共查询到17条相似文献,搜索用时 152 毫秒
1.
本文通过利用Markov信源的冗余信息,提出了一种基于系统LDPC码编码器的信源信道联合译码算法(JSCD)。仿真结果显示,当信源中存在更多的冗余信息时,该JSCD算法可相应取得更好的系统性能。 相似文献
2.
该文提出一种基于原模图低密度奇偶校验(P-LDPC)码的分布式联合信源信道编译码系统方案。该方案编码端,分布式信源发送部分信息位及校验位以同时实现压缩及纠错功能;译码端,联合迭代信源信道译码的运用进一步发掘信源的相关性以获得额外的编码增益。此外,论文研究了所提方案在译码端未知相关性系数的译码算法。仿真结果表明,所提出的基于P-LDPC码的分布式联合信源信道编译码方案在外部迭代次数不大的情况可以获得较大的性能增益,并且相关性系数在译码端已知和未知系统性能基本相当。 相似文献
3.
4.
传统的简单级联编码调制系统在译码时会造成软信息损失.提出了一种基于MSK和LT码的联合软迭代译码算法,设计了算法的系统模型.利用LT码的软译码和MSK调制的SISO算法,进行联合软迭代译码,提高了编码调制系统的性能.仿真结果表明:在误码率为10-4时,提出的算法比传统的简单级联编码调制算法约有1.5 dB的编码增益. 相似文献
5.
为克服无线衰落信道中严重的符号间干扰( ISI)的影响,提出了一种新的利用信源冗余的Turbo均衡算法。该算法将联合信源信道译码技术与Turbo均衡技术结合起来,在均衡、译码、信源之间建立起软信息交互的环路,有效提高了整体接收的性能。外信息传递( EXIT)图分析与计算机仿真均表明,尽管信源冗余给译码器带来的性能提升较为有限,但是将这部分信息反馈回均衡器后,在严重ISI信道,信源冗余度为70%时,整体接收的性能改善约为9.5 dB,基本达到了理想加性高斯白噪声( AWGN)信道下的误码性能。 相似文献
6.
为克服无线衰落信道中严重的符号间干扰(ISI)的影响,提出了一种新的利用信源冗余的Turbo均衡算法。该算法将联合信源信道译码技术与Turbo均衡技术结合起来,在均衡、译码、信源之间建立起软信息交互的环路,有效提高了整体接收的性能。外信息传递(EXIT)图分析与计算机仿真均表明,尽管信源冗余给译码器带来的性能提升较为有限,但是将这部分信息反馈回均衡器后,在严重ISI信道,信源冗余度为70%时,整体接收的性能改善约为9.5 dB,基本达到了理想加性高斯白噪声(AWGN)信道下的误码性能。 相似文献
7.
对信源编码中的残留冗余在联合编码中的作用进行了研究,提出了一个在噪声信道中对可变长信源编码码流传输提供有效差错保护的联合信源信道编码方法,该方法利用信源编码器输出中的残留冗余为传输码流提供差错保护。与Sayood K提出的系统相比,该方法是基于改进的联合卷积软解码以及采用非霍夫曼码的通用可变长码,更接近于一般的信源和信道编码方法,并且信源符号集的大小也不受限制。仿真表明,所提出的联合编码方法可获得比传统的分离编码方法更高的性能增益。 相似文献
8.
对信源编码中的残留冗余在联合编码中的作用进行了研究,提出了一个在噪声信道中对可变长信源编码码流传输提供有效差错保护的联合信源信道编码方法,该方法利用信源编码器输出中的残留冗余为传输码流提供差错保护。与SayoodK提出的系统相比,该方法是基于改进的联合卷积软解码以及采用非霍夫曼码的通用可变长码,更接近于一般的信源和信道编码方法,并且信源符号集的大小也不受限制。仿真表明,所提出的联合编码方法可获得比传统的分离编码方法更高的性能增益。 相似文献
9.
10.
光通信中基于BCJR的BCH译码算法研究 总被引:1,自引:1,他引:0
首先从理论上分析了硬判决译码算法和软判决译码算法的性能然后对BCH(Bose,Ray-Chaudhuri,Hocquenghem)码的网格结构以及BCJR(Bahl,Cocke,Jelinek and Raviv)算法进行了详细地分析及推导。实验结果表明,在光信道环境中,在误比特率为10-5时,当仅提高最小汉明距离码率相同或者仅减小码率最小汉明距离相同时,BCJR算法相对于硬判决译码算法的编码增益分别在之前的编码增益基础上又增加了0.15dB和0.25dB。因此设计级联码方案时,应尽可能选择纠错能力较大的内码。此外也可以采用适当增加内码的冗余度相应减小外码的冗余度的方法,在获得更高的编码增益的同时保证整个系统的带宽利用率不变。 相似文献
11.
