共查询到19条相似文献,搜索用时 140 毫秒
1.
研究了高速电路领域中的一类重要的电源完整性问题,即电源地平面之间激发的地弹噪声问题。地
弹噪声的存在严重破坏了电源/ 地平面的完整性,导致供电电压幅度的不稳定,严重之时甚至导致电路的误判。针
对这一问题,设计了一种超宽带电磁带隙结构。实验结果表明,这种电磁带隙结构可以在0. 5 ~5. 5GHz(11 倍频程)
频段内实现优于30dB 的噪声抑制能力。文章还探讨了带隙结构作为电源平面时信号传输的完整性。研究表明,如
果电路工作频率高达GHz 或更高,在电源/ 地平面采用这种带隙结构,可以有效地避免地弹噪声带来的影响,并保证
电源和信号的完整性。 相似文献
2.
3.
在高速数字设计中,时钟频率的越来越高,同时芯片的规模也越来越大,以致电路的功耗越来越大,而供电电压却越来越低,由此导致信号完整性问题和电源完整性问题,正是高速电路设计中要解决的最重要问题。简要分析了高速电路设计中的电源完整性问题,介绍了利用EDA工具cadence中的Allegro PCB PI进行电源完整性分析和设计流程,并应用于工程实践,性能取得了明显改善。结合设计实例对此进行了说明和分析。 相似文献
4.
面向微波毫米波低噪声放大电路对高性能低噪声放大器件的需求,进行0. 15 μm 栅长GaAs PHEMT低噪声器件制备工艺的开发,在制备工艺中采用了欧姆特性优异的复合帽层欧姆接触、低寄生电容的介质空洞栅结构以及高击穿电压的双槽结构。在此基础上实现了一款性能优异的Ku 波段低噪声放大电路,电路在Ku 频段全频带(14 ~18 GHz)内实现了优良的性能,其噪声系数小于1. 3 dB,增益大于17 dB。电路采用5 V 电源供电,功耗为250 mW,芯片面积为2 mm×1. 6 mm;这款性能优异的Ku 频段低噪声放大器特别适用于高信噪比要求的卫星通信等应用。 相似文献
5.
6.
7.
8.
9.
描述了一种能运用于未来光传输系统SONET OC-768的超高速1∶4静态分频器,其工作频率超过27GHz.该电路采用栅长为0.2μm,截止频率约为60GHz的砷化镓赝晶高电子迁移率晶体管工艺制作,采用共面波导作为电感实现了宽带阻抗匹配.通过采用推拉式有源跟随器,在没有增加功耗的情况下拓宽了频带.单端输入和差分信号输出的方式,为实际应用提供了便利.通过晶圆测试,在单端时钟输入的情况下,芯片的最高工作频率超过27GHz.测试所得到的波形均方根抖动小于820fs.芯片的面积是1.6mm×0.5mm,功耗为440mW. 相似文献
10.
描述了一种能运用于未来光传输系统SONETOC768的超高速1∶4静态分频器,其工作频率超过27GHz.该电路采用栅长为0.2μm,截止频率约为60GHz的砷化镓赝晶高电子迁移率晶体管工艺制作,采用共面波导作为电感实现了宽带阻抗匹配.通过采用推拉式有源跟随器,在没有增加功耗的情况下拓宽了频带.单端输入和差分信号输出的方式,为实际应用提供了便利.通过晶圆测试,在单端时钟输入的情况下,芯片的最高工作频率超过27GHz.测试所得到的波形均方根抖动小于820fs.芯片的面积是1.6mm×0.5mm,功耗为440mW. 相似文献
11.
