Ti/SnO2,Ti/SnO2-Sb2O3阳极电催化氧化酸性品红的试验研究

采用热氧化法制备了Ti/SnO2和Ti/SnO2-Sb2 O3电极,以酸性品红为研究对象,对两种电极材料进行了性能比较,考察槽电压、电流密度、电解质浓度对电催化氧化处理系统的影响.结果表明:热氧化法制备出的Ti/SnO2-Sb2 O3电极,其电催化性能明显优于Ti/SnO2电极;以Ti/SnO2-Sb2 O3为阳极,在酸性品红初始浓度为100 mg/L、电极间距为2.5 cm、电流密度为75mA/cm2、电解质浓度取12 g Na2SO4/L时,60 min后酸性品红的去除率达到了95.41％.     

Kinetics of electro-oxidation of ammonia-N, nitrites and COD from a recirculating aquaculture saline water system using BDD anodes

The viability of the electro-oxidation technology provided with boron doped diamond (BDD) electrodes for the treatment and reuse of the seawater used in a Recirculating Aquaculture System (RAS) was evaluated in this work.The influence of the applied current density (5-50 A m⁻²) in the removal of Total Ammonia Nitrogen (TAN), nitrite and chemical oxygen demand (COD) was analyzed observing that complete TAN removal together with important reductions of the other considered contaminants could be achieved, thus meeting the requirements for reuse of seawater in RAS systems.TAN removal, mainly due to an indirect oxidation mechanism was described by a second order kinetics while COD and nitrite removal followed zero-th order kinetics. The values of the kinetic constants for the anodic oxidation of each compound were obtained as a function of the applied current density (k_TAN = 7.86 × 10⁻⁵·exp(6.30 × 10⁻² J); k₂NO = 3.43 × 10⁻² J; k_COD = 1.35 × 10⁻² J). The formation of free chlorine and oxidation by-products, i.e., trihalomethanes (THMs) was followed along the electro-oxidation process. Although a maximum concentration of 1.7 mg l⁻¹ of total trihalomethanes was detected an integrated process combining electrochemical oxidation in order to eliminate TAN, nitrite and COD and adsorption onto activated carbon to remove the residual chlorine and THMs is proposed, as an efficient alternative to treat and reuse the seawater in fish culture systems. Finally, the energy consumption of the treatment has been evaluated.     

Performance of IFAS wastewater treatment processes for biological phosphorus removal

Integrated fixed film activated sludge (IFAS) is a promising process for the enhancement of nitrification and denitrification in conventional activated sludge systems that need to be upgraded for biological nutrient removal (BNR), particularly when they have space limitations or need modifications that will require large monetary expenses. Several studies have reported successful implementations of IFAS at temperate zone wastewater treatment facilities, typically by placement of fixed film media into aerobic zones. However, nearly all of the implementations have not included enhanced biological phosphorus removal (EBPR) in the upgraded systems. This is possibly because the treatment plants have been operated at low mixed liquor mean cell residence times (MCRTs), and EBPR would wash out of the systems at the low temperatures encountered, making it difficult to maintain EBPR. The primary objective of this study was to investigate the incorporation of EBPR into IFAS systems, and study the interactions between the fixed biomass and the mixed liquor suspended solids with respect to substrate competition and nutrient removal efficiencies. Three pilot-scale UCT/VIP configuration systems were used, one as a control and the other two with Bioweb media integrated into some of the anoxic and aerobic reactors. The systems were operated at different MCRTs, and influent COD/TP ratios, and with split influent flows. The experimental results confirmed that EBPR could be incorporated successfully into IFAS systems, but the redistribution of biomass resulting from the integration of fixed film media, and the competition of organic substrate between EBPR and denitrification would affect performances. Also, the integration of fixed film media into the anoxic reactors affected performances differently from media in aerobic reactors.     

