Nonstationary Simulation Model of Absorber with Falling Film of Suspension

A nonstationary model of SO₂ absorption from a gas phase to a countercurrent falling film of absorbing slurry was developed. Laminar, wavy and turbulent film structures were considered based on published information. Resistances to the mass transfer on the gas and the liquid sides of the interphase were considered, together with chemical reactions in the liquid phase. Relevant chemical equilibria in the liquid phase were modeled. Original experimental data on the neutralization reagent dissolution rate presented as a polydispersed two‐phase system of solids and on the rate of dissolved sulfite oxidation were used. The model was verified with experimental data from a laboratory‐scale falling‐film absorber using a single vertical tube under various geometrical and operating conditions, and a very good agreement was found with the experiment. Parametric sensitivity analysis showed the critical parts of the model.     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Topical use of aprotinin in open heart operations

Among various pharmacological agents used to reduce bleeding after open-heart operations, high-dose aprotinin therapy seems most promising. However, its long-term effects are still obscure; there is almost always possibility of bypass graft occlusions produced by the hypercoagulable state induced by aprotinin in coronary bypass operations. Topical application of aprotinin into the pericardial cavity could prevent the adverse effects. Fifty patients were prospectively studied to evaluate the effects of topical aprotinin. One million KIU of aprotinin was poured into the pericardial cavity before closure of the sternotomy in group 1 (n = 25). Patients in group 2 (n = 25) served as controls. Total postoperative bleeding was significantly reduced in group 1 when compared with that of group 2 (722.7 +/- 230.8 versus 1,282.6 +/- 225.7 mL; p < 0.01). The use of banked donor blood products was significantly less in group 1 than in group 2 (0.33 +/- 0.67 versus 1.36 +/- 0.86 units; p < 0.01). These results show that topical use of aprotinin reduces post-operative blood loss and need for transfusion. It seems promising and warrants further studies to be done.     

Alternative fatty food simulants for migration testing of polymeric food contact materials.

The amounts of substances migrating from plastics into foodstuffs with high fat contents are in most cases higher than in foodstuffs with water contents. This increase in migration commonly is due to the higher solubility of the migrating organic compounds in fat compared to water. The increase in migration is not necessarily due to an increase in the substance's diffusion coefficient due to interactions between the fat and the plastic as is often assumed. Ethanol is a good simulant for fatty foods because it has little interaction with many plastics, e.g. polyolefins, migrants are readily soluble in it, and because it is easy to work with analytically. The utilizable limits of ethanol and ethanol/water mixtures as food simulants are developed from the physical background of diffusion. The use of ethanol and ethanol/water mixtures is supported by published experimental migration results.     

Endogenous adenosine exerts inhibitory effects upon the development of spreading depression and glutamate release induced by microdialysis with high K+ in rat hippocampus

Spreading depression (SD) is known to be involved in the N-methyl-D-aspartate receptor-mediated neuronal damage. In urethane-anesthetized rats, we examined the release of adenosine and glutamate during SD induced by microdialysis of high K+ perfusate through the hippocampal CA1 area. The effects of endogenous adenosine upon SD were studied by applying an adenosine antagonist, theophylline (1 mM) and by a simultaneous application of adenosine uptake blockers, dipyridamole (DPR) (100 microM) and nitrobenzylthioinosine (NBI) (50 microM). The dialysates were sampled every 5 or 10 min and analyzed by HPLC. SD was identified by flattening of background EEg and disappearance of population spikes recorded from the pyramidal cell layer of CA1 area by a glass microelectrode. Adenosine and glutamate release was enhanced significantly in association with the occurrence of SD. Theophylline increased the release of glutamate and the incidence of SD and decreased the latency of the SD occurrence. DPR+NBI decreased the release of glutamate and the occurrence of SD, but increased extracellular adenosine concentration. The effects of DPR+NBI were blocked by application of a selective antagonist of adenosine A1 receptor, 8-cyclopentyl-1,3-dipropylxanthine (DPCPX, 0.1 microM). These findings suggest that endogenous adenosine exerts inhibitory influences upon the development of SD and the glutamate release through the A1 receptor in rat hippocampus.