantly, this may have caused the density of some of the products to be abnormally low. Colloidal silica showed promise of being a useful additive in black powder manufacture. 相似文献
13.
现行的换热网络目标方法,在进行换热网络价格估算时,未考虑热物流的热损失。在真实的设计中,换热器壳体保温后仍与环境温度相差较大,则其热损失不可忽略。文章提出了一个新的基于热损失的换热网络夹点设计法,该方法首先以综合费用最小为目标确定出最小温差,然后建立问题表格确定出夹点位置及最小公用工程消耗,最后再进行换热网络设计。文中采用某石油常减压换热网络系统为典型算例对该方法的前两步进行了分析研究,论证了该方法的必要性及可行性。结果表明:该方法与基本Linnhoff夹点技术法估算的投资费用有较大的差距之外,在一定的最小温差下,其与基本Linnhoff夹点技术法确定的夹点位置不同,公用工程消耗也有较大的差距。 相似文献
14.
15.
16.
Two methods for processing the results of closed-bomb tests of propellants are proposed: a method for determining the force
of propellant, the covolume of propellant gas, and the pressure dependence of the degree of propellant combustion that takes
into account the heat exchange between the combustion products and the walls of the closed bomb; a procedure for determining
the linear behavior of unsteady combustion in the form justified by Ya. B. Zel’dovich. It is shown that accounting for heat
losses is necessary not only to determine the force of propellant and the covolume of propellant gas but also to determine
the combustion behavior.
__________
Translated from Fizika Goreniya i Vzryva, Vol. 42, No. 2, pp. 29–38, March–April, 2006. 相似文献
17.
研究了充氮法测量双基发射药爆热过程中充氮净化次数、充氮压力以及样品用量等因素对爆热值的影响。结果表明,随着氧弹中氮气净化次数的增加,爆热值由大变小并趋于稳定,净化两次以上时,对爆热值的测量不会发生影响;充氮气时,应保证充氮压力大于临界压力,同时控制每次充氮压力值的一致性,当充氮压力大于2.5M Pa时,对爆热值的测量不会发生影响;在确定被测样品实验用量时,应尽可能使样品燃烧后热量计产生的温升值与在热容量标定时标准物质燃烧后产生的温升值相当,样品质量为5.430 g时,爆热值的测量系统误差最小。 相似文献