文中提出一种利用残留冗余的RDPCM信源信道联合编码系统与最小均方误差估计结合的方法.首先,本文针对联合编码系统修正了SOVA算法,在接收端获得利用残留冗余后的比特似然度;然后利用这些后验信息,对信源预测编码器的输出符号值进行最小均方误差重建后再进行信源译码,从而减小了由于硬判决得到符号值所带来的失真.仿真结果显示这种算法在信噪比的低端最大得到了约2dB的增益. 相似文献
12.
Low-complexity iterative joint source-channel decoding for variable-length encoded Markov sources 总被引:1,自引:0,他引:1
In this paper, we present a novel packetized bit-level decoding algorithm for variable-length encoded Markov sources, which calculates reliability information for the decoded bits in the form of a posteriori probabilities (APPs). An interesting feature of the proposed approach is that symbol-based source statistics in the form of the transition probabilities of the Markov source are exploited as a priori information on a bit-level trellis. This method is especially well-suited for long input blocks, since in contrast to other symbol-based APP decoding approaches, the number of trellis states does not depend on the packet length. When additionally the variable-length encoded source data is protected by channel codes, an iterative source-channel decoding scheme can be obtained in the same way as for serially concatenated codes. Furthermore, based on an analysis of the iterative decoder via extrinsic information transfer charts, it can be shown that by using reversible variable-length codes with a free distance of two, in combination with rate-1 channel codes and residual source redundancy, a reliable transmission is possible even for highly corrupted channels. This justifies a new source-channel encoding technique where explicit redundancy for error protection is only added in the source encoder. 相似文献
13.
Iterative source-channel decoding (ISCD) improves the error robustness of a digital communication system by iteratively evaluating natural residual source redundancy and artificial channel coding redundancy in a TURBO-like process. Based on recent results to extrinsic information transfer (EXIT) charts we present a novel (experimental) approach to quantify the minimum terms of residual redundancy which are needed for (almost) successful ISCD. Moreover, we clarify why in certain situations the decoding trajectory exceeds the EXIT-characteristic of soft decision source decoding (SDSD) in an ISCD scheme 相似文献
14.
A constrained joint source/channel coder design 总被引:3,自引:0,他引:3
Sayood K. Fuling Liu Gibson J.D. 《Selected Areas in Communications, IEEE Journal on》1994,12(9):1584-1593
The design of joint source/channel coders in situations where there is residual redundancy at the output of the source coder is examined. It has previously been shown that this residual redundancy can be used to provide error protection without a channel coder. In this paper, this approach is extended to conventional source coder/convolutional coder combinations. A family of nonbinary encoders is developed which more efficiently use the residual redundancy in the source coder output. It is shown through simulation results that the proposed systems outperform conventional source-channel coder pairs with gains of greater than 9 dB in the reconstruction SNR at high probability of error 相似文献
15.
Joint source-channel decoding of variable-length codes for convolutional codes and turbo codes 总被引:2,自引:0,他引:2
Several recent publications have shown that joint source-channel decoding could be a powerful technique to take advantage of residual source redundancy for fixed- and variable-length source codes. This letter gives an in-depth analysis of a low-complexity method recently proposed by Guivarch et al., where the redundancy left by a Huffman encoder is used at a bit level in the channel decoder to improve its performance. Several simulation results are presented, showing for two first-order Markov sources of different sizes that using a priori knowledge of the source statistics yields a significant improvement, either with a Viterbi channel decoder or with a turbo decoder. 相似文献
16.
基于HMM的信源—信道迭代联合译码 总被引:2,自引:0,他引:2
提出一种在接收端利用Turbo译码软输出,结合HMM(隐马尔可夫模型)中的Baum-Welch重估算法获取信源模型参数并进行信源-信道迭代联合译码的算法.通过含噪接收序列信道译码后的软输出对信源模型参数进行估计,并将迭代估计获得的信源精确概率结构和信道译码结合进行信源-信道联合迭代译码.同时从信息论角度提出用鉴别信息来度量估计获得的信源模型参数的精度,以及确定迭代估计终止的条件. 相似文献
17.
《Signal Processing, IEEE Transactions on》2006,54(10):3688-3701
We propose a joint source-channel decoding approach for multidimensional correlated source signals. A Markov random field (MRF) source model is used which exemplarily considers the residual spatial correlations in an image signal after source encoding. Furthermore, the MRF parameters are selected via an analysis based on extrinsic information transfer charts. Due to the link between MRFs and the Gibbs distribution, the resulting soft-input soft-output (SISO) source decoder can be implemented with very low complexity. We prove that the inclusion of a high-rate block code after the quantization stage allows the MRF-based decoder to yield the maximum average extrinsic information. When channel codes are used for additional error protection the MRF-based SISO source decoder can be used as the outer constituent decoder in an iterative source-channel decoding scheme. Considering an example of a simple image transmission system we show that iterative decoding can be successfully employed for recovering the image data, especially when the channel is heavily corrupted. 相似文献