从铜冶炼烟气酸洗液中分离富集铼

铜冶炼烟气酸洗液经D296阴离子交换树脂吸附后,再依次采用氨水解吸Sb,NaOH和酒石酸混合溶液解吸Bi,NH₄SCN溶液解吸Re,实现Re/Sb/Bi的分步解吸并获得铼富集液。结果表明：酸洗液电位对Re、Sb、Bi吸附率没有明显影响,适宜的酸洗液H₂SO₄浓度为43.81 g·L^-1,Re、Sb、Bi吸附率分别为100%、6.55%和89.05%;D296树脂吸附Re的穿透容量和饱和容量分别为1.308和1.773 g·L^-1,且树脂利用率为73.77%;先采用12.5%氨水解吸Sb,16%NaOH+140 g·L^-1酒石酸混合溶液解吸Bi,通过添加酒石酸可有效抑制Bi水解,再采用10%NH₄SCN溶液解吸Re,得到铼富集液,其Cu、As、Sb、Bi浓度均降至1 mg·L^-1以下,且使酸洗液中Re富集了4倍。     

锰铁合金渣浸出液制备电子级硫酸锰(英文)

以锰铁合金渣为原料,经研磨、硫酸浸出后,采用中和-水解、氟化沉淀、硫化沉淀和重结晶法去除浸出液中的铁、铝、钙、镁和重金属以及钠、钾等离子以制备电子级硫酸锰。研究反应pH、反应温度和不同添加剂的用量对硫酸锰产品中杂质含量的影响,并得到了较优的温度、pH、沉淀剂的用量等工艺条件。结果表明:在较优工艺条件下,所制备的碳酸锰中,Ca2+、Mg2+、Na+、K+杂质离子的含量小于0.005%,Fe3+、Al3+和重金属离子的含量小于0.001%,Mn2+的含量大于32%,硫酸锰产品的质量满足锂离子电池正极材料的要求。     

低品位硫化铜矿的细菌浸出

以宁夏某低品位硫化铜矿为研究对象,利用嗜酸氧化亚铁硫杆菌(Acidithiobacillusferrooxidans)和嗜酸氧化硫硫杆菌(Acidithiobacillusthiooxidans)的混合菌,采用摇瓶浸出、小型柱浸和大型柱浸对矿石可浸性进行研究;采用X射线衍射仪分析矿物及其浸渣的成分;采用扫描电镜分析浸渣表面形貌及其表面元素的含量.结果表明摇瓶矿浆浓度为5%,浸出55d铜浸出率为94.38%;小型柱浸处理矿石2.10kg,矿石粒度小于15mm,浸出226d铜浸出率为62.50%;大型柱浸处理矿石77.85kg,矿石粒度小于25mm,浸出285d铜浸出率为50.63%.柱浸过程中,铜的浸出速率逐渐下降;浸渣中钙含量基本不变,而元素硫的含量明显增加,且存在新的石膏相;浸出后矿石表面元素硫、钙、铁的含量明显增加,在浸出过程中生成的硫酸钙结晶覆盖在矿石表面,铁在矿石表面形成沉淀,使矿石的渗透性变差,导致铜的浸出率逐渐下降.     

低品位氧化铜矿氨-硫酸铵体系过硫酸铵氧化浸出

以过硫酸铵为氧化剂,研究低品位氧化铜矿在氨-硫酸铵体系氧化浸出工艺。讨论氨/铵离子摩尔比、总氨浓度,氨、硫酸铵和过硫酸铵的浓度,反应温度,液固比,反应时间和搅拌速度等操作条件对铜浸出的影响。结果表明:在92.8%的矿样粒径小于0.045 mm,氨、硫酸铵和过硫酸铵浓度分别为2.4、1.8和0.100 mol/L,浸出时间为90 min,温度为30℃,液固比(mL/g)为5:1,搅拌速度为500 r/min时的优化条件下,低品位铜矿的铜浸出率达87.7%。     

Deep removal of copper from cobalt sulfate electrolyte by ion-exchange

SP-C was applied for the removal of Cu²⁺ from simulated cobalt sulfate electrolyte containing Co²⁺ 50 g/L and Cu²⁺ 0.5–2.0 g/L. Experimental conditions included pH of 2–4, temperature of 20–60 °C and contact time of 10–40 min. The investigation demonstrated that SP-C had recommendable efficiency in adsorbing Cu²⁺ from the electrolyte with 25- to 100-fold of Co²⁺. The optimal adsorption conditions of SP-C were pH of 4, contact time of 30 min and ambient temperature. The study also showed that the loaded resin could be effectively eluted with 2.0 mol/L H₂SO₄ solution at a contact time of 40 min; the peak concentration of Cu²⁺ in the eluate was about 35 g/L. The sorption characteristics of Cu²⁺ by SP-C could be described by Langmuir isotherm and the pseudo second-order kinetic equation. Infrared spectra showed that nitrogen atoms in the functional group coordinated with Cu²⁺ to form coordination bands.     

