γ-radiation effects on metal oxide particles and their wetted surfaces

ABSTRACT

Typical metal oxide corrosion products of structural materials have been irradiated with γ-rays in ultra-pure water to investigate the effect of radiation on the surface oxide and the nature of adsorbed water. Analysis techniques including thermal gravimetric analysis, differential thermal analysis, diffuse reflectance infrared Fourier transform spectroscopy, and X-ray photoelectron spectroscopy before and after γ-irradiation were employed to investigate surface structural effects and adsorbed water behaviour. The production of H₂ in the oxide nanoparticle mixtures was investigated by gas chromatography to probe the mechanism of radiolysis in the water/oxide mixtures and the relationship with surface water. The nature of water at the surface of the oxides was affected by γ-radiation and the relationship was dependent on the particle composition. The rate of H₂ production was shown to be oxide dependent, and higher rates of H₂ formation were attributed to the decomposition of surface adsorbed water. Changes to the surface chemistry and H₂ production rates were found to be highly dependent on the surface chemistry of the metal oxide nanoparticle and no bulk structural changes were observed.     

Attitudes towards regionalism in a rapid growth suburb

A key issue confronting our newer suburbs is the stance they should take towards efforts at regional cooperation and coordination of major policy areas. This article analyzes the preferences on this issue held by residents in a rapid growth suburb in the St. Louis metropolitan area. Through factor analysis, four identifiable dimensions of regionalist preferences were obtained from questionnaire responses--administrative cooperation, land-use cooperation, mass transit cooperation, and regional basic services cooperation. Correlational analyses between these dimensions of regionalist preferences and selected community status characteristics, social situation characteristics, and local political participation status of respondents reveal no systematic covariation. Thus municipal policies which influence the population mix within a community with respect to the life situation characteristics measured in this study are not likely to be useful instruments for influencing the preferences, pro or con, of the community towards regionalist policies. Further, local political participants are found to be representative of the larger community's regionalist policy preferences.     

Modeling investment priorities for national road improvements: A case study of Korea

The paper addresses specific problems associated with formulating investment priorities for national road improvements in Korea. More specifically, the objectives of the paper are (1) to present a model for formulating investment priorities for road improvements that may be useful to developing countries, (2) to test the model with simplified data for deriving investment priorities for Korea's road improvements, and (3) to learn lessons that can be applicable to other developing countries with particular respect to recommending investment priorities for road improvements. The study results are useful for planners, in developing countries, and also for evaluation analysts in funding institutions who are confronted with evaluating investment priorities for deteriorating road conditions.     

Mobilization of lead from human bone tissue during pregnancy and lactation--a summary of long-term research

The skeleton is potential endogenous source of lead during pregnancy and lactation. We have undertaken a longitudinal investigation into the mobilization of lead from the human maternal skeleton to determine whether lead is mobilized from the maternal skeleton during pregnancy and lactation, and if so, when and how much is released. Subjects in the study were migrants to Australia (n=15) whose skeletal lead isotopic composition (endogenous lead) was different to that prevailing in the Australian environment (exogenous lead). This migrant cohort was compared with 6 multi-generational Australian controls. Biological and environmental samples were taken pre-pregnancy where possible, throughout pregnancy and postpartum for at least 6 months. Newly-born infants of the migrant and Australian mothers were monitored for 6 months. Blood lead concentrations for the migrant mothers ranged from 1.5 to 20 microg/dl (geometric mean 2.8) and for Australian mothers ranged from 1.9 to 4.3 microg/dl (geometric mean 2.9). There was minimal change in lead isotopic composition of the Australian pregnant controls although there were increases of approximately 40% in blood lead concentration in 3 of 6 cases during the postpartum period and from 0 to 12% in the other 3. In the migrant pregnant subjects, the geometric mean skeletal lead contribution to blood lead using the isotopic composition was approximately 33% (range 10-88%) for 14 subjects using a revised estimate for exogenous lead. Skeletal contribution to blood lead during the postpartum period was significantly greater than during pregnancy (P<0.001). The skeletal contributions to blood lead are higher and the changes are more consistent in those subjects who conceived within 100 days of arrival in Australia compared with those who conceived longer than 100 days. In the migrant subjects, changes in blood lead concentration during pregnancy and postpartum varied from subject to subject with an overall 20% increase; the increases during the postpartum period were greater than during pregnancy (P<0.001). It was estimated that the amount of maternal skeletal lead mobilized during pregnancy and transferred to the infant via cord blood averaged approximately 79%. The increased skeletal contribution to blood lead is attributed to a low daily calcium intake of approximately 500 mgCa/day, a condition which was present in both migrant and Australian subjects. An ongoing clinical trial is providing a new cohort with calcium supplements. A summary of other aspects of the study is included and covers: additional flux released from the skeleton during pregnancy and postpartum; XRF bone lead results; urinary excretion of lead during pregnancy and postpartum; dietary contribution to blood lead in female adults and children; comparison of rates of exchange of lead in blood of newly-born infants and mothers; relationships of lead in breast milk to lead in blood, urine and diet of the infant and mother; changes in blood lead after cessation of breastfeeding; urinary lead isotopes during pregnancy and postpartum indicate no preferential partitioning of endogenous lead into plasma; a comparison of some aspects of the nonhuman primate and human pregnancy studies.     

