共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
本文介绍一种可用于HDTV的100MHz 10bit CMOS电流型DAC设计方法。通过合理划分等权重电流和二进制权重电流,并在电路设计及版图设计中充分考虑工艺偏差、开关噪声以及温度电压等的影响,在CMOS工艺上实现高速高精度的电流型输出数模转换器(Current Steering DAC)。 相似文献
3.
本文叙述了高速GaAs ADC与GaAs DAC的研制现状。着重介绍了在芯片上有T/H电路的闪光型ADC和在芯片上有电流源的DAC,以及它们的性能。 相似文献
4.
本文叙述了高速GaAs ADC与GaAs DAC的研制现状,着重介绍了在芯片上有T/H电路的闪光型ADC和在芯片上有电流源的DAC,以及它们的性能。 相似文献
5.
就电流开关驱动器对高速电流型DAC动态性能的影响因素进行了分析,给出了设计应对措施,并设计了一种结构简单使用了同步锁存技术、低驱动信号摆幅技术和低信号交叉点技术的电流开关驱动器电路.基于SMIC 0.18μm CMOS工艺模型,采用Hspice仿真工具,对电流开关驱动器进行仿真分析,结果表明所设计驱动器电路功能正确.测试结果表明,应用该电流开关驱动器的一款嵌入式14位400MSPS DAC电路在输出80 MHz正弦信号时,达到76.47 dB的无杂散动态范围,所设计电流开关驱动器能保证高速电流型DAC的良好动态性能. 相似文献
6.
CD播放机中使用的DAC(2)积分型DAC 总被引:1,自引:0,他引:1
上一期介绍了电流相加型DAC.这一期介绍积分型DAC。积分型DAC具有线性好、音质好的突出优点.可谓曾风光一时与电阻梯形电流相加型DAC平分天下。但是这种DAC由于无法适应高比特高取样化的发展潮流.目前其应用已越来越少。 相似文献
7.
8.
设计了一种带电流源校准电路的16 bit高速、高分辨率分段电流舵型数模转换器(DAC)。针对电流舵DAC中传统差分开关的缺点,提出了一种优化的四相开关结构。系统分析了输出电流、积分非线性和无杂散动态范围(SFDR)三个重要性能指标对电流舵DAC的电流源单元设计的影响,完成了电流源单元结构和MOS管尺寸的设计。增加了一种优化设计的电流源校准电路以提高DAC的动态性能。基于0.18μm CMOS工艺完成了该DAC的版图设计和工艺加工,其核心部分芯片面积为2.8 mm^2。测试结果表明,在500 MHz采样速率、100 MHz输入信号频率下,测得该DAC的SFDR和三阶互调失真分别约为76和78 dB,动态性能得到明显提升。 相似文献
9.
介绍了一种高速7位DAC的设计及芯片测试结果,该DAC选取高5位单位电流源,低2位二进制电流源的分段结构。考虑了电流源匹配、毛刺降低以及版图中误差补偿等方面的问题来优化电路。流片采用0.35μmChartered双层多晶四层金属工艺,测试结果表明在20 MH z的采样频率下,微分非线性度和积分非线性度分别小于±0.2 LSB和±0.35 LSB。该DAC的满幅建立时间是20 ns,芯片面积为0.17 mm×0.23 mm。电源电压为3.3 V,功耗为3 mW。 相似文献
10.
11.
12.
NBTI导致的晶体管老化成为影响电路稳定性的主导因素,同时,降低电路的泄漏功耗是电路设计的目标之一。多米诺电路广泛应用在高性能集成电路中。本文提出了一种多米诺电路用来抑制NBTI引起的多米诺电路衰退并同时降低待机模式下的泄漏电流。在待机模式下,利用2个晶体管将标准多米诺电路的动态节点和输出节点同时上拉为电源电平,从而将保持器和输出反相器中的pMOS晶体管同时置为NBTI的恢复模式。使用全0输入向量和其中增加的一个晶体管的堆栈效应降低待机模式下多米诺电路的泄漏电流。实验表明针对NBTI效应,该方法降低了最多33%的性能衰退,并同时减少了最多79%的泄漏电流。 相似文献
13.
针对滞环恒流大功率LED驱动芯片,提出一款高性能电流采样电路。该电路采用高压工艺,可承受最高达40 V的输入电压。通过分析滞环控制的特点,采用串联电阻采样技术,结合匹配电流源结构,在保证响应速度和采样精度的同时,降低了电路的复杂度。电路中加入输入电压补偿电路,进一步提高了恒流控制的精度。在Cadence下的仿真结果表明,电路可在800 kHz的频率下正常工作,采样精度达99.78%;当电压从15 V变化至35 V时平均负载电流误差为0.81%;输出电压范围为0~5 V。 相似文献
14.
实现了一种具有超高电压输入、高精度、大调光范围、低成本的非隔离型LED恒流驱动芯片。芯片采用外接高压三极管的电压调整结构以及高精度基准电压源,以PWM峰值电流控制方式实现了高精度、高一致性的电流输出。芯片采用18 V耐压的工艺流片,实现输入电压范围从10 V达到450 V变化,电能转换效率高达92%,驱动电流可从几毫安到超过1 A间设定,电流精度和一致性可达1.5%。 相似文献
15.
本设计为一智能化高精度数控直流电流源,该直流电流源系统以AT89S52单片机为控制核心,由显示、键盘、报警以及恒定电流产生等模块组成。其中恒定电流产生电路采用闭环控制模式,由电流取样电阻、电压放大电路、电压比较以及PI调节电路组成。整个程序采用模块化设计,具有良好的扩展性。 相似文献
16.
17.
18.
An injection method for an active filter which eliminates the harmonics present in AC lines by injecting PWM harmonic compensating current is proposed. In the proposed method, the active filter produces a pulsewidth modulation (PWM) current that cancels the existing harmonics up to any order completely. To generate such PWM current, both inverter and DC current source is needed. The current source can be replaced by a large inductor without any external power source. This can be achieved by providing the inverter with rectifying capability because the inverter has the same circuit structure as the rectifier. Therefore, the proposed model of PWM injection current includes not only the harmonic components to suppress the existing harmonics up to any order, but also the fundamental one, to raise the inductor current to any desired value. The characteristics of the injection method are investigated through a digital computer simulation. Feasibility is proved by the experimental results 相似文献
19.
Drakin A.E. Eliseev P.G. Sverdlov B.N. Dolginov L.M. Shevchenko E.G. 《Electronics letters》1984,20(13):559-561
Double heterostructure InGaAsP/InP lasers with a three-layer waveguide (or `separate-confinement? DH) have been prepared by the LPE method with a thin active layer. A decrease in threshold current density has been observed up to 512 A/cm2 in a four-sided cleaved diode at room temperature. CW operation of broad-area diodes is obtained in the pumping current range up to 2.5 A. Calculations of threshold current density for these laser structures are presented. 相似文献
20.
The performance of the unbiased guard ring structure is measured and the effects of high current, emitter area, and layout of unbiased guard rings are reported and explained. Measurements show a reduction in parasitic gain by up to six orders of magnitude, while also avoiding the cross talk and power consumption of biased rings. A comparative analysis of unbiased guard ring with biased guard ring shows up to 100 times better performance at low current levels. A modification to the unbiased guard ring is also implemented and successfully tested which shows an increase in the current handling capability of the structure by an order of magnitude 相似文献