Operational aspects of adsorption air‐conditioner used in diesel locomotive

A locomotive cabin adsorption air‐conditioner has been equipped in #DF4B‐2369 locomotive; and has been successfully run for 2 years. It is powered by waste heat from the exhaust of the diesel engine. The influence on heat transfer is described by the equivalent heat transfer coefficient or thermal resistance of components inside the adsorber. The variation of adsorption capacity is expressed by a non‐equilibrium adsorption function. The dynamic heat transfer process of adsorption air‐conditioning system is treated with the lumped parameter method. Some typical running experimental results are present. The diesel engine rotating speed and locomotive speed influenced on the refrigeration system are discussed. The maximum mean refrigeration power is regarded as an objective function. Based on experiments and theoretical analysis, the running characteristics of the air‐conditioning system are optimized. Some techniques of performance improvement are suggested as well. Copyright © 2006 John Wiley & Sons, Ltd.     

Two‐phase production of cyclohexene and cyclooctene oxides in water as an approach to pollution prevention

Liquid–liquid two‐phase epoxidation from cyclohexene and cyclooctene in aqueous potassium peroxymonosulfate (commercially available as Oxone^®) solution was studied as an application in pollution prevention. To avoid potential emissions of volatile organic compounds an aqueous solution was employed to replace the usual chlorinated solvents used in epoxide production. A droplet column reactor and stirred tank reactor were used to investigate two‐phase synthesis of epoxide. An aqueous Oxone^® solution was used to oxidize a dispersion of alkene droplets and form epoxide. The study of aqueous epoxidation in both reactors showed that the epoxidation of alkenes can be represented as a first order reaction with respect to alkene. The salting out effect of Oxone^® concentration was studied in both reactors and found to be very similar at optimal conditions. In comparing the two reactors, it was found that the droplet column reactor produces larger quantities of product per unit reactor volume for the same reaction time. The objective of this study is to provide an alternative reactor design and synthesis route that can meet pollution prevention goals. Copyright © 2004 Society of Chemical Industry     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

The radiation crosslinking and scission of ethylene-propylene copolymers studied by solid-state nuclear magnetic resonance

Methyl groups from chain scission and H-crosslinks have been identified by solid-state nuclear magnetic resonance in amorphous ethylene-propylene copolymers containing 23 and 36 mole % propylene after γ-irradiation to 10 MGy at 30°C. G (scission) and G (crosslink) values determined from the n.m.r. spectra and by extraction are in agreement, which suggests that the crosslinks are not clustered. This may differ from the situation in polyethylene where there is a substantial crystalline content. G(S). G(X) and the ratio G(S)/G(X) increase with increasing propylene content of the copolymers.     

Implementing Information Systems: Some Practical Advice and a Richer Model

Recent research suggests that implementing information systems presents considerable difficulties and that many implementations are total or partial failures. This paper argues that what both practitioners and students require are richer and more acceptable models of information systems implementation. Accordingly, case study data concerning the introduction of manufacturing resource planning (MRP II) are used to illustrate five patterns of behaviour (rites) which capture important social actions; and four components of changing psychological orientation. It is argued that appreciation of the rites and psychological developments identified here will support effective change programmes. Guidelines based on our model are provided for practitioners.     

Effects of viscosity on the bitterness and astringency of grape seed tannin

To examine the separate effects of viscosity and sweetness on astringency, aqueous solutions of grape seed tannin (GST) were thickened with carboxymethyl cellulose (CMC) from 2 to 45 cP (experiment 1) or sweetened with 0 to 1.8 g/L aspartame (experiment 2). Trained subjects continuously rated astringency and bitterness in duplicate. Subjects were categorized by the salivary flow induced by citric acid and ability to taste n-propyl thiouracil (PROP). In experiment 1, maximum intensity and total duration of astringency were significantly decreased as viscosity rose, although time to maximum intensity of astringency was not affected. Maximum intensity and total duration of bitterness were not significantly affected by increasing viscosity; however, the onset of bitterness was significantly delayed. In experiment 2, increasing sweetness had no affect on any astringency parameter, although maximum intensity of bitterness was significantly decreased. Neither PROP nor salivary flow-status had any effect on perception of bitterness or astringency in either experiment.     

辐射对血液流变效应的研究及动物全身照射后全血粘度的变化规律

本文结果表明经一次大剂量全身照射后的机体血液流变的主要特性为全血表观粘度先高粘后低粘的双向性变化,从照后第一天起即升高。随着放射病病程的发展,在早期有一个高粘峰,其峰均值比照前升高47.80％。但因不同动物、不同剂量、不同均速,不同血源而变化不同。