To supply a power distribution network with stable power in a high‐speed mixed mode system, simultaneous switching noise caused at the multilayer PCB and package structures needs to be sufficiently suppressed. The uniplanar compact electromagnetic bandgap (UC‐EBG) structure is well known as a promising solution to suppress the power noise and isolate noise‐sensitive analog/RF circuits from a noisy digital circuit. However, a typical UC‐EBG structure has several severe problems, such as a limitation in the stop band's lower cutoff frequency and signal quality degradation. To make up for the defects of a conventional EBG structure, a partially located EBG structure with decoupling capacitors is proposed in this paper as a means of both suppressing the power noise propagation and minimizing the effects of the perforated reference plane on the signal quality. The proposed structure is validated and investigated through simulation and measurement in both frequency and time domains. 相似文献
12.
13.
Shamim A. Arsalan M. Roy L. Shams M. Tarr G. 《Circuits and Systems II: Express Briefs, IEEE Transactions on》2008,55(7):643-647
14.
Yong-Duck Chung Kwang-Seong Choi Jae-Sik Sim Hyun-Kyu Yu Jeha Kim 《Lightwave Technology, Journal of》2007,25(11):3407-3412
We developed an analog optical system-on-package (SoP) transmitter for a 60-GHz-band radio-over-fiber (RoF) link. The SoP transmitter consisted of an electroabsorption modulator, radio frequency amplifiers, and a bandpass filter. The 60-GHz RoF wireless link was prepared to measure the performance of the SoP transmitter. The transmission characteristics of 64-quadrature amplitude modulation (64-QAM) data of the 60-GHz RoF wireless link, including the SoP transmitter, were investigated by measuring the error vector magnitude (EVM) and signal-to-noise ratio (SNR) with a baseband frequency. The EVM of the 60-GHz RoF wireless link was between 2.25% and 2.80%, and the SNR was between 27.36 and 29.31 dB from 140 and 770 MHz, at input baseband power of -9 dBm. The noise figure had the minimum of 8.44 dB at 500 MHz. We successfully transmitted digital community antenna television (CATV) system signals through the 60-GHz RoF wireless link, including the SoP transmitter. Digital CATV signals of 86 channels could be transmitted through the 60-GHz RoF wireless link, and the total throughput was found to be 2.61 Gb/s. 相似文献
15.
16.
系统级封装(System in Package,SiP)已经成为重要的先进封装和系统集成技术,是未来电子产品小型化和多功能化的重要技术路线,在微电子和电子制造领域具有广阔的应用市场和发展前景,发展也极为迅速。对目前SiP技术的研究现状和发展趋势进行了综述,重点关注了国际上半导体产业和重要的研究机构在SiP技术领域的研究和开发,对我国SiP技术的发展做了简单的回顾和展望。 相似文献
17.
In this paper, we summarize and analyze main challenges towards system-on-package (SoP) integration with a broad perspective from system design to technology development. We see that the future SoP faces a main challenge of changed system architecture that will be different from today’s personal computer or PC-based systems. It is likely that communication-network based system architectures will be interesting to future SoP platforms. Second, we find that a major paradigm shift will occur in design methodology for SoP integration that emphasizes a coherent co-design of chip, package and system in a mixed signal environment and in combination with new issues such as virtual components integration. On the technology side, the major challenges will be power dissipation and system cooling, low-cost and thermal-matched high-density interconnect substrates, as well as low-cost passive components integration. Finally, we present some research examples that aim to cope with these new challenges on a strategic basis. 相似文献
18.
哪种方式更能提高LST的附加值?是SiP(system in a package)还是SoC(system on a chip)?LSI厂家正对此进行激烈争论。作为系统集成的选择方式,LSI厂家一直集中力量致力于SoC的开发。但是LSI厂家发现,仅靠SoC这一条路线已不能满足用户的要求。目前,对于各大LSI厂家来说,要不要转换其发展资源的投入方向,需要当机立断。 相似文献
19.
A method and a novel circuitry for intra- and inter-chip temperature measurement in a system in a package (SiP) module is presented. The proposed built-in self-test (BiST) system for the SiP module features a newly proposed digital frequency analyser (DFA) that can be used to efficiently discern clock period differences of up to 1 ns. The full digital interface of the DFA enables power and area efficient temperature measurements in an SiP. 相似文献