室内MIMO无线信道模型和信道容量研究

本文从工程的实际出发,首先提出一种修正的室内MIMO无线信道模型,该模型有效地修正先前室内MIMO无线信道模型的不足,具有明显吻合室内实际通信环境的特点,然后分析天线方向性以及天线单元间的互耦对室内MIMO无线信道容量的影响.数值模拟验证了这种影响,并得到在一定条件下互耦导致的天线方向图畸变产生角度分集,提高信道容量,互耦对空域相关性无影响的条件以及室内丰富的多径使天线方向性对信道容量的影响不明显等结论.最后,实验也证实理论分析.     

Exact capacity distribution for dual MIMO systems in Ricean fading

It is well known that multiple input multiple output (MIMO) systems offer the promise of achieving very high spectrum efficiencies (many tens of bit/s/Hz) in a mobile environment. The gains in MIMO capacity are sensitive to the type of channel encountered in the radio environment. To date most analytical work has concentrated on Rayleigh fading channels. Hence, in this letter we consider the capacity outage performance of MIMO systems in Ricean channels. Due to analytical complexity we concentrate on dual antenna systems (either two transmit or two receive antennas) and derive exact densities and distribution functions for the capacity.     

Channel capacity of MIMO architecture using the exponentialcorrelation matrix

Multiple-input multiple output (MIMO) communication architecture has recently emerged as a new paradigm for wireless communications in rich multipath environment, which has spectral efficiencies far beyond those offered by conventional techniques. The channel capacity of the MIMO architecture in independent Rayleigh channels scales linearly as the number of antennas. However, the correlation of a real-world wireless channel may result in a substantial degradation of the MIMO architecture performance. In this letter, we investigate the MIMO channel capacity in correlated channels using the exponential correlation matrix model. We prove that, for this model, an increase in correlation is equivalent to a decrease in signal-to-noise ratio (SNR). For example, r=0.7 is the same as 3-dB decrease in SNR     

Some remarkable properties of diagonally correlated MIMO channels

This paper investigates so-called diagonally correlated multiple input-multiple output (MIMO) channels, which provide higher ergodic capacity than independent and identically distributed (i.i.d.) fading channels. The presented analysis details physical scenarios leading to such channels, some properties of the channel matrix, and an analytical expression for its ergodic capacity.     

Simulation Models for Investigation of Multiuser Scheduling in MIMO Broadcast Channels

Spatial correlation is a result of insufficient antenna spacing among multiple antenna elements, while temporal correlation is caused by Doppler spread. This paper compares the effect of spatial and temporal correlation in order to investigate the performance of multiuser scheduling algorithms in multiple‐input multiple‐output (MIMO) broadcast channels. This comparison includes the effect on the ergodic capacity, on fairness among users, and on the sum‐rate capacity of a multiuser scheduling algorithm utilizing statistical channel state information in spatio‐temporally correlated MIMO broadcast channels. Numerical results demonstrate that temporal correlation is more meaningful than spatial correlation in view of the multiuser scheduling algorithm in MIMO broadcast channels. Indeed, the multiuser scheduling algorithm can reduce the effect of the Doppler spread if it exploits the information of temporal correlation appropriately. However, the effect of spatial correlation can be minimized if the antenna spacing is sufficient in rich scattering MIMO channels regardless of the multiuser scheduling algorithm used.     

An analytical comparison of partial power-feedback designs for MIMO block fading channels

It has been shown that with perfect feedback (CSIT), the optimal multiple input/multiple output (MIMO) transmission strategy is a cascade of channel encoder banks, power control matrix, and eigen-beamforming matrix. However, the feedback capacity requirement for perfect CSIT is 2n/sub T//spl times/n/sub R/, which is not scalable with respect to n/sub T/ or n/sub R/. In this letter, we shall compare the performance of two levels of partial power-feedback strategies, namely, the scalar symmetric feedback and the vector feedback, for MIMO block fading channels. Unlike quasi-static fading, variable rate encoding is not needed for block fading channels to achieve the optimal channel capacity.     

Simplified transmitter design for MIMO systems with channel uncertainty

This article investigates transmitter design in Rayleigh fading multiple input multiple output (MIMO) channels with spatial correlation when there are channel uncertainties caused by a combined effect of channel estimation error and limited feedback. To overcome the high computational complexity of the optimal transmit power allocation, a simple and suboptimal allocation is proposed by exploiting the transmission constraint and differentiating a bound based on Jensen inequality on the channel capacity. The simulation results show that the mutual information corresponding to the proposed power allocation closely approaches the channel capacity corresponding to the optimal one and meanwhile the computational complexity is greatly reduced.     

