Development of Anticandidal Delivery Systems: (I) Anticandidal Activities of Antifungal Agents and Synergistic Combination with Other Drugs

Susceptibility testing with antifungal agents, e. g., minimum inhibitory concentration (MIC) determination, is performed to obtain reliable data that permit selection of the most suitable agents for treatment of an infective condition. To determine the drugs that provide maximum effectiveness against oral candidiasis, the MICs of various antifungal agents were determined. Also, synergism between two chosen antifungal agents was evaluated, and the effect of benzocaine, an anesthetic, and hydrocortisone, an antiinflammatory agent, on their MICs was examined. It was observed that among all the drugs tested, clotrimazole was the most promising candidate for use as an oral local antifungal. The combination of clotrimazole and chlorhexidine resulted in a decrease in the MIC. While the addition of hydrocortisone to this combination resulted in a slight increase in the MIC, the inclusion of benzocaine resulted in a substantial decrease in the MIC of the antifungal agent combination.     

On the kinetics of the autoxidation of fats: influence of pro‐oxidants,antioxidants and synergists

The influence of minor amounts of pro‐ and anti‐oxidants on the kinetics of the autoxidation of fat has been evaluated. The reaction rates of oxygen with the substrates were found to follow the same basic equation, hitherto established for pure substrates. There is evidence that the surface of the reaction vessel also acts as a reaction catalyst and its effect is proportional to the area of glass in contact with lipids. Oxidation is enhanced by trace metal ions as well as by surface‐active compounds (e.g. hydroperoxides and sterols). Antioxidants such as α‐tocopherol and butylated hydroxyanisole inhibit the oxidation by delaying the start of oxygen consumption (the induction period) while retarders like amino acids only decrease the rate of oxidation. Thus pro‐ and anti‐ oxidants affect either the start or the rate of oxygen consumption. The empirical formula dx/dt = k [O₂] (1‐x/n) f′(t) was found applicable to the different stages of oxidation.     

Iterative interference cancellation for high spectral efficiencysatellite communications

The problem of efficient utilization of the frequency spectrum for satellite systems is investigated; one which results as a consequence of highly crowding adjacent channels. An analytical characterization of the resulting interference channel is introduced and then exploited for interference cancellation. Two classes of cancelers are investigated. The first approach does not benefit from the forward error control (FEC) coding information which limits the performance gain. This motivates the second approach where a joint implementation of interference cancellation and decoding is developed using soft-input-soft-output (SISO) modules along with the iterative structure. It is shown that iterative interference cancellation techniques can achieve significant gains compared with the single-user matched filter receiver     

On Iron Metabolism and Its Regulation

Iron is a critical metal for several vital biological processes. Most of the body’s iron is bound to hemoglobin in erythrocytes. Iron from senescent red blood cells is recycled by macrophages in the spleen, liver and bone marrow. Dietary iron is taken up by the divalent metal transporter 1 (DMT1) in enterocytes and transported to portal blood via ferroportin (FPN), where it is bound to transferrin and taken up by hepatocytes, macrophages and bone marrow cells via transferrin receptor 1 (TfR1). While most of the physiologically active iron is bound hemoglobin, the major storage of most iron occurs in the liver in a ferritin-bound fashion. In response to an increased iron load, hepatocytes secrete the peptide hormone hepcidin, which binds to and induces internalization and degradation of the iron transporter FPN, thus controlling the amount of iron released from the cells into the blood. This review summarizes the key mechanisms and players involved in cellular and systemic iron regulation.     

