首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到20条相似文献,搜索用时 0 毫秒
1.
Oxide ceramics with nominal composition of were grown by using the citrate sol-gel method followed by high temperature sintering. The thermoelectric properties were studied in the temperature range between 100 and 290 K. The magnitude of Seebeck coefficient S(T) and electrical resistivity ρ(T) increases with the manganese doping level, reaching maximum values close to and , respectively. On the contrary, the total thermal conductivity κ(T) decreases with the manganese content. The behavior of S(T) and ρ(T) was interpreted in terms of small-pollaron hopping mechanism. From S(T), ρ(T) and κ(T) data it was possible to calculate the dimensionless thermoelectric figure of merit ZT, which reaches maximum values close to 0.12; the structural and morphological properties of the samples were studied by powder X-ray diffraction analysis and scanning microscopy (SEM), respectively.  相似文献   

2.
The figure of merit of monopolar nondegenerate semiconductors is theoretically investigated. The difference between the electron and phonon temperatures, which arises as a result of the action of different surface mechanisms of energy relaxation at the contacts of the sample with the heat reservoir, is taken into account. It is shown in the case of isothermal boundary conditions for the electron subsystem and adiabatic conditions for the phonon subsystem that the thermoelectric figure of merit of the sample increases with decreasing sample’s linear dimensions and reaches its maximum in films of submicron thickness. Fiz. Tekh. Poluprovodn. 31, 323–325 (March 1997)  相似文献   

3.
The thermoelectric figure of merit of a semiconductor p-n junction is calculated in terms of the diode theory taking account of the bipolar thermal conductivity. The thermoelectric figure of merit of a Bi2Te3 diode is estimated and it is shown that the Ioffe criterion may be at the same level as the best modern thermoelectric materials but cannot exceed unity.  相似文献   

4.
The Seebeck coefficient and the electrical and thermal conductivities (S, σ, and κ) of ternary PbTe1?xSex (x=0.1 and 0.3) and quaternary PbTe1?2xSexSx (x=0.025, 0.05, 0.1, and 0.15) solid solutions have been studied. Polycrystalline samples with an electron density of (0.5–5.0)×1018 cm?3 were used; their quality was monitored by comparing the measured and calculated mobility values at 85 K. A considerable decrease in mobility and an anomalous trend in the σ(T) curve near 77 K were revealed in quaternary alloys with x?0.1; for x=0.15, unusual behavior of κ(T) was also found. According to estimates, the lattice thermal conductivity of this material is temperature-independent in the 80-to 300-K temperature range. This means that a reduction in phonon-phonon scattering with an increase in temperature is completely compensated by an increase in the scattering on impurities. The observed anomalies of σ(T) and κ(T) are considered assuming the possible of off-center location of sulfur atoms at the lattice sites. The thermoelectric figure of merit Z of the studied alloys has been determined in the range 80–300 K. In spite of decreasing mobility, the maximum Z was obtained in a quaternary compound with x=0.1: at 300 K, Zmax=2×10?3 K?1 with a carrier density of ~3×1018 cm?3; at 175 K, Zmax=1.5×10?3 K?1 with the density decreasing to 5×1017 cm?3. The obtained data indicate that the introduction of off-center impurities rises Z at T?300 K.  相似文献   

5.
6.
Powering integrated circuits is a compromise between increasing power to increase circuit speed and maintaining high packaging density while satisfying cooling constraints. The optimization of this compromise provides the basis for a packaging figure of merit.  相似文献   

7.
A discussion of materials for dispersive birefringent filters which simultaneously exhibit extremely narrow bandwidths (< 1 Å) and wide fields of view (geq +45degacceptance angle) will be presented in this paper. Two specific types, the iso-index filter and the dispersive birefringent Lyot filter are considered. First, a figure of merit for the filter material is derived. Then the figure is related to the optical properties of the material. From this analysis the dependence of the filter bandwidth on crystal birefringence and optical bandedge characteristics is obtained.  相似文献   

8.
9.
Power semiconductor device figure of merit for high-frequencyapplications   总被引:1,自引:0,他引:1  
A figure of merit (the Baliga high-frequency figure of merit) is derived for power semiconductor devices operating in high-frequency circuits. Using this figure of merit, it is predicted that the power losses incurred in the power device will increase as the square root of the operating frequency and approximately in proportion to the output power. By relating the device power dissipation to the intrinsic material parameters, it is shown that the power loss can be reduced by using semiconductors with larger mobility and critical electric field for breakdown. Examination of data in the literature indicates that significant performance improvement can be achieved by replacing silicon with gallium arsenide, silicon carbide, or semiconducting diamond  相似文献   

10.
In the temperature range of 100–300 K, the electric (σ) and thermoelectric (α0) properties of Ag2Se with an excess of Ag as high as ~0.1 at. % and Se as high as ~1.0 at. %, respectively, are investigated. From the data on σ, α0, and χtot (thermal conductivities), the thermoelectric power α 0 2 σ and the figure of merit Z are calculated. It is found that α 0 2 σ and Z attain the peak values at room temperature and the electron concentration n ≈ 6.5 × 1018 cm?3.  相似文献   

11.
This note derives a figure of merit for a varactor tuned microwave solid state oscillator. Thu figure of merit is in terms of electronic tuning range and power output normalized to the available power from the untuned oscillator. This enables the varactor which will give the required combination of thorns parameters to be specified in terms of y and f c.

