Ruthenium dye-sensitized SnO2/TiO2 coupled solar cells

The photoelectrochemical behaviors of RuL₂(NCS)₂ dye-sensitized SnO₂/TiO₂ coupled solar cell was studied and compared with TiO₂ single system. The coupled system shows higher incident photon-to-current conversion efficiency (IPCE) value than the single system. A maximum IPCE value in the coupled system with 3.5 μm-thick SnO₂ and 7 μm-thick TiO₂ attained 82.4% at 530 nm wavelength. The higher IPCE value in the coupled system is attributed to the charge separation by fast electron transfer process from the excited RuL₂(NCS)₂ dye to TiO₂ to SnO₂ in the system with different energy level.     

Partial scan design and test sequence generation based on reduced scan shift method

This paper presents a partial scan algorithm, calledPARES (PartialscanAlgorithm based onREduced Scan shift), for designing partial scan circuits. PARES is based on the reduced scan shift that has been previously proposed for generating short test sequences for full scan circuits. In the reduced scan shift method, one determines proch FFs must be controlled and observed for each test vector. According to the results of similar analysis, PARES selects these FFs that must be controlled or observed for a large number of test vectors, as scanned FFs. Short test sequences are generated by reducing scan shift operations using a static test compaction method. To minimize the loss of fault coverage, the order of test vectors is so determined that the unscanned FFs are in the state required by the next test vector. If there are any faults undetected yet by a test sequence derived from the test vectors, then PARES uses a sequential circuit test generator to detect the faults. Experimental results for ISCAS'89 benchmark circuits are given to demonstrate the effectiveness of PARES.     

Gel chromism and anomalous luminescence in poly(3-alkylthiophene)

The absorption spectrum of poly(3-alkylthiophene) gel changes drastically in association with a volume instability upon changing the solvent composition and also the temperature. In the expanded state in chloroform and at high temperature, the photoluminescence is much enhanced compared with the shrunken state in ethanol and at low temperature. This gel chromism and anomalous luminescence are discussed in terms of the change of effective conjugation length induced by the steric hindrance and the dynamics of the photoexcited species.     

Air gap flux analysis for cage rotor diagnosis

The relationship between the magnetomotive force distribution of a three-phase induction motor and various cage rotor faults, such as broken bars and end rings, is discussed in detail. Search coil output and its harmonic components are analyzed to allow the determination of faults from the air-gap flux density. The results obtained in tests on a motor into which faults were intentionally introduced confirm the effectiveness of this method of analysis.     

Structural study of degraded ZnMgSSe blue light emitters

Using electroluminescence (EL) topography and transmission electron microscopy (TEM), we investigated the nonluminescent regions which form while current is being injected into ZnMgSSe/ZnSSe/ZnCdSe-based blue light emitters. Small dark spots were observed just after turn-on and spread out forming rough nonluminescent triangles in the <100> directions in the EL image of the active region. TEM studies showed that the small dark spots are pre-existing stacking faults originating at the substrate/epitaxial layer interface. The nonluminescent triangles were found to be a dense region of dislocation dipoles and dislocation loops. Each dipole was aligned along two <110> directions in the {111} planes. The Burgers vectors were of the type a/2<011> inclined at 45° to the (001) junction plane.     

Trace elements in human transitory milk. Variation caused by biological attributes of mother and infant

Multielement analysis was performed on human milk collected on 5-9-d postpartum from 51 Japanese females using inductively coupled plasma (ICP) mass spectrometry (MS), ICP atomic emission spectrometry (ICP-AES) and fluorometry. Thirty-one elements were detected by these analytical methods in milk. Twelve elements (Na, Mg, P, S, K, Ca, Cu, Zn, Se, Sr, Rb, and Mo) were detected in all of the samples. Al, Cs, and Ba were the elements detected by ICP-MS in more than half of the samples. Multiple regression analysis extracted biological attributes of mother and infant, such as maternal stature, maternal wt, or infant's birth wt, as statistically significant factors contributing to the variation in elemental concentration in milk. However, the rates of contribution were small in all cases. It was concluded that the biological attributes of mother and infant examined in this study were not the major factors that contribute to elemental variation in human milk.     

Distributed architecture for energy management D-structure

Electric power systems are expanding in size and complexity, and the requirement for the energy management system (EMS) is becoming more important. In this computer control system, a single control computer is used mainly as the primary computer and its software is very complicated because of its hugh number of small, quick tasks to obtain high response speed. Therefore, much effort is needed to develop and modify the programs, and the responsiveness of this centralized architecture varies greatly when many faults occur in the power system. This paper describes a new distributed architecture for the EMS. Distributed processors execute the functions cooperatively with periodic access to the common bulletin board database in which information about the power system exist. This architecture facilitates the software development and maintenance, and it also enhances the performance by the parallel processing of the distributed functions.