Crystallization and spectroscopic properties in Er3+ doped oxyfluorogermanate glass ceramics containing Na

The Er³⁺ doped oxyfluorogermanate glasses, with a composition containing Na element, were synthesized by the conventional melting–quenching technique. When Na element was introduced into the composition of oxyfluorogermanate glass, the crystals behavior was investigated in details. Depending on the annealing procedure supplied, thermal annealing of precursor glasses in the system GeO₂/BaF₂/AlF₃/Na₂O/NaF/ZnO/GdF₃/ErF₃ led to the precipitation of different crystal phase nanocrystals. It was confirmed the nanocrystals in GC600 is orthorhombic NaBaAlF₆ which led to enhance obviously in the UC luminescence of Er³⁺. However, the nanocrystals in G585 led to decrease in the UC luminescence, which indicated few Er ions enter into the lattice of this nanocrystal phase. The reason of the decrease in UC emission intensity of GC585 was analyzed.     

Er~(3+)掺杂透明微晶玻璃光谱性质的研究

通过高温熔融法和热处理制备了含有-γBi2WO6纳米晶的Er3+掺杂透明硼铋酸盐微晶玻璃.根据X射线粉末衍射结果和Scherrer公式计算得到-γBi2WO6晶粒大小约为15 nm.由于部分Er3+离子取代Bi3+进入-γBi2WO6纳米晶相中,使得Er3+离子在1.5μm的有效发射带宽由78 nm增加到85 nm,同时Er3+离子在4I13/2能级的荧光寿命由0.67 ms增加到1.43 ms.此外,与原始玻璃相比,在Er3+掺杂硼铋酸盐微晶玻璃中观察到强烈的绿光上转换发光,其上转换发光机制可以归为双光子过程.     

Influences of Er3+ content on structure and upconversion emission of oxyfluoride glass ceramics containing CaF2 nanocrystals

Transparent 45SiO₂–25Al₂O₃–5CaO–10NaF–15CaF₂ glass ceramics doped with different content of erbium ion (Er³⁺) were prepared. X-ray diffraction (XRD) and transmission electron microscope (TEM) analyses evidenced the spherical CaF₂ nanocrystals homogeneously embedded among the glassy matrix. With increasing of Er³⁺ content, the size of CaF₂ nanocrystals decreased while the number density increased. The crystallization kinetics studies revealed that CaF₂ crystallization was a diffusion-controlled growth process from small dimensions with decreasing nucleation rate. Er³⁺ could act as nucleating agent to lower down crystallization temperature, while some of them may stay at the crystal surfaces to retard the growth of crystal. Intense red and weak green upconversion emissions were recorded for glass ceramics and their intensities increased with the increasing of Er³⁺ content under 980 nm excitation. However, the concentration quenching effect appeared when Er³⁺ doping reached 2 mol%. These results could be attributed to the change of ligand field of Er³⁺ ions due to the incorporation of Er³⁺ ions into precipitated fluoride nanocrystals.     

Emission properties of highly doped Er3+ fluoroaluminate glass

Er³⁺-doped fluoroaluminate (AYF) glass was compared with fluorozirconate (ZBLAN) and tetraphosphate (PE) glass as a host material for 1.54-μm emission. Experimental results show that the Er³⁺:AYF glass has a smaller concentration quenching and much stronger intensity for the 1.54-μm emission. In high dopant, the 1.54-μm emission is two times stronger in Er³⁺/AYF glass than in ZBLAN glass, and 10 times stronger than in PE glass.     

Study of fluorine losses and spectroscopic properties of Er doped oxyfluoride silicate glasses and glass ceramics

The fluorine losses during synthesis of Er³⁺ doped transparent glasses in the SiO₂–PbO–PbF₂ system were investigated. The final fluorine contents of the glasses were detected by using a fluorine ion selective electrode. The results show that high fluorine losses are occured in the normal preparation processes. With the increase of initial PbF₂ contents or melting time resulted in the increase of the fluorine losses. The thermal and spectroscopic properties of the glasses and the corresponding glass ceramics were investigated through the analysis of the differential scanning calorimetry (DSC), absorption and upconversion luminescence spectra. The effects of fluorine contents show a decrease of the glass transition temperatures (Tg) of the glasses and an enhancement of upconversion intensity of the corresponding glass ceramics.     