Characteristic‐Function‐Based Analysis of MIMO Systems Applying Macroscopic Selection Diversity in Mobile Communications

Multiple‐input multiple‐output (MIMO) systems can provide significant increments in capacity; however, the capacity of MIMO systems degrades severely when spatial correlation among multipath channels is present. This paper demonstrates that the influence of shadowing on the channel capacity is more substantial than that of multipath fading; therefore, the shadowing effect is actually the dominant impairment. To overcome the composite fading effects, we propose combining macroscopic selection diversity (MSD) schemes with MIMO technology. To analyze the system performance, the capacity outage expression of MIMO‐based MSD (MSD‐MIMO) systems using a characteristic function is applied. The analytic results show that there are significant improvements when MSD schemes are applied, even for the two‐base‐station diversity case. It is also observed that the effect of spatial correlation due to multipath fading is almost negligible when multiple base stations cooperatively participate in the mobile communication topology.     

Ergodic channel capacity of the spatial correlated rayleigh MIMO channel

The theoretical capacity of the spatial correlated Rayleigh multiple input multiple output (MIMO) channel is an important issue in MIMO technology. In this article, an ergodic channel capacity formula of the spatial correlated rayleigh MIMO channel is provided, which is deduced when two antennas exist at either the transmitter or the receiver. The multi-dimensional least-squares fit algorithm is employed to narrow the difference between the theoretical formula capacity and the practical capacity. Simulation results show that the theoretical capacity approaches the practical one closely.     

Capacity of MIMO channels in the presence of co‐channel interference

This paper presents analytical results on the capacity of multiple‐input‐multiple‐output (MIMO) fading channels in the presence of co‐channel interference (CCI). We consider the scenario in which the desired and CCI users are all subject to Rayleigh fading. We assume that channel realizations of both the desired and CCI users are known at the receiver. Moreover, we consider the case where the transmitter does not have any CSI and as such equal‐power allocation among transmit antennas is used. Given this setup, we derive the moment generating function (MGF) and the mean of the mutual information (MI). We then study the complementary cumulative distribution function of the MI using a Gaussian approximation. Finally, we present and discuss numerical examples to illustrate the mathematical formalism and to show the effect of various parameters on the capacity of MIMO channels in the presence of CCI. Copyright © 2006 John Wiley & Sons, Ltd.     

Experimental Evaluation of MIMO Capacity and Correlation for Narrowband Body-Centric Wireless Channels

Using multiple antennas at the transmitter and receiver has shown a remarkable scope for capacity increase for indoor wireless mobile and PAN communications and is here extended to on-body channels. The capacity and multiple-input multiple-output (MIMO) channel correlation analysis has been performed at 2.45 GHz frequency using planar Inverted-F antennas (PIFA) for three on-body channels. The improvement offered by 2 $,times,$2 MIMO over the conventional single-input single-output link for the on-body channels has been discussed. The variation of capacity with Rician ${rm K}$-factor is shown and the MIMO channel spatial correlation matrices are presented. The effect of correlation on the channel capacity is discussed.      

Relaying Schemes Using Matrix Triangularization for MIMO Wireless Networks

Multiple input multiple output (MIMO) relay networks are wireless communication systems comprising of multiple nodes, each of which is equipped with multiple antennas. Information theories have shown that using multiple nodes to simultaneously relay a message can improve the capacity of source-to-destination communications. In this paper, we propose new relaying schemes for MIMO relay networks. The major concept behind the proposed schemes is to transform each of the MIMO relay channels into an equivalent triangular channel with positive real diagonal entries. By doing so, the resultant MIMO relay channel can simultaneously offer both distributed array gain (diversity gain obtained among relay nodes) and intranode array gain (diversity gain realized by multiple antennas of individual relay node) while maintaining the maximum spatial multiplexing gain (number of parallel data pipes). Based on this concept, three relaying schemes are derived that perform QR decomposition and phase control. Numerical results confirm that at least one of the proposed schemes outperforms the amplify-and-forward and the zero-forcing relaying schemes under various conditions. Moreover, we show that ratios of noise power level at relay and destination node have a great impact on capacities.     

An EM based Joint Data Detection and Channel Estimation Incorporating with Initial Channel Estimate

In this letter, we derive an expectation-maximization (EM) algorithm to solve the maximum-likelihood (ML) detection problem over multiple input multiple output (MIMO) channels. The difference from the existing EM algorithms for the ML detection problem is that the proposed EM algorithm does not require the probability density function (pdf) of channel parameters. Thus, the proposed EM algorithm is applicable for any type of MIMO channels (e.g., Rician or Rayleigh) without any modification.     

