一种改进的网络控制系统控制器设计方法

讨论网络控制系统的状态反馈控制器设计问题。针对具有未知时变时延的网络控制系统,应用自由权矩阵方法得到系统的稳定性条件,并应用到具有时变结构不确定性的网络控制系统,在此基础上提出状态反馈控制器设计方法。数值实例表明该方法的有效性,与已有方法相比,具有较低的保守性。     

不确定时延网络控制系统的保性能控制

在工程实际网络控制系统中,不仅要求系统能够保持稳定,还要系统具有一定的性能指标,采用状态反馈控制是一种非常有效的控制方式。针对一类线性不确定时延网络控制系统,研究了在有记忆状态反馈控制器下的保性能控制问题。利用Lyapunov函数和线性矩阵不等式的方法,给出了网络控制系统保性能控制律存在的条件和相应的状态反馈控制器的设计方法。最后,通过Matlab数值仿真算例验证了该方法的有效性和正确性。     

时延丢包网络控制系统的分析与控制

针对网络控制系统中同时存在时延和丢包问题,基于零阶保持器的工作机制,将同时受时延和丢包影响的网络控制系统建模为输入带有时延的控制系统,根据李雅普诺夫稳定性理论和时滞系统理论得出控制系统的时滞相关稳定性条件,进一步基于锥补线性化的方法给出控制器的设计方法,有效解决了网络控制系统中同时存在时延和丢包的控制问题。仿真算例表明所提方法的有效性。     

MIMO网络控制系统的建模与分析

针对网络只存在于传感器节点与控制器节点之间的多输入多输出(MIMO)网络控制系统,研究了系统建模和稳定性问题.设传感器节点和控制器节点均为时间驱动,且它们的采样存在着固定的时间差,网络诱导时延的上界大于一个采样周期,建立了此类网络控制系统的模型.基于Lyapunov函数和线性矩阵不等式(LMIs)方法,给出了闭环系统渐近稳定的充分条件.仿真表明本文的方法是有效的.     

具有快变时延和丢包的网络控制系统镇定

对一类网络控制系统,研究了变时延和数据丢包对闭环系统稳定性的影响.基于Lyapunov-Krasovskii方法,给出了闭环系统的稳定条件,该条件不依赖于时延变化率的上界.通过求解一个适当的线性矩阵不等式(LMI)得到控制增益矩阵,求解时不需要对矩阵的结构进行限制,也不必使用重复迭代.最后,给出了一个数值例子以说明方法的有效性.     

具有随机丢包的网络控制系统的镇定

研究具有随机丢包的网络控制系统(NCS)的镇定问题.同时考虑传感器节点到控制器节点(S/C)和控制器节点到执行器节点(C/A)的随机丢包,并分别对这两种丢包现象建模.基于Lyapunov稳定性理论,得到闭环系统全局均方渐近稳定的充分条件.进一步利用线性矩阵不等式(LMI)方法,得到状态反馈控制律的增益矩阵.数值仿真算例验证了所得结果的有效性.     

不确定时滞网络控制系统的非脆弱控制器设计

研究了具有状态时滞的不确定网络控制系统的鲁棒非脆弱控制器设计问题。基于Lyapunov稳定性理论,给出使系统的状态反馈非脆弱控制器,并以线性矩阵不等式形式给出了系统的渐进稳定的充分条件,所得条件可以通过Matlab十分方便求解。     

时滞网络控制系统的鲁棒稳定性条件

本文研究了时滞网络控制系统的鲁棒稳定性问题，并用向量Lyapunov方法给出了保证系统稳定的线性矩阵不等式条件。本文的结果均是在子系统水平上的，仿真结果表明了本文所提出的结果的有效性。     

具有随机丢包的线性网络控制系统控制器设计

研究一类双向通道里同时存在随机数据包丢失的线性网络控制系统的控制器设计问题,随机数据包丢失同时存在于传感器-控制器和控制器-执行器网络通道里,随机数据包丢失采用满足Bernoulli分布的二进制切换序列来描述.在发生随机数据包丢失时,可采用闭环系统均方指数稳定的动态输出反馈控制器存在的充分性判据,并给出了基于线性矩阵不等式(LMI)的控制器求解方法,并通过一个仿真算例验证了控制器的正确性.     

参数不确定的网络控制系统控制器设计

针对一类具有不确定参数的被控对象模型,考虑长时延有界及数据丢包的情况,建立网络控制系统闭环模型.在所提模型的基础上,用线性矩阵不等式的形式给出了系统渐近稳定的状态反馈控制器的设计方法.仿真结果验证了本文方法的有效性.     

一类基于观测器的非线性网络化控制系统的绝对稳定性

主要考虑了基于观测器的Lurie网络化控制系统的绝对稳定性问题. 由于采用了基于观测器的反馈控制器, 传感器到控制器的网络诱导时延和控制器到执行器的网络诱导时延不再能合并到一起处理. 首先通过状态增广方法将Lurie网络化控制系统建模为一个多时滞的Lurie系统, 然后利用Newton-Leibniz公式和添加自由权矩阵的方法给出了时滞依赖的稳定性条件. 在此基础上, 给出三种求解控制器和观测器增益矩阵的方法. 此外, 还分别给出了被控对象存在范数有界不确定性和结构不确定性时系统的鲁棒稳定性条件及鲁棒控制器设计方法, 所有得到的结果都是以线性矩阵不等式的形式给出的. 便于利用线性矩阵不等式工具包进行求解. 最后, 通过两个仿真算例说明了方法的可行性和有效性.     

