Alumina-supported catalysts for propane oxidative dehydrogenation from mixed VXM(6−X)O19 (M=W, Mo) hexametalate precursors

γ-Al₂O₃ supported vanadium oxides were modified by tungsten and molybdenum oxides in order to improve dispersion and selectivity towards olefins in propane oxidative dehydrogenation (ODH). Both vanadium–tungsten and vanadium–molybdenum catalysts were obtained by adsorption of mixed isopolyanions (VW₅O₁₉⁵⁻, V₂W₄O₁₉⁴⁻, VMo₅O₁₉⁵⁻ and V₂Mo₄O₁₉⁴⁻) from aqueous solutions. The isopolyanion solutions were characterized by UV-Vis and ⁵¹V NMR spectroscopy. Vanadium, vanadium–tungsten and vanadium–molybdenum precursors and catalysts were also characterized by UV-Vis (diffuse reflectance) and solid state ⁵¹V NMR spectroscopy. An improved selectivity to propene in the presence of tungsten and molybdenum in VO_x/γ-Al₂O₃ was observed and attributed to dilution of vanadium by tungsten or molybdenum oxides on the γ-Al₂O₃ surface.     

Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling.

The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two separate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4. 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO4(3-) in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO4(3-) molar ratio in digested sludge was low, by increasing the pH alone (using NaOH) the precipitation of PO4(3-) was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduce PO4(3-) recycling back to the plant. For long-term operation, maximum PO4(3-) reduction should be the ultimate aim to minimise PO4(3-) accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO4(3-) reduction in the digested sludge was achieved.     

An expert system with temporal reasoning for alarm processing inpower system control centers

The alarm lists presented to control center operators are usually difficult to interpret. The authors present an expert system that processes the alarm lists in Portuguese control centers. This system makes an intelligent synthesis of the available information and presents it in a flexible and structured way. It uses an original approach to deal with temporal reasoning and real-time constraints. The system incorporates an explanation module that enables its use as a tutor for novice operators     

Robustness of VS-MRAC with respect to unmodelled dynamics and external disturbances

A variable structure model reference adaptive controller (VS-MRAC) using only input and output measurements was recently proposed and shown to be globally asymptotically stable with superior transient behaviour and disturbance rejection properties. In this paper a singular perturbation approach is used in order to establish the robustness of the controller in the presence of unmodelled dynamics (parasitics) and disturbances. We develop a new Lyapunov-based technique to analyse the overall system and show that for sufficiently small parasitics the system remains stable and the output error is small in some sense.     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

A boost-type converter for DC-supply of fluorescent lamps

A boost type converter is described that is suitable for low-voltage DC-supply of fluorescent lamps. It has inherent lamp current limitation (ballast action) and provides the high voltage pulses and electrode heating that are required for igniting the lamp. The proposed circuit is applicable in automotive, emergency, and portable light sources.<>     

Isolation and preliminary characterization of Pichia pinus mutants insensitive to glucose repression

A new method for the isolation of glucose repression-insensitive mutants in the methylotrophic yeast Pichia pinus was developed. The method is based on screening of small suspension samples derived from 2-deoxyglucose-resistant colonies for alcohol oxidase activity. Alcohol oxidase activity was evaluated by determination of formaldehyde excreted by cells. Mutants with glucose non-repressible alcohol oxidase and catalase synthesis were obtained. All mutants grew poorly on D -xylose compared to the wild type, whereas growth on L -arabinose was similar to the wild type. Changes in the glucose transport system were suggested to be responsible for altered growth characteristics and defective glucose repression.     

Total and acid-soluble fluoride content of infant cereals, beverages and biscuits from Brazil

Total fluoride (TF) and HCl 0.01 M ('gastric juice')-soluble fluoride (SF) were analysed in infant foods, beverages and calcium-rich biscuits. Samples were divided into seven categories: children cereals (A), chocolate-flavoured milk (B), soy beverages (C), filled biscuits (D), non-filled biscuits (E), wafer biscuits (F) and corn starch biscuits (G). Mean TF concentrations ± SD (amplitude, unit µg F ml^-1 or µg F g^-1) were: (A) 4.25 ± 3.04 (0.20 - 7.84, n = 6); (B) 0.34 ± 0.47 (0.05-1.27, n = 6); (C) 0.15 ± 0.07 (0.09-0.29, n = 8); (D) 8.44 ± 1.76 (7.65-10.47, n = 4); (E) 12.41 ± 1.15 (10.69-13.68, n = 4); (F) 0.35 ± 0 (0.34-0.36, n = 4) and (G) 7.77 ± 1.12 (6.86-8.68, n = 2). Five samples of cereals, one sample of chocolate-flavoured milk and 10 samples of biscuits were analysed for SF. In cereals analysed for SF, all fluoride was soluble, while for the chocolate-flavoured milk, approximately 50% of TF was soluble. Regarding the biscuits analysed for SF approximately 20% of TF was soluble. It was observed that some of the cereals and beverages, and most of the biscuits analysed, might be important contributors to total daily fluoride intake. When consumed just once per day, cereals and beverages might supply up to 25% of the maximum recommended daily fluoride intake (0.07 mg F kg^-1 body weight) for a 2-year-old child (12 kg). For the filled, non-filled and corn starch biscuits, when 3, 32 or 20 units of them, respectively, are consumed just once per day, they may supply up to 16% of the maximum recommended daily fluoride intake. However, only approximately 25% of fluoride absorption occurs from the stomach and 75% from the small intestine. Therefore, a higher fluoride bioavailability is possible.