Flexural properties of moldings of rigid polyurethane made by reaction injection molding

Flexural properties of moldings made by Reaction Injection Molding (RIM), which are structural foams consisting of high density skin and low density core, were investigated by three-point bending tests. Two failure modes were observed in bending tests of the moldings made by RIM, and they are classified as follows according to the density ratio of skin layer to core layer: the opposite side of the skin layer to which load was subjected failed by tensile stress: and the same side of the skin layer to which load was subjected failed by compressive stress, causing wrinkling or buckling. Then the conventional composite beam theory was applied to the former failure mode and Hoff s buckling theory to the latter, and equations were derived to predict the flexural properties of the structural foams, which involved buckling from the flexural properties of solid construction. In addition, it has been shown that there exists a density distribution that maximizes the flexural strength of the moldings made by RIM with a given overall density. The results obtained here should be useful to the optimum structural design of moldings made by RIM.     

Copolymerization of methylmethacrylate on a ball-milled surface of coal at 77 K

The ball-milling of coal with methylmethacrylate monomer was carried out under vacuum at 77 K and at room temperature and in air. The e.s.r. and i.r. spectra of ball-milled material showed that a copolymer of coal and methylmethacrylate was formed on the surfaces of coal created by ball-mining. Oxygen is an inhibitor to this process.     

Fibrous support for immobilization of enzymes

A poly(vinyl alcohol) (PVA) fiber support incorporating various aminoacetal functional groups has been developed for immobilizing enzymes. The aminated PVA fiber seems to adsorb enzymes with electrostatic force of attraction; thus the immobilization procedure is simple. By the use of this fiber having immobilized enzymes, the reaction between enzymes and substrates is nearly independent of the size of subtstrates. This newly developed type of fiber, which is formed by a mass superfine fibers (SFF), each measuring 1 μm or less in diameter, permits much more increased surface area than the conventional enzyme immobilization supports. Our studies of the properties of the fiber for immobilization of enzymes show the following results: (1) SFF has a greater ability for the immobilization of invertase than ordinary fibers; (2) dimethyl-aminated SFF has the best performance for the immobilization of invertase. From these results, it is concluded that the dimethyl-aminated SFF is an excellent support for the immobilization of invertase.     

In-situ monitoring of the stabilization with hydrogen of free radicals thermally induced from coal using high pressure e.s.r., d.t.a. and p.d.a. equipment

High temperature, high pressure e.s.r. measurements of the hydrogenation reaction of Taiheiyo coal in the presence of catalysts were carried out to understand the stabilization of thermally and/or catalytically induced free radicals. A decrease in free radical concentration with increasing temperature was observed for ZnCl₂ and SnCl₂ · 2H₂O catalysts at 10MPa under hydrogen gas. High pressure modified single-cell d.t.a. and p.d.a. equipment augmented the uniquely designed high temperature, high pressure e.s.r. cell. The hydrogenation reaction was monitored under the same experimental conditions as for e.s.r. From the results of the combination of high temperature, high pressure e.s.r. with high pressure d.t.a. and p.d.a., it was established that H₂ molecules can react efficiently with free radicals from coal molecules created by the presence of ZnCl₂ and SnCl₂ · 2H₂O catalysts.     

Tele‐Cocooning: Mobile Texting and Social Scope

The present study examines the tele‐cocooning hypothesis in the context of general trust using a nationally representative survey of Japanese youth. We find that although frequency of texting is positively correlated with general trust, this correlation is spuriously caused by how heavy mobile texters interpret the words “most people” in the general trust measurement. Heavy users assume that “most people” only refers to friends, family, and others going to the same school. When the effect of the “most people” assumption is controlled, the positive association between texting and general trust disappears. Further exploration of the data shows that heavy texting nevertheless has negative implications for social tolerance and social caution, both of which are theoretically proximate to general trust.     

