共查询到20条相似文献,搜索用时 187 毫秒
1.
2.
3.
4.
6.
电力电缆故障的精确定点是人们十分关注的课题,本文详细介绍了电力电缆低阻故障,高阻故障,故障和特殊位置故障的定点方法,并且根据作者的经验介绍了电力电缆故障的定点技巧及注意事项. 相似文献
7.
8.
阻水型电力电缆的主要结构和关键工艺 总被引:1,自引:4,他引:1
阻水型电力电缆作为电线电缆行业的一个新品种,正随着经济的发展、技术的成熟而得到推广应用。该文就阻水电力电缆的结构设计和工艺控制提出一些看法。 相似文献
9.
葛南直流线路高阻接地故障保护分析 总被引:9,自引:1,他引:8
分析了葛洲坝一南桥高阻接地故障所引发的保护动作行为,以加深对极线路保护的理解.通过读取故障的原始录波数据,详细分析了这次故障的特征,给出了行波保护、电压突变量保护、线路低电压保护和线路差动保护的动作行为,使这次故障过程得到比较清楚的解释.同时根据直流线路高阻接地原理图,计算出高阻接地的故障点和过渡电阻值,指出高阻接地故障时主保护灵敏度不足的问题. 相似文献
10.
11.
随着大量电力电缆的投运,相应的电缆故障率也随着使用年限等上升,造成停电事故和巨大的经济损失,为此快速修复故障成为迫切需要。但是由于电缆的敷设特性决定了需要对电缆故障性质进行了解。该文从多方面分析了造成电缆故障的原因,然后按电缆材料、故障发生部位和基于行波理论测距方法分类做进一步深入研究,并依故障测距的步骤着重介绍了当前电缆精确测距的方法和当前比较新颖的电缆故障在线检测及其相关讨论,突出介绍了基于小波变换电缆故障测距。还介绍当前在电力系统中的电缆故障检测应用设备情况,概括了当前国内设备同国外公司的差别,对电缆故障测距的发展趋势做了一定程度的展望。 相似文献
12.
13.
Banker W.A. Nannery P.R. Tarpey J.W. Meyer D.F. Piesinger G.H. 《Power Delivery, IEEE Transactions on》1994,9(3):1187-1194
A nondestructive, high resolution radar system that precisely locates URD power cable faults and splices has been developed. High resistance faults are identified without thumping via a low energy, battery-powered snapshot unit. Only enough DC voltage to initiate and maintain one flashover at the fault is applied; the duration is limited to four milliseconds. Pinpointing the fault or splice is accomplished by detecting the radar signal above ground. When the antenna is directly over the fault or splice, the location is confirmed. The ability to receive the signal from the cable makes the pinpointing step independent of cable propagation velocity 相似文献
14.
15.
16.
17.
电力电缆故障检测方法与应用 总被引:1,自引:1,他引:0
介绍电力电缆故障的检测步骤,概述电力电缆故障的原因和性质分类,分析常用的测试和故障定位方法,同时结合一起电力电缆故障的查找经过,提出电力电缆故障检测时应注意的问题。 相似文献
18.
Yoshiharu Yotsumoto Shigeki Isono Katsutoshi Kawasaki 《Electrical Engineering in Japan》2001,134(2):19-28
Formerly, only pulse radar and the Murray loop bridge could be utilized in a cable fault location method that is applicable to branch lines. Those methods need a terminal connection at the far end. Therefore, it is difficult in fault location involving branch lines. Pulse radar is applicable only for high‐resistance ground faults and the Murray loop bridge is applicable only for low‐resistance ground faults. We have developed current‐detection pulse radar and tested it. In high‐resistance ground fault location, the measured result includes discharge delay error. Therefore, we have proposed an error correction method and confirmed it. In addition, we have designed a new cable fault location method of pulse radar and tested it. © 2000 Scripta Technica, Electr Eng Jpn, 134(2): 19–28, 2001 相似文献
19.
20.
针对带并联电抗器的超高压电缆-架空混合线路,分析了两相或三相不同性质故障时故障相的残余电压特性,提出了基于差模电压频率测量的相间故障性质识别新判据。混合线路发生故障且两侧断路器跳开后,利用扩展Prony算法快速获取差模电压频率。发生瞬时性故障时,差模电压频率略低于工频;发生永久性故障时,差模电压频率接近于0。基于上述特征可进行瞬时性故障与永久性故障的有效识别,该方法原理简单,且易于实现。大量的EMTDC仿真验证表明,该方法能够有效可靠地实现超高压电缆-架空混合线路的永久性故障与瞬时性故障的识别,且不受过渡电阻、故障位置及电力电缆所占线路全长比例的影响。 相似文献