首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到20条相似文献,搜索用时 890 毫秒
1.
本文剖析了二硫化钨润滑剂特点及二硫化钨固体润滑薄膜的润滑机理;分析了纳米二硫化钨颗粒的团聚原因及二硫化钨分散方法,讨论了分散方法对分散效果的影响;重点概述了二硫化钨在润滑油中及其润滑薄膜应用进展,展望二硫化钨未来固体润滑应用前景。  相似文献   

2.
分析流体动压润滑产生的原因以及实现流体动压润滑的条件。以CO2压缩机为例,阐述流体动压润滑在实际生产中的应用、引起流体动压润滑破坏的原因和应注意的问题。  相似文献   

3.
<正>0前言润滑系统是水泥生产的重要环节,是保障水泥生产系统正常运转的关键。但润滑系统的故障时有发生,造成生产中断或设备损坏,严重影响了生产正常运行。以金牛公司出现在水泥磨润滑系统的几次故障为例,分析其原因及处理情况,为更好地预防和处理同类问题提供借鉴。1水泥磨主轴瓦漏油故障原因及措施金牛公司有两台Φ3 m×13 m水泥磨,电机和前  相似文献   

4.
润滑不当是造成辊压机行星减速器齿轮失效的一个重要原因。这类减速器的润滑在设计方面应包括润滑油、润滑系统的设计、润滑系统的维护以及与润滑系统相关的减速器结构的设计。  相似文献   

5.
我厂Φ31m/25m×78m带多筒冷却机的回转窑,一档托轮轴瓦润滑不良,在高温炎热的夏季润滑状况更差。我们认为托轮轴瓦润滑不良的原因主要有以下几点:①油勺带到油槽上的油量太少;②由于一档托轮负荷大,环境温度高,我厂使用的24号饱和汽缸油满足不了润...  相似文献   

6.
介绍了ATOX辊磨磨辊润滑系统及工作原理,并阐述了磨辊润滑系统使用与维护中的注意事项,并分析了一些典型的润滑系统故障原因,给出了故障检查和处理的方法.  相似文献   

7.
常体荣  朱磊  陈盼娣 《广州化工》2011,39(8):116-117,128
油雾润滑技术作为一种先进的机泵润滑方式,有很多优点,其运用的场合与日俱增。分析了机泵轴承易于损坏的主要原因,重点介绍油雾润滑技术、油雾润滑系统的主要组成和原理,还介绍了实际改进方法及其在延安石油化工厂重整加氢装置的成功应用。  相似文献   

8.
润滑平衡     
李杰  刘芳  夏飞 《橡塑助剂信息》2005,(V00):91-103
本文提出由外润滑平衡定义及其定量标准;造成内外润滑失衡的原因  相似文献   

9.
徐大卫 《水泥工程》2015,28(6):55-55
<正>1存在的问题目前国内大多数立磨磨辊轴承采用稀油循环润滑方式,虽循环的油液会快速将磨辊内的大量热量带出,稳定辊内温度,保持润滑良好,但大多数立磨磨辊轴承都存在长时间高温运行的情况。2原因分析(1)立磨磨内工作环境温度一般在100~200℃,  相似文献   

10.
减速器的设计、制造缺陷和辊压机系统的载荷异常是导致辊压机减速齿轮失效的重要原因,润滑不当是导致齿轮失效的另外一个重要原因。为了确保辊压机行星齿轮减速箱(器)润滑的科学性,在对齿轮失效机理研究的基础上,根据实践中取得的有得有失经验,主张选择这样的润滑油:粘度可以低一点,但箱(器)启动时一定要形成最佳的油膜保护;油品性能持久,降低齿面粗糙度(因为齿面粗糙度影响油膜的压力、膜厚和温度,从而影响润滑效果);油品清洁持久。  相似文献   

11.
陈建文 《广东化工》2006,33(6):79-81
乙烯酮(双乙烯酮)是十分重要的化工中间体,其下游产品较多。江苏某化工厂开发生产乙烯酮(双乙烯酮)下游产品三十多个,年生产规模三万多吨,是国内以乙烯酮(双乙烯酮)为中间体生产精细化学品的综合骨干企业。针对乙烯酮(双乙烯酮)下游产品废水特点,该厂结合企业实际,开展了产品优化,结构调整,清洁生产,资源循环利用,节水降耗等工作,从源头削减了污染物的生产。同时投资二千多万元新建预处理装置三套,6000m3/d废水生化处理装置一套,使全厂乙烯酮(双乙烯酮)下游产品的废水得到了有效的治理。  相似文献   

