Study of radiation hardness of HfO2-based resistive switching memory at nanoscale by conductive atomic force microscopy

A resistive switching random access memory (RRAM) with an HfO₂/Ti structure grown on a molybdenum (MO) substrate was fabricated, and a gold (Au) conductive atomic force microscopy (CAFM) tip was used as the top electrode such that the cell area of the resulting RRAM device is as small as 3 × 10⁻¹² cm². The pre- and post-irradiated resistive switching behaviors of the RRAM device with various HfO₂ layer thicknesses were investigated after being subjected to Co⁶⁰ γ-ray irradiation with different radiation doses. It is found that the forming voltage (V_forming), set voltage (V_set), resistance of high resistance state (RHRS) and resistance of low resistance state (RLRS) of the RRAM device are all radiation dose-dependent. The V_forming, V_set, RHRS and RLRS all decrease as the radiation dose increases due to increasing radiation-induced oxygen vacancies or defects inside the HfO₂ layer. Our experimental results indicate that the HfO₂-based RRAM cell with an extremely small cell area is not actually radiation hard since the operating voltage will change with V_forming and V_set after irradiation.     

Use of C-SAM acoustical microscopy in package evaluations and failure analysis

Acoustical microscopy is gaining wide acceptance in the microelectronic packaging community. C-mode scanning acoustical microscopy, C-SAM, is widely used in package evaluations and for failure analysis. This paper discusses several specific topics. These include: (1) popcorn cracking in SMDs; (2) an evaluation of solder die attach in power packages; (3) an instance of top of die delamination which resulted in electrical failures; and (4) moisture sensitivity of other surface mount power packages and how it resulted in ball bond degradation during a new product qualification.     

Qualification of plastic encapsulated microcircuits (PEM) for avionicsBased on ``Plastic Encapsulated Microcircuits (PEM) Qualification Testing'''', by J. A. Scalise, which appeared in the Proceedings of the 46th Electronic Components and Technology Conference, Orlando, FL, U.S.A., 28–31 May 1996, pp. 392–397. © 1996 IEEE.

Microcircuit package qualification testing is used to establish the reliability of integrated circuit processes and devices as they relate to part packaging. This paper presents the results of package qualification tests conducted on plastic encapsulated microcircuits (PEMs) and plastic discrete devices (diodes, transistors) used in avionics applications. Highly accelerated stress test (HAST) and temperature cycle (TC) test results, including part failure mechanisms and associated failure rates, are provided. A variety of plastic package styles and integrated circuit functions have been tested. Examples of package styles tested include small outline (SO), plastic leaded chip carrier (PLCC), thin small outline package (TSOP), plastic quad flat package (PQFP) and plastic dual-in-line (PDIP).Manufacturers' devices have been evaluated and various plastic compounds have been compared to determine which provide optimum reliability. The testing showed that package qualification performance of PEMs is affected by type of compound, passivation (including die coat) and die size. HAST failures are caused by moisture penetration of the package while temperature cycle failures result from coefficient of thermal expansion (CTE) mismatch effects.