共查询到20条相似文献,搜索用时 62 毫秒
1.
太钢3#高炉大修改造是集团公司重点外部工程项目之一,工程量大,工期紧,施工场地狭小,而质量要求较高。如何采取科学、经济的设备吊装方案,对整个项目经济指标的实现,意义重大。文章详细介绍了太钢3#高炉重力除尘器大件整体吊装方案。通过实际采用,取得良好的经济效果。 相似文献
2.
本文详细地阐述了氧化铝气力卸船机输送管道系统与臂架之间的支撑方案,通过确定支撑位置及形式,采用三弯矩方程计算垂直输送管道处于不同工作幅度时的支撑位置载荷,通过比较最终确定不同支撑形式的支撑载荷,为支撑装置的结构设计提供了载荷设计参数,确保结构设计的可靠性。 相似文献
3.
4.
5.
6.
韶钢4号高炉冷却塔工程,地质勘探表明,建设场地上层覆盖有5.1~7.0m厚的人工回填土,其承载力<130kPa.根据建筑荷载以及实际情况进行方案比选,采用了砂垫层换填法处理地基.经设计计算,砂垫层长、宽、厚分别为21.2、12.2和3.0m,并严格按现行有关规范进行施工.为了确保施工质量,砂垫层按照国标GBJ7-89附录四地基土载荷试验要点采用压重平台反力装置进行试验,结果表明:砂垫层累计沉降量为12.91~13.40mm,承载力基本值为240kPa,完全满足设计和使用要求,取得了缩短工期23d和节约工程投资20万元的经济效益. 相似文献
7.
8.
隔膜泵是一种应用于矿山、化工等领域的管道输送设备,其出料管口处受到管路系统所施加的力与力矩的作用,为了隔膜泵不被损坏,需要控制其受力情况,保证强度满足设计要求。通过在SolidWorks中建立三维模型,并进行有限元分析,得到了隔膜泵的变形及应力结果,校验了管口载荷与设备本身的匹配性。 相似文献
9.
三炼钢1号板坯连铸机大断面改造后铸坯输送辊道频频损坏、铸坯跑偏,通过改造辊道旧辊,改造辊道底座,选用底座固定式减速机,在传动系统中增设有吸振功能的十字万向联轴器,降低辊道冲击载荷尖峰值,明显增强设备抗冲击能力,有效地解决了铸坯跑偏问题。 相似文献
10.
11.
12.
对首钢两座高炉的锌负荷和碱金属负荷进行了研究,其锌负荷分别为497、680 g/t,碱金属负荷分别3.5673、.487 kg/t,均明显高于同行业标准。锌负荷和碱金属负荷偏高已影响高炉正常生产,必须尽快对高炉洗气灰等高锌物料进行脱锌处理,严密监视高炉碱金属平衡,在必要时采取排碱的技术措施。 相似文献
13.
14.
15.
童华 《有色冶金设计与研究》2009,30(3):13-15
在矿山钢井架的设计中,井架上的荷载就要人工统计和填写,而作用在井架上的荷载与一般的结构不同,荷载组合方式也不一样。以下告铁矿副井落地多绳钢井架设计为例,阐述钢井架的荷载计算,为钢井架设计提供借鉴。 相似文献
16.
鞍钢新轧钢公司厚板厂整体改造过程中,主电机需更换.根据新设备荷载,通过分析计算,对旧有基础进行加固利旧. 相似文献
17.
Selective attention has been hypothesized to reduce distractor interference at both perceptual and postperceptual levels (Lavie, 2005), respectively, by focusing perceptual resources on the attended location and by blocking at postperceptual levels distractors that survive perceptual selection. This study measured the impact of load on these selection mechanisms using a flanker paradigm (Eriksen & St. James, 1986) and indexing distractor interference as a function of separation. It distinguished changes in the extent of focus of the distractor-interference function of separation (reflecting perceptual selection) from changes in the amplitude of distractor interference not accompanied by changes in focus (reflecting postperceptual selection). It showed that: (1) the spatial profile of perceptual resources is shaped like a “Mexican hat” (Müller et al., 2005); (2) increasing perceptual load focuses perceptual resources (Caparos & Linnell, 2009); (3) increasing cognitive load defocuses perceptual resources; and (4) participants with reduced working-memory span show reduced postperceptual blocking of distractors. While these findings are consistent with two levels of selective attention, they show that the first perceptual level is affected not only by perceptual but also by cognitive-control mechanisms. (PsycINFO Database Record (c) 2010 APA, all rights reserved) 相似文献
18.
Caparos and Linnell (2009, 2010) used a variable-separation flanker paradigm to show that (a) when cognitive load is low, increasing perceptual load causes spatial attention to focus and (b) when perceptual load is high, decreasing cognitive load causes spatial attention to focus. Here, we tested whether the effects of perceptual and cognitive load on spatial focus remain when, respectively, cognitive load is high and perceptual load is low. We found that decreasing cognitive load only causes spatial attention to focus when perceptual load is high and the stimulus encourages this. Moreover, and contrary to the widely held assumption that perceptual load focuses attention automatically (Lavie, Hirst, de Fockert, & Viding, 2004), perceptual load exerts its focusing effect only with the engagement of cognitive resources when cognitive load is low. In sum, perceptual and cognitive mechanisms exert interacting effects and operate in concert to focus spatial attention. (PsycINFO Database Record (c) 2011 APA, all rights reserved) 相似文献
19.
连杆式钢包回转台动载荷特性研究 总被引:2,自引:0,他引:2
针对连杆式钢包回转台结构动态设计要求,通过计算机模拟钢包加载过程,分析了连杆式钢包回转台在不同冲击载荷模式作用下的动载荷特性,讨论了结构动载荷系数的取值规律,现场实机测试表明,实际加载过程中所表现的动载荷特性与理论结果一致,从而为钢包回转台动态设计和动载荷系数的选取提供了可靠的理论依据。 相似文献
20.
介绍了电能表的三个调节装置及三个调节装置间的影响量 ,一次性调整法 ,就是将三个调节装置按估算所得分别调到其最佳位置 ,可使调整一次完成。 相似文献