The 20th century whole-basin trophic history of an inter-drumlin lake in an agricultural catchment

Eight 1-m sediment cores were extracted from across the basin of Friary Lough, a 5.4-ha eutrophic lake in a wholly grassland agricultural catchment in Co. Tyrone, Northern Ireland. Sedimentary TP, diatom inferred TP, Ca, Na, Fe, Mn, loss-on-ignition (LOI), dry weight and density were determined in the core profiles. Core dating and correlation gave a 210Pb, 137Cs and 241Am chronology from 1906 to 1995 and enabled a whole-basin estimate of chemical and sediment accumulation rate over the 20th Century. The major changes for all parameters occurred after c. 1946. Sediment accumulation rate was most influenced by organic matter accumulations, probably of planktonic origin, and increasing after c. 1946. Inorganic sediment accumulation rate was found to be largely unchanging through the century at 10 t km(-2) yr(-1) when expressed as catchment exports. All chemical accumulation rate changes occurred after c. 1946. Total phosphorus accumulation rate, however, was found to be the only chemical to be increasing throughout the epilimnion and hypolimnion areas of the sedimentary basin at an average of 22.5 mg m(-2) yr(-1) between 1946 and 1995. The other chemical parameters showed increasing accumulation rates after c. 1946 in the epilimnion part of the basin only. Interpreted in terms of whole-basin sedimentation and catchment export processes over time, it is suggested that diffuse TP inputs are independent of sediment inputs. This corresponds to hydrochemical models that suggest soluble P as the primary fraction that is lost from grassland catchments. The increase in sedimentary TP accumulation rate, and DI-TP concentration, are also explained with regard to current models that suggest increases in runoff P concentrations from elevated soil P concentrations. Increases in eplimnion chemical and sediment accumulation rate after c. 1946 may be due to local erosion that has limited impact on lake basin sedimentation.     

Toxicity bioassay of heavy metals in water using Tetrahymena pyriformis

The toxicities of five heavy metal compounds on the survival of the ciliated protozoan Tetrahymena pyriformis were determined. Three-day old cultured cells were exposed to five concentrations of each test compound in one or more of three water series; distilled, soft, and hard water. A culture of each sample was placed in a plastic petri dish and covered with mineral oil to prevent evaporation. The cells were counted initially, then again at 0·5 h, 1 h, 2 h, 1 day, 2 days, 3 days, and on the fourth day. Lethal threshold concentrations and tolerance limit medians were determined by graphic methods. On a weight bases cadmium was most toxic, followed in decreasing toxicity by mercury, cobalt, zinc, and lead. Compared to similar fish data, all heavy metals were more toxic to T. pyriformis except lead. The toxicity of lead in soft versus hard water exemplified an antagonistic effect with greater than seven times the amount of lead necessary in hard water to produce comparable mortality as lead in soft water. On the other hand, the toxicity of mercury is about twice as great in hard water as in soft water (a synergistic effect). T. pyriformis appears to be a more sensitive indicator than fish of heavy metal contamination of water. T. pyriformis bioassay should prove a good means of determining the existence of many water pollutants.     

Arsenic-sulfides confound anion exchange resin speciation of aqueous arsenic

A field-portable anion exchange resin method (often cited as the Ficklin method (1983)) has been extensively used to distinguish between dissolved arsenite (As(III)) and arsenate (As(V)) species in natural waters. As(III) occurs largely as As(OH)(3), which is uncharged at ca. pH 7, while As(V) is negatively charged and will sorb to the resin. However, we show that negatively charged As(III)-sulfide (thioarsenite) species, important at sulfide concentrations >10 microM, also bind to the anion exchange resins, and therefore might be interpreted incorrectly as As(V). Furthermore, we show that nitrogen-purging, which results in a conversion of As(III)-sulfides to arsenite, can be used to obtain accurate arsenic speciation when resins are used on sulfidic water samples.     