Physicochemical investigation of the decomposition products of ammonium metal carboxylates: ammonium ferric citrate hydrate

The thermal decomposition up to 400 °C of ammonium ferric citrate hydrate, of unknown structure and formula weight, was studied by thermogravimetry, differential thermal analysis, infrared (IR) spectroscopy and X-ray diffractometry. The possible identities of the formula weight and the intermediate products of calcination are discussed. The results revealed that the parent material is amorphous and contains two moles of water and two moles of ammonia. Decomposition takes place via six weight-loss processes, three endothermic (90–230 °C) and three exothermic (240–298 °C), leading eventually to the formation of Fe₂O₃. The intermediate solid products are mainly unstable amorphous oxycarbonates, as indicated by X-ray and IR spectroscopies. The gas-phase decomposition products identified by IR spectroscopy are NH₃, CO₂, CO, CH₃COCH₃, CH₄ and NH₄OH. Surface area measurement and scanning electron microscopy showed that Fe₂O₃, the final product at 400 °C, hada surface area of 40 m²/g and good crystalline and porous character.     

Quantitative estimation of sucrose esters of plamitic acid

Thin layer chromatography was adapted for direct quantitative estimation of sucrose esters of palmitic acid. Urea-phosphoric acid spray was used to detect the sucrose moiety of the various esters. The photometrically metermined density density of each spot on the thin layer plate was found to be proportional to its sucrose content. Ester content was then obtained by multiplying sucrose found by the factor, mol. wt. ester/mol. wt. sucrose. Ester mixtures were prepared by interesterifying sucrose with various proportions of methyl palmitate in dimethylformamide solution. Positional isomers were observed at each level of substitution but could not be adequately separated from each other for quantitative evaluation. Presented at the AOCS Meeting, Minneapolis, October 1969. So. Utiliz. Res. Dev. Div., ARS, USDA.     

Modification of sandy soil using water‐borne polymer

A new polymeric system has been applied for structural modification of (noncompactable) sandy soils. The system is based on a water‐borne styrene acrylic polymeric formulation (emulsion) containing varying amounts of solid polymer. The present work deals with system optimization and measurements designed to examine the effects of polymer content on hydraulic conductivity and compressive strength. Samples were prepared from prescribed amounts of polymer, water, and sand by using two different preparations methods (mixing and spraying). Measurements of hydraulic conductivity for both sets of samples were conducted in a flexible membrane test apparatus. For the first set of samples, the permeability coefficient of the sand was noted to be reduced 10‐fold (from 10^?5 to 10^?6 m s^?1) upon the incorporation of about 2% polymer. In the second set (samples prepared with the spraying method), the hydraulic conductivity was further reduced to 7.2 × 10^?7 at a polymer concentration of about 2%. Stress–strain measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. For both types of preparation methods, the compressive strength and modulus of elasticity increased linearly with the polymer concentration in the sample. Scanning electron microscopic examination revealed that the dramatic reduction in the permeability and the improved mechanical properties are attributed to the polymer coverage of the sand particles and the development of interconnecting ties between them. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 2484–2491, 2003     

Mathematical Analysis and Performance Evaluation of the Cell-Free mMIMO Networks Based on Cognitive Relays

Wireless Personal Communications - The cell-Free massive multiple input multiple output “mMIMO” networks can provide a satisfied performance for the fifth generation “5G”...     

Assessing information quality of e-learning systems: a web mining approach

E-learning systems provide a promising solution as an information exchanging channel. Improved technologies could mean faster and easier access to information but do not necessarily ensure the quality of this information; for this reason it is essential to develop valid and reliable methods of quality measurement and carry out careful information quality evaluations. This paper proposes an assessment model for information quality in e-learning systems based on the quality framework we proposed previously: the proposed framework consists of 14 quality dimensions grouped in three quality factors: intrinsic, contextual representation and accessibility. We use the relative importance as a parameter in a linear equation for the measurement scheme. Formerly, we implemented a goal-question-metrics approach to develop a set of quality metrics for the identified quality attributes within the proposed framework. In this paper, the proposed metrics were computed to produce a numerical rating indicating the overall information quality published in a particular e-learning system. The data collection and evaluation processes were automated using a web data extraction technique and results on a case study are discussed. This assessment model could be useful to e-learning systems designers, providers and users as it provides a comprehensive indication of the quality of information in such systems.