Spatio-temporal coding for wireless communication

Multipath signal propagation has long been viewed as an impairment to reliable communication in wireless channels. This paper shows that the presence of multipath greatly improves achievable data rate if the appropriate communication structure is employed. A compact model is developed for the multiple-input multiple-output (MIMO) dispersive spatially selective wireless communication channel. The multivariate information capacity is analyzed. For high signal-to-noise ratio (SNR) conditions, the MIMO channel can exhibit a capacity slope in bits per decibel of power increase that is proportional to the minimum of the number multipath components, the number of input antennas, or the number of output antennas. This desirable result is contrasted with the lower capacity slope of the well-studied case with multiple antennas at only one side of the radio link. A spatio-temporal vector-coding (STVC) communication structure is suggested as a means for achieving MIMO channel capacity. The complexity of STVC motivates a more practical reduced-complexity discrete matrix multitone (DMMT) space-frequency coding approach. Both of these structures are shown to be asymptotically optimum. An adaptive-lattice trellis-coding technique is suggested as a method for coding across the space and frequency dimensions that exist in the DMMT channel. Experimental examples that support the theoretical results are presented     

A transmit preprocessing technique for multiuser MIMO systems using a decomposition approach

We introduce a transmit preprocessing technique for the downlink of multiuser multiple-input multiple-output (MIMO) systems. It decomposes the multiuser MIMO downlink channel into multiple parallel independent single-user MIMO downlink channels. Some key properties are that each equivalent single-user MIMO channel has the same properties as a conventional single-user MIMO channel, and that increasing the number of transmit antennas of the multiuser system by one increases the number of spatial channels to each user by one. Simulation results are also provided and these results demonstrate the potential of our technique in terms of performance and capacity.     

Capacity/Throughput Optimization for H-BLAST with SC Receiver over MIMO Channels

Among various Bell Labs layered space-time (BLAST) architectures over multiple input multiple output (MIMO) channels, we focus on the horizontal BLAST (H- BLAST) transmission scheme as it can achieve the channel capacity with a simple receiver, namely the successive cancellation (SC) receiver. The power optimization across layers is considered with a short-term power constraint. In addition, for block- fading channels, the rate optimization across layers is studied to maximize the throughput when the instantaneous channel state information (CSI) is not available. Since the CSI is not available, the rates can be greater than the instantaneous channel capacity and error propagation in the SC receiver is inevitable. Thus, the rate optimization plays a key role in reducing the chance of error propagation to maximize the throughput. It is shown that the optimal rates can be obtained recursively and each optimization can be carried out by a one-dimensional search.     

基于相关矩阵的MIMO系统信道容量分析

多输入多输出（MIMO）通信系统相比其他的通信系统具有更高的频谱效率,在不增加发射功率以及信号带宽的情况下,MIMO技术可以有效地提高系统信道容量及其性能。利用均匀角能量分布以及相关矩阵,分析了相关信道下的MIMO系统信道容量,得出了系统信道容量的通用公式,并利用MATLAB进行仿真。仿真结果表明,相关性的增加意味着信噪比的减小,圆形接收天线阵列半径与角度扩展是决定MIMO系统信道容量的主要因素。     

Capacity of Orthogonalized Weibull MIMO Channels Under Different Adaptive Transmission Techniques

Space-time block codes (STBCs) are known to orthogonalize the multiple input multiple out (MIMO) wireless channels. In this paper, we study the capacity of STBCs over Weibull MIMO channels under three adaptive transmission techniques: optimal power and rate adaptation, optimal rate adaptation with constant transmit power and channel inversion with fixed rate, and obtain closed-form expressions for the corresponding capacity. This capacity provides an upper bound on spectral efficiency using these techniques and avoids Monte Carlo simulations. Moreover, we also examine the effects of the fading severity on the concerned quantities. The figures show that our theoretical results of channel capacity line up exactly with the simulations.     

阵列布局对机载MIMO信道容量影响

为进一步提高空地(air-to-ground,ATG)下行通信容量,建立了三维基于散射体分布的ATG MIMO单跳同心椭圆环信道模型,结合机载多入多出（multiple input multiple output,MIMO）均匀线阵以及圆阵布局方案,推导了基于阵列结构分量的机载MIMO信道相关矩阵,为通过合理设计机载MIMO天线结构来提升ATG传输速率,分析了阵列结构参数对遍历容量的影响。仿真表明,受ATG远距离通信影响,需要扩大天线间隔来提高MIMO信道容量,且相比于线阵布局,圆阵布局更加适应飞行姿态变化,获得较高的信道容量。      

基于不同调度算法的多用户分集MIMO中继信道容量分析

采用平均容量性能来定量分析多用户分集多输入多输出(MIMO)中继信道,中继节点使用放大转发(Amplify-and-forward,AF)协议将接收到的源节点的发送信号重发给目的节点.研究了多用户MIMO中继信道的不同调度算法,即容量公平、最大特征根、最小特征根调度策略和空间独立性调度算法,结果表明空间独立性调度算法有...