Multicolor upconversion of Er3+/Tm3+/Yb3+ doped oxyfluoride glass ceramics

Er³⁺/Tm³⁺/Yb³⁺ tridoped oxyfluoride glass ceramics was synthesized in a general way. Under 980 nm LD pumping, intense red, green and blue upconversion was obtained. And with those primary colors, multicolor luminescence was observed in oxyfluoride glass ceramics with various dopant concentrations. The red and green upconversion is consistent with ⁴F_9/2 → ⁴I_15/2 and ²H_11/2, ⁴S_3/2 → ⁴I_15/2 transition of Er³⁺ respectively. While the blue upconversion originates from ¹G₄ → ³H₆ transition of Tm³⁺. This is similar to that in Er³⁺/Yb³⁺ and/or Tm³⁺/Yb³⁺ codoped glass ceramics. However the upconversion of Tm³⁺ is enhanced by the energy transfer between Er³⁺ and Tm³⁺.     

Structural and spectroscopic characterization of Yb doped Lu2O3 transparent ceramics

Yb³⁺ doped Lu₂O₃ transparent ceramics were fabricated by the solid-state reaction method and sintered in H₂ atmosphere. Structural and spectroscopic properties of Yb:Lu₂O₃ ceramics were studied. The Yb:Lu₂O₃ ceramic structure, and the lattice parameter are refined with the Rietveld method. Yb:Lu₂O₃ has broad absorption and emission bands with a long fluorescence lifetime (1.31 ms). The energy level diagram is calculated based on the absorption and emission spectra, Yb³⁺ in Lu₂O₃ ceramics exhibits a big splitting energy of the ²F_7/2 ground state (1023 cm⁻¹). Furthermore, the gain cross-section (σ_g) is estimated with different β values.     

Fabrication and properties of highly transparent Er:YAG ceramics

Highly transparent Er:YAG ceramics with different Er doping concentrations were fabricated by a reactive sintering method under vacuum. The optical properties and the microstructures of the Er:YAG ceramics were investigated. For 3 mm thickness samples, the in-line transmittances of the as-fabricated Er:YAG ceramics at the wavelength of 1100 nm and 400 nm were about 84% and 82%, respectively. The micrograph of the Er:YAG transparent ceramics exhibited a pore-free structure and the average grain size was about 10 μm. The grain boundary of the ceramics was clean and no secondary phase was detected. The absorption and emission spectra, the fluorescence decay traces of the Er:YAG ceramics were measured and discussed. The ceramics obtained may have potential use for eye-safe solid-state lasers partly replacing Er:YAG single crystals.     

Er3+/Yb3+ ions in a novel zinc borate glass: spectroscopic and physical properties

Journal of Materials Science: Materials in Electronics - Novel zinc borate glass doped with mixed rare-earth ions such as erbium (Er3+) and ytterbium (Yb3+) ions were prepared by conventional melt...     

Er3+离子掺杂透明的LaF3-SiO2纳米玻璃-陶瓷的上转换发光

采用溶胶-凝胶法成功制备了一系列Er3 掺杂的透明纳米LaF3-SiO2玻璃-陶瓷样品,并研究了其上转换发光性质与发光机制.研究得到了Er3 浓度对上转换发光的影响规律,拟合了上转换荧光强度与LD工作电流的关系,发现所得结果与理论值能够很好地一致.在980nm激光二极管激发下,获得了发射波长为520、540、660nm的有效上转换发光.在较低的功率泵浦下,540nm波长的绿光波段发射最强,其发光主要过程是处于4F7/2态的Er3 离子能量大部分被弛豫到4S3/2态,再由此激发态跃迁到基态4I15/2态所致.     

Crystallization and optical properties of a transparent mullite glass ceramic

Transparent mullite - based glass ceramics in the system SiO₂-Al₂O₃-B₂O₃-ZnO-K₂O were prepared. The activation energy of crystallization, the Avrami constants and the mechanism of crystallization of mullite were determined by the Matusita method through differential thermal analysis. X-ray diffraction and scanning electron microscopy methods were also used to determine the type and morphology of the precipitated crystalline phase. In addition, the degree of crystallinity was determined by the internal standard method. The results showed that bulk crystallization was the main mechanism for crystallization of the glasses. Optical absorption and photoluminescence properties of the obtained transparent glass-ceramics and their initial glasses were also studied. The glass-ceramics exhibited two emissions at 680 and 700 nm.     

