共查询到20条相似文献,搜索用时 62 毫秒
1.
我公司年产水泥100万t,有4台Φ3m×9m和2台Φ2.2m×6.5m水泥磨。Φ3m×9m水泥磨的质量指标为80μm筛筛余≤3.0%(复合硅酸盐水泥)和≤2.5%(普通硅酸盐水泥),配套Φ3.0m的旋风式选粉机,目前台时产量稳定在32.5~33.5t/h之间。本文介绍成品细度、出磨细度、回粉细度值等对Φ3m×9m水泥磨生产的影响。1生产状况1997~1999年,由于受原生料生产的影响,我们把水泥磨出磨细度定为80μm筛筛余为35%,而实际生产在34%~40%之间,表1是3号水泥磨这几年的生产参数概况。从表1可… 相似文献
2.
1公司生产概况我公司拥有5台机立窑生产线和1条1000t/d的新型干法回转窑生产线,设计生产能力为70万t;水泥粉磨系统主要有1台Φ2.2m×6.5m带离心式选粉机的闭路磨(以下简称5号磨),1台Φ3m×11m带O-Sepa-1000N型高效选粉机的闭路磨(以下简称6号磨)和1台Φ3m×11m磨内选粉的开路磨(以下简称7号磨)。其中5号磨台时产量一般为15t/h,6号磨台时产量为45t/h,7号磨台时产量为35t/h。在水泥生产控制过程中,我们习惯于通过稳定熟料、混合材的质量以及入磨物料的搭配等方面来提高水泥的稳… 相似文献
3.
水泥磨电磁脉冲助磨试验 总被引:2,自引:0,他引:2
华新南通水泥有限公司水泥粉磨系统采用二级闭路循环工艺,前级预粉磨由德国KHD公司1.2m×1.05m辊压机和该公司的VS静态选粉机完成,二级粉磨由唐山水泥机械厂生产的3.8m×11m单仓水泥磨(平均球径为30mm)和KHD公司的SKS高效选粉机完成,原料为湖北华新旋窑熟料。该系统设计生产能力为100t/h(42.5级普通水泥),成品比表面积为360m2/kg,0.080mm方孔筛筛余控制在3%以内,现实际生产42.5级水泥时台时产量为106t/h(粉煤灰加入量5.7%),0.080mm方孔筛筛余为0.8%,比表面… 相似文献
4.
1系统简介我公司采用2台Φ3.0m×11m和1台Φ2.4m×8m闭路水泥粉磨生产线。2001年,公司将2条600t/d预热器窑改造为1100t/d预分解窑后,原水泥粉磨系统生产能力明显不足。为此,新增1条Φ3m×11m挤压联合粉磨水泥生产线。工艺流程见图1。系统主要设备配置见表1。图1水泥挤压联合粉磨系统工艺流程示意表1水泥粉磨系统主要设备配置设备名称规格型号备注胶带输送机B650×11.5m130t/h,10kW交叉带式除铁器MC12-8090L冷态消耗功率:2.6kW稳流称重仓2500mm×2500mm22m3辊… 相似文献
5.
立波尔窑技术改造情况介绍赵广耀河南省平顶山水泥厂(467047)1概况平顶山水泥厂是由1台Φ4.0×60m的立波尔窑和2台Φ3.0×9m带选粉机的生料磨、2台Φ3.0×9m带选粉机的水泥磨组成的半干法水泥生产厂,1982年投产。原设计年产熟料25.5... 相似文献
6.
Φ2.2m×6.5m水泥粉磨系统的改造 总被引:2,自引:0,他引:2
王岘水泥厂是300t/d熟料的水泥厂,水泥粉磨系统由Φ2.2m×6.5m球磨机及Φ3.5m离心式选粉机组成。多年来,水泥磨产量一直未达到设计能力,始终在11.0t/h左右。加之该厂已于1999年7月完成了Φ2.8m/2.5m×42m五级旋风预热器回转窑的改造,窑产量从原来的7~9t/h提高到现在年平均10.5t/h。此时水泥磨的产量更显不足,该厂于2000年11月委托我院对粉磨系统进行改造设计。1改造方案1.1降低入磨物料粒度该厂水泥熟料冷却使用Φ2.2m×24.0m单筒冷却机。冷却效果不好,温度在180℃以上… 相似文献
7.
放宽我厂湿法棒球磨生料细度的探讨张乃鸿贵州省六盘水市水城水泥厂(553027)我厂生产规模为年产水泥80万t,主机设备为Φ3.5m×145m的华新窑3台;Φ2.4m×13m的湿法开路棒球磨4台;Φ3.0m×9.0m的闭路水泥磨4台等。生产方法为湿法。... 相似文献
8.