Development and Use of a Kinetical and Real-Time Monitoring System to Analyze the Replication of Hepatitis C Virus

In microbiological research, it is important to understand the time course of each step in a pathogen’s lifecycle and changes in the host cell environment induced by infection. This study is the first to develop a real-time monitoring system that kinetically detects luminescence reporter activity over time without sampling cells or culture supernatants for analyzing the virus replication. Subgenomic replicon experiments with hepatitis C virus (HCV) showed that transient translation and genome replication can be detected separately, with the first peak of translation observed at 3–4 h and replication beginning around 20 h after viral RNA introduction into cells. From the bioluminescence data set measured every 30 min (48 measurements per day), the initial rates of translation and replication were calculated, and their capacity levels were expressed as the sums of the measured signals in each process, which correspond to the areas on the kinetics graphs. The comparison of various HuH-7-derived cell lines showed that the bioluminescence profile differs among cell lines, suggesting that both translation and replication capacities potentially influence differences in HCV susceptibility. The effects of RNA mutations within the 5′ UTR of the replicon on viral translation and replication were further analyzed in the system developed, confirming that mutations to the miR-122 binding sites primarily reduce replication activity rather than translation. The newly developed real-time monitoring system should be applied to the studies of various viruses and contribute to the analysis of transitions and progression of each process of their life cycle.     

Mechanism of elongation of gold or silver nanoparticles in silica by irradiation with swift heavy ions

It has been reported that elongated Au nanoparticles oriented parallel to one another can be synthesized in SiO₂ by ion irradiation. Our aim was to elucidate the mechanism of this elongation. We prepared Au and Ag nanoparticles with a diameter of 20 nm in an SiO₂ matrix. It was found that Au nanoparticles showed greater elongated with a higher flux of ion beam and with thicker SiO₂ films. In contrast, Ag nanoparticles split into two or more shorter nanorods aligned end to end in the direction parallel to the ion beam. These experimental results are discussed in the framework of a thermal spike model of Au and Ag nanorods embedded in SiO₂. The lattice temperature exceeds the melting temperatures of SiO₂, Au and Ag for 100 ns after one 110 MeV Br¹⁰⁺ ion has passed through the middle of an Au or Ag nanorod.     

Bulk heterojunction organic solar cells utilizing 1,4,8,11,15,18,22,25-octahexylphthalocyanine

Bulk heterojunction solar cells utilizing soluble phthalocyanine derivative, 1,4,8,11,15,18,22,25-octahexylphthalocyanine (C6PcH₂) have been investigated. The active layer was fabricated by spin-coating the mixed solution of C6PcH₂ and 1-(3-methoxy-carbonyl)-propyl-1-1-phenyl-(6,6)C61 (PCBM). The photovoltaic properties of the solar cell with bulk heterojunction of C6PcH₂ and PCBM demonstrated the strong dependence of active layer thickness, and the optimized active layer thickness was clarified to be 120 nm. By inserting MoO₃ hole transport buffer layer between the positive electrode and active layer, the FF and energy conversion efficiency were improved to be 0.50 and 3.2%, respectively. The tandem organic thin-film solar cell has also been studied by utilizing active layer materials of C6PcH₂ and poly(3-hexylthiophene) and the interlayer of LiF/Al/MoO₃ structure, and a high V_oc of 1.27 V has been achieved.     

An Opportunistic Directional MAC Protocol with Pulse/Tone Exchange in Wireless Ad-Hoc Networks

Wireless Personal Communications - This paper proposes a Medium Access Control (MAC) protocol using directional antennas in wireless ad-hoc networks, which achieves frame-collision reduction,...     

Sweep‐out flow of film condensation on vertical plates with horizontal grooves

We have investigated fluid flow characteristics of film‐wise condensation on vertical plates with horizontal periodic grooves. Condensate stays at the edge of the grooves due to the surface tension. The condensate starts to flow, however, when the balance between the surface tension and the condensate's own weight is broken. It is found that the condensate flows downward successively and periodically from the top part of the plate as a group. In addition, we have obtained the relation between the frequencies of the periodic flow and the degree of sub‐cooling for two different pitches of the grooves. © 2009 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20249