The figure of merit also shows that a varactor with a large value of the product yf c maximizes the figure of merit.  相似文献   

12.
The authors propose a new noise figure for avalanche photodiodes (APDs). This new noise figure overcomes the difficulty of estimating the internal multiplication and quantum efficiency in complex APD structures, such as III-V SAM APDs. Measurements of the new noise figure are presented for two commercial SAM APDs and the authors show theoretically that it represents a more complete figure of merit for comparing the performance of one APD with another, and with the ideal  相似文献   

13.
The effects of base resistance, base transit time, and junction capacitances play a key role in the propagation delay of high-speed bipolar logic gates. A simple device figure of merit for transistors used in current mode logic (CML) circuits, based on minimum propagation delay, is developed. This delay is derived from the large-signal 3-dB cutoff frequency of the CML gate. Results are shown to be applicable for a wide range of device and circuit parameters  相似文献   

14.
In recent years a new class of reflector antennas utilizing array feeds has been receiving attention. An example of this type of antenna is a reflector utilizing a moveable array feed for beam steering. Due to the circuitry required to adjust the weights for the various feed array elements, an appreciable amount of loss can be introduced into the antenna system. One technique to overcome this possible deficiency is to place low noise amplifiers with sufficient gain to overcome the weighting function losses just after each of the feed elements. In the evaluation of signal processing antennas that employ amplifiers the standard antenna gain measurement will not be indicative of the antenna system's performance. In fact, by making only a signal measurement, the antenna gain can be made any arbitrary value by changing the gains of the amplifiers used. In addition, the IEEE Standard Test Procedures for Antennas does not cover the class of antennas where the amplifier becomes part of the antenna system. There exists a need to establish a standard of merit or worth for multi-element antenna systems that involve the use of amplifiers. A proposed figure of merit for evaluating such antenna systems is presented.  相似文献   

15.
16.
In this paper a new figure of merit for high frequency noise behavior for use in the evaluation and development of bipolar silicon process technology is introduced. Basic low noise design rules for optimum transistor biasing and emitter scaling are proposed  相似文献   

17.
The delay time of an inverter or NAND chain at a gate length yielding equal standby current and active current is used as the definition of a maximum Figure of Merit (FOM), FOMmax. The circuit power that occurs under this condition of equal standby and active currents is an equally important measure. This FOMmax technique is particularly useful in characterizing complementary metal-oxide-semiconductor (CMOS) technologies in the deep submicron regime. A knowledge of the exact value of gate length is not necessary to apply the FOMmax methodology. For a fixed supply voltage and gate oxide thickness, node capacitance and transistor drive, and off currents determine the value of FOMmax. The value of gate length at which FOMmax occurs decreases with decreasing supply voltage. FOMmax analysis is applied to the comparison of CMOS technologies using gate oxide thicknesses of 5.7 and 3.8 nm  相似文献   

18.
A CCD split-electrode transversal filter (EPSEF) with analog controlled tap weights is described. The programmable tap weighting utilizes a novel analog multiplier for sampled data, based on charge profiling underneath a resistive gate structure. The EPSEF device concept and the performance data of a prototype filter with eight programmable taps are presented. Applications of the EPSEF in several programmed filter functions and in an adaptive filter system are demonstrated.  相似文献   

19.
This paper deals with the problem of determining the impurity distribution which will improve the minority carrier base transit time and figure of merit of transistors. From the study of a special form of doping distribution which presents a point of inflection in the resulting built-in electric field configuration, it is concluded that the optimum doping distributions derived through variational methods [2–4] do not necessarily offer a unique minimum for base transit time. A new technique called “The Segmentation Technique” is evolved to synthesise base impurity distributions for improved high frequency performance of present-day junction transistors. It is shown that typical impurity distributions presenting retarding field over a small portion of the base and an aiding field over the rest of the base region offer a significant improvement in base transit time and the high frequency figure of merit.  相似文献   

20.
It is shown that a different measure of performance must be used to evaluate hybrid-integrated active filters from that used to evaluate active filters in discrete form. Where sensitivity was previously found to be an adequate and useful measure for Q stability of discrete active filters, the gain-sensitivity product gives an accurate measure of Q stability for hybrid-integrated circuits. Where negative feedback filter schemes were found to be preferable with respect to Q stability when realized in discrete form, positive feedback schemes with their very much lower gain- sensitivity product may be preferable in hybrid-integrated filter circuits. In addition, they require low-gain amplifiers than can be used up to higher frequencies. Q-stability measurements of hybrid- integrated positive feedback, or Sallen-Key-type circuits, which were realized with tantalum thin-film resistors and capacitors combined with beam-leaded operational amplifier chips agree very accurately with the predictions derived from gain-sensitivity calculations.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号