Development of a 2-sludge, 3-stage system for nitrogen and phosphorous removal from nutrient-rich wastewater using granular sludge and biofilms

A novel 2-sludge 3-stage process using a combination of granular sludge and biofilm was developed to achieve biological removal of nitrogen and phosphorus from nutrient-rich wastewater. The system consists of a granular sequencing batch reactor (SBR) working under alternating anaerobic/anoxic conditions supplemented with a short aerobic phase and an aerobic biofilm SBR. The wastewater is first fed to the granular SBR reactor, where easily biodegradable carbon sources are taken up primarily by polyphosphate accumulating organisms (PAOs). The supernatant resulting from quick settling of the granular sludge is then fed to the biofilm SBR for nitrification, which produces oxidized nitrogen that is returned to the granular reactor for simultaneous denitrification and phosphorus removal. While maximizing the utilization of organic substrates and reducing operational costs, as do other 2-sludge processes previously reported in literature, the proposed system solves the bottleneck problem of traditional 2-sludge systems, namely high effluent ammonia concentration, due to its high-volume exchange ratios. An ammonia oxidation rate of 32 mg N/Lh was achieved in the biofilm SBR, which produced nitrite as the final product. This nitrite stream was found to cause major inhibition on the anoxic P uptake and also to result in the accumulation of N(2)O. These problems were solved by feeding the nitrite-containing stream continuously to the granular reactor in the anoxic phase. With a nitrogen and phosphorus removal efficiency of 81% and 94%, respectively, the system produces an effluent that is suitable for land irrigation from a wastewater stream containing 270 mg N/L of total nitrogen and 40 mg P/L of total phosphorus.     

Removal of nitrogen, phosphorus and COD from waste water using sand filtration system with Phragmites Australis

The removal efficiencies of nitrogen, phosphorus and COD from waste water were examined using sand filtration systems with Phragmites australis (Cav.) Trin. ex. Steudel. The quality of effluent waters from the system with plant were far better than those from the one without plant, implying Phragmites could incorporate nitrogen and phosphorus into its tissues and promote phosphorus absorption onto the sand by the release of oxygen from the roots. The P-pot provided with the influent containing 198 mg l^- of total nitrogen and 21 mg l^-1 of total phosphorus had the highest biomass of Phragmites. Harvestable above-ground biomass accounted for about 3.5 kg m^-2 and removable nitrogen and phosphorus accounted for 69 and 6 g m^-2 respectively.The removal rates of total nitrogen and phosphorus in the system with Phragmites receiving variable amounts of COD were almost at the same level and also much better than those of the systems without plant, implying that the different COD concentrations in the influent media do not impair the removal efficiencies of nitrogen and phosphorus. Also Phragmites was found to resist COD concentration as high as 128 mg l^-1, and signs of clogging were not detected in this system throughout the experiment.     

产酸脱硫反应器中COD/SO42-比对硫酸盐去除率的影响研究

采用两相厌氧生物处理工艺的产酸相作为硫酸盐还原单元,以食用红糖为碳源,通过连续流实验,重点研究了产酸相中COD/SO42-值(C/S)对SO42-去除率的影响.在34±1 ℃、进水碱度(ALK)300～500mg/L、pH 6.0～6.2、氧化还原电位(ORP)-250～-350mV等条件下,当进水C/S＜2.0时,SO42-去除率小于81%;当进水C/S值为2.5～2.0时,SO42-去除率为90～81%;当进水C/S值为大于2.5时,SO42-去除率为90%以上.随着C/S值的降低,SO42-的去除效果会将有所降低.     

Simultaneous removal of carbon and nutrients from an industrial estate wastewater in a single up-flow aerobic/anoxic sludge bed (UAASB) bioreactor

Simultaneous removal of carbon and nutrients (CNP) in a single bioreactor is highly significant for energy consumption and control of reactor volume. Basically, nutrients removal is dependant to the ratio of biochemical oxygen demand to chemical oxygen demand (BOD₅/COD). Thus, in this study the treatment of an industrial estate wastewater with low BOD₅/COD ratio in an up-flow aerobic/anoxic sludge bed (UAASB) bioreactor, with an intermittent regime in aeration and discharge, was investigated. Hydraulic retention time (HRT) of 12-36 h and aeration time of 40-60 min/h were selected as the operating variables to analyze, optimize and model the process. In order to analyze the process, 13 dependent parameters as the process responses were studied. From the results, it was found, increasing HRT decreases the CNP removal efficiencies. However, by increasing the BOD₅ fraction of the feed, the total COD (TCOD), slowly biodegradable COD (sbCOD), readily biodegradable COD (rbCOD), total nitrogen (TN), and total phosphorus (TP) removal efficiencies were remarkably increased. Population of heterotrophic, nitrifying and denitrifying bacteria showed good agreement with the results obtained for TCOD and TN removal. The optimum conditions were determined as 12-15 h and 40-60 min/h for HRT and aeration time respectively.