A Switched System Approach to Robust Stabilization of Networked Control Systems with Multiple Packet Transmission

This paper considers robust stabilization of networked control systems (NCSs) with the problem of multiple packet transmission. Two parts of uncertainties are considered in this paper: norm‐bounded parameter uncertainties in the plant, and norm‐bounded parameter uncertainties in the controller. For sensor nodes and actuator nodes communicating through a limited communication channel, we are particularly interested in the case that only one packet containing part of the state information can be transmitted through a toking‐bus every time. Stability of the NCSs with multiple packet transmitted in a periodic manner is closely related to that of periodically switched systems. For NCSs with and without uncertainties in the plant and the controller, stabilizing state feedback controllers are constructed in terms of linear matrix inequalities (LMIs). Numerical examples are given to illustrate the feasibility and effectiveness of the proposed approach.     

H_∞ Controller Design for Networked Control Systems via Active-varying Sampling Period Method

This paper studies the problem of designing H_∞controllers for networked control systems (NCSs) with both network-induced time delay and packet dropout by using an active-varying sampling period method,where the sampling pe- riod switches in a finite set.A novel linear estimation-based method is proposed to compensate packet dropout,and H_∞controller design is also presented by using the multi-objective optimization methodology.The simulation results illustrate the effectiveness of the active-varying sampling period method and the linear estimation-based packet dropout compensation.     

基于主动变采样周期方法的网络控制系统的H∞控制器设计

利用主动变采样周期方法, 本文研究了具有时延及丢包的网络控制系统的 H∞ 控制器设计问题, 其中采样周期在一个有限集合内切换. 提出了一个新的线性估计方法以补偿丢包的负面影响, 并利用多目标优化方法设计系统的 H∞ 控制器. 仿真结果表明了主动变采样周期方法及基于线性估计的丢包补偿方法的有效性.     

基于主动变采样周期方法的网络控制系统的H∞控制器设计

This paper studies the problem of designing H∞ controllers for networked control systems (NCSs) with both network-induced time delay and packet dropout by using an active-varying sampling period method, where the sampling period switches in a finite set. A novel linear estimation-based method is proposed to compensate packet dropout, and H∞ controller design is also presented by using the multi-objective optimization methodology. The simulation results illustrate the effectiveness of the active-varying sampling period method and the linear estimation-based packet dropout compensation.     

状态时滞的网络控制系统的保成本控制器设计

针对一类含状态时滞的网络控制系统,本文对此进行了状态反馈保成本控制器设计.在考虑网络引起的滞后的基础上,一个新的模型提出来了.保成本控制器的存在性也通过一系列线形矩阵不等式表达出来.一个能把非凸问题转换成凸问题的方法同时应用了.与此同时,相应的能获取最低性能指标的算法也已给出.配套的仿真例子证明了此算法的有效性.     

网络控制系统的状态反馈保成本控制器设计

This paper is concerned with the state-feedback guaranteed cost controller design for a class of networked control systems (NCSs) with state-delay. A new model of the NCSs is provided under consideration of the network-induced delay. A sufficient condition for the existence of a guaranteed cost controller for NCSs is presented by a set of linear matrix inequalities(LMIs). A method, which can transform non-convex to the convex, is applied. Accordingly, a numerical algorithm is proposed to obtain the lower bound. Theoretical analysis through an example shows the effectiveness of the method.     

一类带有时延的非线性网络控制系统可靠模糊控制

研究了带有状态时延及执行器故障的非线性网络控制系统的可靠模糊控制问题. 利用输入时延方法, 将带有网络诱导时延和数据包丢失的非线性网络控制系统等价的转化为具有时变时延的Takagi-Sugeno(T-S)模糊系统. 时延对象的状态信息, 采用时滞分解方法, 得以充分的考虑. 并利用锥补线性化迭代算法, 将非凸的稳定性条件转化成可行的线性矩阵不等式(LMI)的形式. 文中将更紧的界处理方法(相互凸组合技术)与不相关增广矩阵项引入到Lyapunov函数的处理当中, 获得保守性更小的稳定性条件. 数值算例验证了该方法的有效性.     

Output tracking control for networked control systems with time delay and packet dropout

This article studies the problems of H _∞ output tracking performance analysis and controller design for networked control systems (NCSs) with time delay and packet dropout. By using linear matrix inequality (LMI)-based method, H _∞ output tracking performance analysis and controller design are presented for NCSs with constant sampling period. For NCSs with time-varying sampling period, a multi-objective optimisation methodology in terms of LMIs is used to deal with H _∞ output tracking performance analysis and controller design. The designed controllers can guarantee asymptotic tracking of prescribed reference outputs while rejecting disturbances. The simulation results illustrate the effectiveness of the proposed H _∞ output tracking controller design.     

Term and variable selection for non-linear system identification

The purpose of variable selection is to pre-select a subset consisting of the significant variables or to eliminate the redundant variables from all the candidate variables of a system under study prior to model term detection. It is required that the selected significant variables alone should sufficiently represent the system. Generally, not all the model terms, which are produced by combining different variables, make an equal contribution to the system output and terms, which make little contribution, can be omitted. A parsimonious representation, which contains only the significant terms, can often be obtained without the loss of representational accuracy by eliminating the redundant terms. Based on these observations, a new variable and term selection algorithm is proposed in this paper. The term detection algorithm can be applied to the general class of non-linear modelling problems which can be expressed as a linear-in-the-parameters form. The variable selection procedure is based on locally linear and cross-bilinear models, which are used together with the forward orthogonal least squares (OLS) and error reduction ratio (ERR) approach to determine the significant terms and to pre-select the important variables for both time series and input–output systems. Several numerical examples are provided to illustrate the applicability and effectiveness of the new approach.