Object–Oriented Enterprise Modeling and Simulation of AEC Projects

In this paper we describe an object–oriented framework for developing enterprise models of Architecture, Engineering, Construction projects, and a methodology for formalizing these models such that they can be used for discrete event simulation of information processing and coordination in project execution. The simulation results can be used to predict the probable effects of carrying out proposed changes in planning and managing projects.
In our enterprise modeling framework we represent engineering design projects in terms of deliverables (requirements and solutions), plans (activities and process relations), and organization (participants and organizational relations). The resulting project model is the starting point for identifying coordination requirements between project team participants. Our methodology uses matrix techniques derived from qualtiy function deployment (QFD) to identify interactions between project requirements and solutions and calculate measures of product complexity . We then describe information flow between project activities in a similar matrix and calculate measures of process uncertainty . Finally, we identify the responsibilities of project team members and use a matrix to point out organizational interdependencies .
We apply our framework and methodology to model and simulate engineering design for a major extension of an electrical power substation. Our simulation results demonstrate how project performance is contingent on the fit between the project policies and the objectives and preferences of the project team.     

Cigarette characteristics,smoker characteristics,and the relationship to cigarette fires

Data were collected from eight cities on a wide range of cigarette and smoker characteristics for a sample of smokers. Of these, 564 smokers had had fires and were identified through fire department response to those fires, while the other 1,611 smokers had not had fires and were identified through a telephone sample survey of the communities. The characteristics analyzed included those that had shown evidence of a relationship to the risk of a cigarette-initiated fire, either in laboratory studies or in previous statistical analyses of fire experience.The smoker characteristics analyzed were household income, education, age, gender, and race. The cigarette characteristics analyzed were filter, tobacco column length, filter length, circumference, density, amount of tobacco, menthol, citrate, porosity, and pack type. In addition, a variable was used to control for the smoker's city.After controlling for all smoker characteristics and city, logistic regression modeling showed four cigarette characteristics to be significant: filter, filter length, porosity, and type of pack. Filter, filter length, and porosity all affect air intake, which, therefore, appears to be an important physical element in the combustion process associated with risk. Analysis limited to filtered cigarettes only showed the same characteristics to be significant, plus tobacco column length. Extension of the analysis to two-way interaction terms did not change any of the conclusions on which cigarette characteristics are important, but it did indicate that the role of pack type was different for men and women.Sensitivity analyses, shown in the appendix, supported the main conclusions that cigarette characteristics are significant after controlling for smoker characteristics and that the four specific cigarette characteristics—filter, filter length, porosity, and pack—are the ones that are significant. These analyses checked the impact of cluster sampling, sensitivity to missing data on smoker characteristics, and sensitivity to nonfire smoker cases with responses by people other than the smokers themselves.All this means that there are already cigarettes commercially available that exhibit a reduced propensity for ignition when one controls for smoker characteristics.This report was originally written as the final report in June 1993 as part of CPSC-P-91-1147 Contract Cigarette Fire Incident Study that the National Fire Protection Association conducted for the U.S. Consumer Product Safety Commission.Harwood, formerly with the Consumer Product Safety Commission, is retired.     

First evidence for the reliability of building co-heating tests

This paper provides powerful evidence empirically demonstrating for the first time the reliability of the co-heating test. The test is widely used throughout Europe to measure the total heat transfer through the fabric of buildings and to calculate the heat-transfer coefficient (HTC; units W/K). A reliable test is essential to address the ‘performance gap’, where in-use energy performance is consistently, and often substantially, poorer than predicted. The co-heating test could meet this need, but its reliability requires confirmation. Seven teams independently conducted co-heating tests on the same detached house near Watford, UK. Despite differences in the weather and in the experimental and analytical approaches, the teams’ final reported HTC measurements were within ±10% of the mean. With further standardization it is likely to be possible to improve upon this reproducibility. Furthermore, uncertainty analysis based upon a 95% confidence interval resulted in an estimated uncertainty in HTC measurements of ±8%. This research addresses persistent doubts about the reliability of the co-heating test. Avenues to further improvement of the test are discussed. This work helps to enable the test’s wider adoption as a component of the regulatory process and thus improvements to standards of house construction.