巯基包覆CdSe和CdSe/CdS核壳纳米晶的水相合成与表征

利用水相合成的方法制备了巯基包覆的具有较高荧光量子产率的CdSe和CdSe／CdS纳米晶．水相合成方法的优点是原料低廉、安全可靠和重复性高，缺点是纳米晶的尺寸分布较宽，发光效率不是很高．采用X-射线粉末衍射、吸收和荧光等光谱手段对纳米晶的平均尺度、粒径分布、晶体结构及发光特性进行了表征。在77K到300K的温度范围内，随着温度降低，CdSe纳米晶的发光峰逐渐蓝移，而CdSe／Cds纳米晶发光峰位基本不随温度变化而变化．此外，在325nm激光辐照下，CdSe／CdS纳米晶的荧光寿命比CdSe纳米晶延长了6倍左右，稳定性大幅度提高．以上结果表明，核壳结构的CdSe／CdS纳米晶具有较高的发光效率和良好的稳定性，具有广阔的应用前景．     

Hole Surface Trapping in CdSe Nanocrystals: Dynamics, Rate Fluctuations, and Implications for Blinking

Carrier trapping is one of the main sources of performance degradation in nanocrystal-based devices. Yet the dynamics of this process is still unclear. We present a comprehensive investigation into the efficiency of hole transfer to a variety of trap sites located on the surface of the core or the shell or at the core/shell interface in CdSe nanocrystals with both organic and inorganic passivation, using the atomistic semiempirical pseudopotential approach. We separate the contribution of coupling strength and energetics in different systems and trap configurations, obtaining useful general guidelines for trapping rate engineering. We find that trapping can be extremely efficient in core-only systems, with trapping times orders of magnitude faster than radiative recombination. The presence of an inorganic shell can instead bring the trapping rates well below the typical radiative recombination rates observed in these systems.     

水相中CdSe与核/壳CdSe/CdS量子点的制备与发光特性研究

以巯基乙酸为稳定剂在水相中制备了CdSe与核/壳型CdSe/CdS量子点水溶胶, 用紫外-可见吸收光谱和发射光谱研究了它们的发光特性, 并且用X射线粉末衍射(XRD)、透射电镜(TEM)和X射线光电子能谱(XPS)表征了它们的结构、形貌和化学组成, 结果表明使用该方法制备的量子点分散性良好, 而且用CdS对CdSe进行表面修饰以后的发光强度明显提高, 发射光谱和吸收光谱都有红移现象, 不同粒径颗粒的吸收峰的位置也有所不同.     

Properties of electrospun CdS and CdSe filled poly(methyl methacrylate) (PMMA) nanofibres

Electrospinning technique was used to fabricate poly(methyl methacrylate) (PMMA) fibres incorporating CdS and CdSe quantum dots (nanoparticles). Different nanoparticle loadings (2, 5 and 10 wt% with respect to PMMA) were used and the effect of the quantum dots on the properties of the fibres was studied. The optical properties of the hybrid composite fibres were investigated by photoluminescence and UV-vis spectrophotometry. Scanning electron microscopy (SEM), X-ray diffraction and FTIR spectrophotometry were also used to investigate the morphology and structure of the fibres. The optical studies showed that the size-tunable optical properties can be achieved in the polymer fibres by addition of quantum dots. SEM images showed that the morphologies of the fibres were dependent on the added amounts of quantum dots. A spiral type of morphology was observed with an increase in the concentration of CdS and CdSe nanoparticles. Less beaded structures and bigger diameter fibres were obtained at higher quantum dot concentrations. X-ray diffractometry detected the amorphous peaks of the polymer and even after the quantum dots were added and the FTIR analysis shows that there was no considerable interaction between the quantum dots and the polymer fibres at low concentration of quantum dots however at higher concentrations some interactions were observed which shows that QDs were present on the surfaces of the fibres.     

Comparative behavior of CdS and CdSe quantum dots in poly(3-hexylthiophene) based nanocomposites

CdS and CdSe nanoparticles have been prepared using conducting poly(3-hexylthiophene) (P3HT) matrix with an objective to understand the effect of nanoparticles on the polymer matrix using electrochemical and spectroscopic techniques. The spectroscopic results reveal that the electronic structure of polymer is strongly influenced by the characteristics of embedded semiconducting nanoparticles. SEM and TEM images show the ordered morphology of the CdS and CdSe nanoparticles in presence of the polymer matrix. Cyclic voltammetry performed both in the presence and absence of light enables us to understand the redox changes in P3HT due to CdS and CdSe quantum dots such as the generation of free radical in the excited state and their electrochemical band gaps.     

CdSe量子点/PVK复合电双稳器件的制备及载流子输运性能研究

报道一种基于CdSe量子点/聚乙烯基咔唑有机无机复合电双稳器件,通过对量子点浓度的控制使器件在室温下可以通过正向偏压和负向偏压脉冲激励下实现高阻态与低阻态的相互转变,相当于存储器件的写入功能与擦除功能,并且可实现重复的“读-擦-读-写”操作.对电流-电压曲线和电容-电压曲线展开讨论,验证器件的载流子捕获与释放机制,阐述载流子在该器件的输运机制.     

A White Light‐Emitting Quantum Dot Complex for Single Particle Level Interaction with Dopamine Leading to Changes in Color and Blinking Profile

The interaction of the neurotransmitter dopamine is reported with a single particle white light‐emitting (WLE) quantum dot complex (QDC). The QDC is composed of yellow emitting ZnO quantum dots (Qdots) and blue emitting Zn(MSA)₂ complex (MSA = N‐methylsalicylaldimine) synthesized on their surfaces. Sensing is achieved by the combined changes in the visual luminescence color from white to blue, chromaticity color coordinates from (0.31, 0.33) to (0.24, 0.23) and the ratio of the exponents (α_on/α_off) of on/off probability distribution (from 0.24 to 3.21) in the blinking statistics of WLE QDC. The selectivity of dopamine toward ZnO Qdots, present in WLE QDC, helps detect ≈13 dopamine molecules per Qdot. Additionally, the WLE QDC exhibits high sensitivity, with a limit of detection of 3.3 × 10^?9m (in the linear range of 1–100 × 10^?9m ) and high selectivity in presence of interfering biological species. Moreover, the single particle on–off bilking statistics based detection strategy may provide an innovative way for ultrasensitive detection of analytes.