Luminescence and energy transfer of Sm3+/Eu3+ co-doped transparent glass ceramics

Journal of Materials Science: Materials in Electronics - The Sm3+/Eu3+ doped transparent glass ceramics (GCs) containing Na7.15(Al7.2Si8.8O32) crystallite were successfully prepared by melt...     

Yb3+ and Er3+ co-doped Y2Ce2O7 nanoparticles: synthesis and spectroscopic properties

Yb³⁺ and Er³⁺co-doped Y₂Ce₂O₇ nanoparticles sintered at different temperatures were prepared by homogeneous co-precipitation method. The products were characterized by X-ray powder diffraction (XRD), energy-dispersive spectroscopy (EDS) and transmission electron microscopy (TEM). The results indicated that the particle sizes and morphologies of the samples were heavily influenced by the sintering temperature. As temperature increased, the particle sizes became gradually larger and more agglomerate. The emissions including green and red upconversion emissions were investigated under 980 nm excitation. The emission intensities of the samples also depended on the sintering temperature. Two photon processes were mainly responsible for green and red upconversion emissions.     

Fabrication of highly-transparent Er:CaF2 ceramics by hot-pressing technique

Highly-transparent trivalent erbium ion doped calcium fluoride (5 mol % Er:CaF₂) ceramics were fabricated by a hotpressing (HP) method using high-purity Er:CaF₂ nanoparticles, which were synthesized by co-precipitation method. The mean grain size of the nanoparticles was about 24.7 nm. The nanoparticles were sintered at 600 °C, 700 °C, 800 °C and 900 °C, respectively, for 30 min under a uniaxial pressure of 30 MPa and vacuum of 10^?3 Pa with 1 mol % lithium fluoride (LiF) as sintering additive. The 5 mol % Er:CaF₂ ceramics sintered at 800 °C exhibits high density and pore-free microstructure with an average grain size of about 8 μm. The optical transmittance of the transparent ceramics is close to 85 % at visible and nearinfrared wavelengths. The strong and broad absorptions peaks corresponding to characteristic absorption of trivalent erbium ions make the ceramics a potential candidate for infrared and upconversion laser operating.     

Emission properties of polymer composites doped with Er3+:Y2O3 nanopowders

In this work we report the recent results of our investigation on visible emission properties of the PMMA-based polymer nanocomposites doped with Er³⁺:Y₂O₃ nanopowders. The set of active nanopowders, and polymer films, differing in active ions concentration, was characterized with respect of their luminescent properties in the green spectral range, available to a limited extent for semiconductor lasers. In particular – the concentration dependent emission spectra and fluorescence dynamics profiles were measured under direct (single photon) and up-converted excitation, enabling the comparison of luminescent properties of developed nanocomposite materials and original nanopowders, optimization of erbium dopant concentration as well as discussion of excitation mechanisms and analysis of the efficiency of depopulation processes.     

Er3+单掺与Er3+/Yb3+共掺Y2SiO5的上转换发光

报道了一种新的上转换发光材料X2型Y2SiO5:Er, Yb并研究了Yb3 浓度和泵浦功率对样品的上转换发光特性的影响:(1)随着Yb3 浓度的增加,绿、红光发射均呈先增强后减弱的变化,但相对于绿光发射,红光发射受Yb3 浓度的影响更剧烈,并且当12%(摩尔分数)Yb3 时,可以得到很纯的红光发射;(2)上转换发光强度与泵浦功率的关系表明,双光子吸收贡献样品的上转换发射.此外,讨论了可能的上转换机制.认为随着Yb3 浓度增加,Er3 的激发态吸收、Yb3 到Er3 的能量传递和Er3 的交叉弛豫对上转换发光的作用依次逐渐加强.     

Optical dephasing of triply ionized rare earths in transparent glass ceramics containing LaF3 nanocrystals

Optical dephasing of Pr3+ and Tm3+ ions doped in transparent oxyfluoride glass ceramics was studied with the two-pulse photon echo technique. It was found that the dephasing time of rare earth ions is dramatically less in nanocrystals embedded in a glass matrix than in bulk crystals. A quasi-linear temperature dependence obtained at low temperatures proved that the long-range interaction of the ions inside the nanocrystals with the two level systems of the glass matrix dominates the optical dephasing. The local thermal effect in glass ceramics containing nanocrystals elevates the local temperature, which results in the reduction of optical dephasing time. For Tm(3+)-doped glass ceramics, the elevation of local temperature induced by the irradiation of excitation laser even quenched the photon echo signals in the experimental study.