12.
阐述并比较了几种加压设备在乙炔加压清净过程中的性能和特点。  相似文献   

13.
本文通过三个厂家提供的三种煤样燃烧热的测定,由测定结果综合得出3号煤样燃烧最完全、燃烧热也最大,是三个煤样中最好的一种。  相似文献   

14.
A semi-empirical equation of state for metals is described. Its capabilities are demonstrated by the example of the equation of state for aluminum. New experimental data are presented on the location of the isentrope of aluminum for unloading from the state at p = 229.71 GPa on the shock adiabat to an aerogel (SiO2) of density 0.08 g/cm3. __________ Translated from Fizika Goreniya i Vzryva, Vol. 44, No. 2, pp. 61–75, March–April, 2008.  相似文献   

15.
水泥水化热是中、低热水泥和核电工程用水泥的一项关键的技术指标。全球范围内测定水泥水化热的方法有溶解法、直接法/半绝热法、等温传导量热法三种。本文总结了中、美、欧相关方法标准,对其测试原理、仪器设备、试验过程等方面进行了比对,并对其在领域的应用做了简单的概括。  相似文献   

16.
A thermochemical rather simple experimental technique is applied to determine the enthalpy of formation of Diperoxide of ciclohexanone. The study is complemented with suitable theoretical calculations at the semiempirical and ab initio levels. A particular satisfactory agreement between both ways is found for the ab initio calculation at the 6–311G basis This set level. Some possible extensions of the present procedure are pointed out.  相似文献   

17.
论述了涂装工艺设计对涂装设备投资、涂装生产成本的影响。  相似文献   

18.
A perturbation viscometer is a differential capillary viscometer that measures the logarithmic viscosity gradient of the viscosity-composition curve for gas mixtures. Measurements are made at different gas mixture compositions. Integration of the logarithmic viscosity gradients measured over the full composition range gives the mixture viscosity relative to the viscosity of one of the pure components of the gas mixture. This method is attractive because, for measurements of equal precision, integration of the gradients is potentially an order of magnitude more precise than measurement of the viscosities directly. It can also work at high and low temperatures and perhaps high pressures.The perturbation viscometer has been used to make measurements on ideal gas mixtures at ambient and elevated temperatures. The situation is more complicated when the gas mixtures are non-ideal. Extra effects due to density differences, molar volume change on mixing and differential thermal expansion may be measured in addition to the desired viscosity change producing systematic errors in the results. Thus, a more sophisticated apparatus is required. The standard perturbation viscometer has been modified to separate out the extra effects to permit measurement of the true change in viscosity. In addition, the theoretical operation of the modified apparatus has been revised to account for the design changes to permit calculation of the viscosity-composition profiles from the results.The apparatus has been tested using helium-HFC-125 mixtures and two new viscosity-composition profiles are presented for these mixtures at 23 and . Internal consistency tests have been used to confirm that the data produced are of high quality with an estimated uncertainty in the viscosity ratio data at of 0.9% and at of 1.5%.  相似文献   

19.
塔设备改造选型的分析   总被引:2,自引:0,他引:2  
黄洁  张学 《化工设计》1997,7(3):23-27
就当前扩产增容中塔设备设计和改造时板式塔和填料塔的选型问题加以分析。在评述目前国内常用的几种塔板和新型填料之后,着重介绍一种新型塔板(导向梯形浮阀塔板)和一种新型填料(波环填料——乾隆帕克)。  相似文献   

20.
周辉  李灵  娄伦武 《化肥工业》2013,40(4):36-38
气化给煤装置自投运以来,出现了气化煤仓堵煤、称重给煤机输送皮带因跑偏而损伤以及清扫装置故障频繁等问题,多次造成气化系统减负荷运行。通过对出现的各种问题进行分析,找到了产生这些问题的原因,并有针对性地采用配煤和改进清扫链等措施,使出现的问题得到了极大的改善。  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号