共查询到20条相似文献,搜索用时 171 毫秒
1.
研究了中国石化北京燕山分公司生产的钕系顺丁橡胶(Nd-BR,牌号为Nd 40)的加工性能及硫化胶的性能,并与国产牌号为BR 9000的镍系顺丁橡胶(Ni-BR)和国外生产的牌号为CB 24的Nd-BR进行了对比。结果表明,与BR 9000和CB 24相比,Nd 40生胶的门尼黏度相近,冷流性较高,但Nd 40混炼胶的门尼黏度和格林强度高,挤出特性稍差;Nd 40硫化胶的综合力学性能明显优于BR9000硫化胶,尤其是弹性和动态压缩温升,具有更低的滚动阻力和更高的刚度;与CB 24硫化胶相比,Nd 40硫化胶的扯断伸长率较高,生热更低,耐磨性更好,其他性能稍逊。 相似文献
2.
3.
不同催化体系顺丁橡胶胎冠胶性能比较 总被引:2,自引:0,他引:2
对钴系、钕系和镍系顺丁橡胶(BR)胎冠胶物理性能和工艺性能进行对比。结果表明:钕系BR胶料综合物理性能最好,表现为弹性和耐磨性能好,压缩生热低,300%定伸应力和撕裂强度高;国产镍系BR9000胶料的综合物理性能优于钴系BR150和BR1203G-1胶料,尤其是耐屈挠性能和抗刺扎性能好;镍系BR胶料的工艺性能最好,钕系BR胶料的半成品工艺性能较差。 相似文献
4.
<正>稀土顺丁橡胶是以稀土化合物(因为稀土元素中钕化合物具有最高的催化活性,故又称为钕系顺丁橡胶(Nd-BR))为主催化剂制得的具有高顺式1,4-结构含量的聚丁二烯橡胶。它具有链结构规整度高、线性好、平均相对分子质量高、相对分子质量分布可调、自粘性好等优点以及加工性能优异。稀土顺丁橡胶是除溶聚丁苯橡胶(SSBR)之外,另一种对开发经济、 相似文献
5.
6.
7.
8.
本文提出,Fe胶体可以提高镍系催化丁二烯聚合的活性;每克镍可合成顺丁橡胶240公斤;所制得的高聚物微观结构稳定,顺式含量高,胶的物理机械性能好。 相似文献
9.
10.
11.
本文介绍了Enichem与原西德Bayer公司近年来分别推出的稀土钕系聚丁二烯橡胶的商品物性,并与传统立构BR进行了比较,还介绍了国外生产或合成Nd—BR的技术新进展。 相似文献
12.
国产钕系BR的综合性能 总被引:11,自引:3,他引:8
将国产钕系顺丁橡胶(NdBR)与国外同类产品和国产镍系顺丁橡胶NiBR进行了基本性能的对比。与国产NiBR相比、NdBR显示了链结构规整性与相绎分子质量较高、相对分子质量分布较窄、加工性能稍差、自粘结性能与生胶强度较高、硫经胶拉伸强度的固弹性高、疲劳生热低、疲劳生热低、动态力学性能优良、抗湿滑性与滚动阻力之间具有最佳平衡等特点,综合性能比NiBR优良。国产NdBR的性能与国外轴类产品基本相近,其中 相似文献
13.
14.
复合型防老剂在低顺式聚丁二烯橡胶中的应用 总被引:2,自引:0,他引:2
以防老剂1010,防老剂1076,防老剂264,防老剂168和防老剂TNP为基础,研究了二元,三元和四元复合型防老剂对低顺式聚丁二烯橡胶的防化作用,结果表明:复合型防老剂抗热,氧老化性能和抗热机械剪切性能均优于单一型防老剂,受阻酚类与亚磷酸酯类二元复合型防老综合性能最佳。 相似文献
15.
16.
Chansuree Chatarsa Pattarapan Prasassarakich Garry L. Rempel Napida Hinchiranan 《应用聚合物科学杂志》2015,132(15)
Neodymium (Nd)‐based Ziegler–Natta catalyst has been well known for preparing polybutadiene rubber (BR) containing high, about 98%, cis−1,4 configuration with extremely low gel content providing superior resistance to low‐temperature fatigue and abrasion. However, its cost is more expensive than a conventional nickel (Ni)‐based catalyst. The Nd‐BR has poor processability with high cold flow due to its high linearity and molecular weight. To compare with a traditional process, the BR produced by Ni‐based catalyst has higher level of branching resulting in the better processability, but it contains medium amount of gel. To balance the catalyst cost and the BR properties, this article reported the influence of a solution containing Ni‐ and Nd‐based Ziegler–Natta catalyst (Ni/Nd) using diethyl aluminum chloride and triethyl aluminum as co‐catalysts on 1,3‐butadiene (BD) conversion and physical properties of the elastomeric materials based on obtained rubber (Ni/Nd‐BR). In the presence of toluene, the increase in the Ni/Nd molar ratio from 0.0/1.0 to 0.4/0.6 yielded Ni/Nd‐BR containing cis−1,4 units of 95%–96% with significantly decreasing both levels of vinyl−1,2 and trans−1,4 configurations from 0.26% to 0.13% and 4.44% to 3.07%, respectively. When cyclohexane was applied as the reaction media, 100% BD conversion was achieved and the Ni/Nd‐BR had very low content of vinyl−1,2 unit (0.07%). The mechanical properties in terms of tensile properties and abrasion resistance of the elastomer based on Ni/Nd‐BR having high cis‐1,4 and relatively higher trans−1,4 configurations were superior to elastomers based on commercial BRs produced by using Ni‐ and Nd‐based catalyst systems. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 41834. 相似文献
17.
18.
19.
低凝胶含量镍系顺丁橡胶的研究 总被引:2,自引:0,他引:2
研究了在加氢汽油中以Ni(naph)2-Al(i-Bu)3-BR·D(以下简称Ni-Al-B·D)为引发体系,进行丁二烯聚合的规律。与Ni(naph)2-Al(i-Bu)3-BF3·OEt2体系相比,由于采用新型的B·D络合物代替了三氟化硼乙醚络合物,改善了引发体系在溶剂中的溶解性,从而使聚丁二烯橡胶中的凝胶含量由原来的0.36%左右降至0.10%左右。调节B·D络合物用量可合成出不同门尼粘度、凝胶含量低、胶液粘度适宜、性能好的高顺式聚丁二烯橡胶。 相似文献
20.
回顾了Ni系催化剂的开发研究及应用。重点介绍Ni系催化剂合成顺丁橡胶的聚合特征,活性中心模型,聚合机理,聚合动力学,以及国内外改进Ni系催化剂的新进展。 相似文献