重庆市某水泥厂有1条年产10万t水泥机立窑生产线,生料磨是1台Φ2.4m×7m球磨机,设计能力26t/h,磨机转速20.7r/min,主电动机型号JRQ1512-8,功率475kW,设计研磨体装载量38t,系统配有Φ4.0m离心式选粉机、PPCS564-4气箱脉冲袋式除尘器及离心通风机构成闭路粉磨系统。为了确保出磨生料水分,磨头设计有Φ1.5m×1.0m的悬臂烘干仓,配有高温沸腾炉供热烘干系统。该系统自1997年投产以来,台时产量一般稳定在26~29t/h,达到设计能力,生料磨电耗22kWh/t以上。为了提高生料磨台时… 相似文献
9.
我公司1号水泥粉磨系统是由Φ3.8m×12m球磨机(设计生产能力55t/h)、NBH450C×34600mm斗式提升机(日本·椿本)、PPDC96-8气箱脉冲袋除尘器和Φ4.0m旋风式选粉机等组成的圈流生产工艺流程,1995年投产。初期,因水泥磨产量只有40~45t/h,除尘器能够正常运行。随着水泥磨台时产量的提高(1999年产量达80t/h),除尘器不能达标排放。1技术参数气箱脉冲袋除尘器主要技术参数见表1。表1气箱脉冲袋除尘器主要技术参数处理风量/(m3/h)53510总过滤面积/m2744滤袋直径/mmΦ13… 相似文献
10.
我公司现有1台带五级旋风预热器干法回转窑,规格为Φ2.5m×44m,台时产量13.5~14t/h,运转率92%以上。2台Φ2.2m×6.5m闭路水泥磨,配NHX600双转子式选粉机,随着烧成系统能力的提高,水泥磨已不能满足生产需要。主要矛盾是进料粒度大、产量低及细度不理想。为解决以上难题,公司经多方考察、论证,于2000年底选用ZMJ900型柱磨机作预粉磨,使用至今,取得了良好效果。1柱磨机工作原理柱磨机结构示意见图1。当物料从进料口加入后,由撒料盘均匀撒入内筒,自由下落到滚轮和衬板之间的间隔中,由主轴… 相似文献
11.
M. Rosario Rodríguez Niño Cecilio Carrera Sánchez Marta Cejudo Fernández Juan M. Rodríguez Patino 《Journal of the American Oil Chemists' Society》2001,78(9):873-879
The surface activity of β-casein, caseinate, and a whey protein isolate in aqueous solutions has been investigated over a
range of protein concentrations (1·10−5 to 5% w/w) at pH 5 and 7. The surface pressure data were determined by the Wilhelmy plate method. Surface pressure data at
low protein concentration indicate a low surface activity that rises to a plateau as the monolayer is saturated at higher
protein concentrations. The protein concentration and the surface pressure at the plateau depend on the pH and the type of
protein in the aqueous phase. Protein-monoglyceride interactions were investigated by spreading an insoluble monoglyceride
(monopalmitin, monoolein, or monolaurin) on a film of protein previously adsorbed on the interface at equilibrium. The existence
of protein-monoglyceride interactions depends on the interfacial composition and on the protein/monoglyceride ratio. The surface
activity of mixed protein-monopalmitin and protein-monoolein films is determined by the lipid as the surface pressure of the
mixed film is the same as the monoglyceride equilibrium spreading pressure, and the monolayer is not saturated by the protein.
However, the protein determines the surface activity of mixed protein-monopalmitin and protein-monoolein films as the protein
saturates the monolayer. For protein and monolaurin mixed films, protein determines the surface activity over the range of
protein-monolaurin compositions due to monolaurin dissolution in the bulk aqueous phase. 相似文献
12.
13.
This paper addresses the “pressure gap” between traditional surface science experiments and catalysis under practical conditions.
We review high-pressure, microflow experiments at elevated temperatures during the catalytic oxidation of CO. Using a specially
constructed “Reactor-STM” we simultaneously determine the surface structure of a model catalyst by scanning tunneling microscopy
and the reaction kinetics by online mass spectrometry. For both Pt(110) and Pd(100) we find that under O2-rich conditions surface oxides are formed on the otherwise metallic surfaces. The presence of the oxide is correlated with
a superior catalytic activity. Whereas the reaction on the metal surfaces shows traditional Langmuir–Hinshelwood kinetics,
the reaction on the oxides follows the Mars-Van Krevelen oxidation–reduction mechanism, as we conclude from the reaction kinetics
and the reaction-induced roughening of the surface. We emphasize that in addition to a pressure gap there can also be a temperature
gap, requiring experiments to be performed not only at high pressures but also at sufficiently high temperatures. 相似文献
14.
15.
16.
17.
18.
19.
20.
《国际聚合物材料杂志》2012,61(1-2):31-47
Abstract New phosphorous and chlorine containing oligomeric and polymeric products are synthesized and their potential as inhibitors of burning for polymeric materials demonstrated. 相似文献