用离子交换法从潜在钪资源的铜浸出残液中回收钪（英文）

伊朗Sarcheshmeh铜联合企业的铜浸出残液含有高达3 mg/L的钪,明显高于许多现有的钪资源,因而成为用离子交换法回收钪的可能原料。使用Visual Minteq软件确定在矿山工艺条件下可能形成的离子物种,从而选择合适的离子交换树脂。所选择的阳离子树脂在静态试验中用于含有离子的合成溶液,以及在静态/动态试验中用于实际的铜矿浸出残液。室温和pH值为1.5时,钪的吸附率最高。在动态试验中,残液流量为450 BV时,树脂达到完全饱和。在恒定时间的静态洗脱试验中,使用碳酸钠洗脱,树脂中Sc、Y、Ce的解吸率高于Fe、Al和Cu。动态洗脱试验结果表明,洗脱的优先顺序和洗脱程度具有相似的趋势。动态试验样品的解吸结果表明,浓缩比达到60:1,可得到186 mg/L的富钪溶液。     

Effect of temperature on leaching behavior of copper minerals with different occurrence states in complex copper oxide ores

The effect of temperature on leaching behavior of copper minerals with different occurrence states in complex copper oxide ores was carried out by phase analysis means of XRD, optical microscopy and SEM−EDS. The results indicated that at ambient temperature, the easily leached copper oxide minerals were completely dissolved, while the bonded copper minerals were insoluble. At lukewarm temperature of 40 °C, it was mainly the dissolution of copper in isomorphism state. With increasing temperature to 60 °C, the copper leaching rate in the adsorbed state was significantly accelerated. In addition, when the temperature increased to 80 °C, the isomorphic copper was completely leached, leaving 11.2% adsorbed copper un-leached. However, the copper in feldspar−quartz−copper−iron colloid state was not dissolved throughout the leaching process. Overall, the leaching rates of copper in different copper minerals decreased in the order: malachite, pseudo-malachite > chrysocolla > copper-bearing chlorite > copper-bearing muscovite > copper-bearing biotite > copper-bearing limonite > feldspar−quartz−copper−iron colloid.     

活化焙烧-酸浸法富集中低品位富钛料

采用还原磨选法制得的富钛料TiO2品位低,不适合直接作生产氯化法钛白和海绵钛的原料.热力学分析表明,采取添加Na2CO3进行焙烧处理后,可破坏富钛料中主要矿物组分黑钛石(Me3O5型固溶体,Me=Ti、Fe、Mg、Mn等)的固溶体结构,使固溶于其中的杂质元素铁和镁等转变为易溶于稀盐酸的物质.结果表明,用稀盐酸浸出活化富钛料可使浸出产物TiO2品位提高到90%以上,比直接用稀盐酸浸取未经活化的富钛料浸出产物TiO2的品位提高了近10%.     

Dissolution kinetics of low grade complex copper ore in ammonia-ammonium chloride solution

The leaching kinetics of Tang-dan refractory low grade complex copper ore was investigated in ammonia-ammonium chloride solution. The concentration of ammonia and ammonium chloride, the ore particle size, the solid-to-liquid ratio and the temperature were chosen as parameters in the experiments. The results show that temperature, concentration of ammonia and ammonium chloride have favorable influence on the leaching rate of copper oxide ores. But, leaching rate decreases with increasing particle size and solid-to-liquid ratio. The leaching process is controlled by the diffusion of the lixiviant and the activation energy is determined to be 23.279 kJ/mol. An equation was also proposed to describe the leaching kinetics.     

低品位氧化锌矿在MACA体系中的循环浸出

研究Me(Ⅱ)-NH4Cl-NH3-H2O(MACA)体系处理兰坪低品位氧化锌矿的浸出过程,提出用循环浸出方法富集浸出液中锌浓度的工艺技术方案.结果表明:循环浸出的优化条件为液固比4:1、常温、搅拌速度300 r/min、浸出时间3 h;通过循环次数分别为14、15及10的3个阶段的循环浸出试验,获得渣计锌浸出率≥69...