Effect of intrathecal nimodipine on spinal cord blood flow and evoked potentials in the normal or injured cord

A method was developed for administering intrathecal pharmacotherapy in a rat model of spinal cord injury. The effects of intrathecal administration of nimodipine on spinal cord blood flow (SCBF) and evoked potentials (EPs) were measured in the normal and injured spinal cord. It had previously been shown that systemic nimodipine caused severe hypotension after spinal cord injury. After baseline SCBF and EPs, 15 uninjured rats were blindly allocated to one of three groups: one placebo group (n = 5); and two groups with intrathecal nimodipine, 0.05 mg/kg (n = 5), or 0.2 mg/kg (n = 5). Ten other rats received a 35 g acute clip compression injury of the spinal cord for 1 minute and, were allocated to one of two groups: placebo (n = 5); and intrathecal nimodipine 0.05 mg/kg (n = 5) given 60 min after injury. In the uninjured groups, neither 0.05 nor 0.2 mg/kg of nimodipine increased SCBF during, or 30 min after, intrathecal infusion. However, the mean arterial blood pressure (MABP) decreased significantly to 69.73.1% after the infusion of 0.2 mg/kg nimodipine and did not recover by 98 min. In all three groups of uninjured rats, the amplitude of the cerebellar EP was decreased 30 min after infusion. After spinal cord injury, there were significant decreases in MABP, SCBF and EP amplitude in both placebo and treatment groups, but there was no therapeutic benefit from nimodipine. Thus, intrathecal infusion of nimodipine did not prevent the hypotension encountered with systemic administration and exerted no beneficial effect on SCBF or EPs after acute spinal cord injury.     

Observation of cold-rolling texture and partially recrystallized texture in polycrystalline 3 pct Si-Fe by high-resolution electron backscattered diffraction

Cold-rolling texture and partially recrystallized texture of polycrystalline 3 pct Si-Fe were investigated using high-resolution electron backscattered diffraction (EBSD) method. From the measurement on a deformed grain with {211}〈011〉∼{111}〈011〉 orientations, deformation bands with {12 4 1}〈014〉 orientation were found. It turned out that the orientation rotation relationship between deformation bands and surrounding deformed grain can be explained by the activation of the slip system, which has a common slip plane with an adjacent grain. Oriented nucleation of recrystallized grains with {12 4 1}〈014〉 orientation was observed in a deformed grain with {211}〈011〉∼{111}〈011〉 orientation. Exactly the same orientation relationship that was observed between deformed grain and the deformation bands was also observed between the deformed grain and the recrystallized grain. A hypothesis that recrystallization nuclei are generated directly from the deformation bands formed by an activation of the slip system that has a common slip plane of neighboring deformed grains was proposed from the present experimental results.     

Coupling ratio control of polymeric waveguide couplers by bending

Directional couplers are successfully fabricated on acrylic substrates using polymers synthesised from deuterated methacrylate and deuterated fluoromethacrylate monomers. The excess loss of a 50 mm long coupler is about 0.7 dB including waveguide and fibre coupling losses. A novel method is proposed for tuning the coupling ratio. By bending the coupler, high precision control of within 1% is attained without optical polarisation dependence.<>     

Creep Crack Growth in Polypropylene Film with Various Crack Lengths at Diverse Stresses and Temperatures

Creep crack growth rates were measured using centrally cracked tension specimens of thin polypropylene film with different crack lengths at various stresses and temperatures. The creep crack growth rates were correlated with the stress intensity factor. There was the region of the minimum constant crack growth rate which occupied more than 70% of the total creep failure life. This constant creep crack growth rate characteristics were analyzed on the basis of the stress-dependent Arrhenius type thermally activated process.     

Fate of the human liver after hemihepatic portal vein embolization: cell kinetic and morphometric study

The favorable therapeutic effect of preoperative portal vein embolization (PVE) was analyzed by assessing various volumetric, cell kinetic and morphometric parameters and examining histologically the embolized and nonembolized lobes of 15 patients who underwent extended right lobectomy 2 to 3 weeks after PVE. Each lobar volume was calculated from computed tomography (CT) images, hepatocyte proliferation was evaluated by assessing proliferative cell nuclear antigen (PCNA) expression and mitosis, hepatocyte apoptosis was evaluated by the terminal deoxyribonucleotidyl transferase-mediated dUTP nick end labeling (TUNEL) assay, and the hepatocyte numerical density as well as the sinusoidal volumetric ratio (Vvs) and the mean hepatocyte volume (Cv) were calculated using morphometric methods. PVE induced hepatocyte apoptosis and atrophy of the embolized lobe (from 798 +/- 213 to 708 +/- 222 cm3; P < .05). The increased sinusoidal volume in this lobe (17.7% +/- 4.5% and 21.7% +/- 5.7%, periportal and pericentral area, respectively) may have been attributable to hepatocyte deletion. Cells in the nonembolized lobe entered a highly active phase of proliferation within 2 weeks after PVE. Further evidence of cellular proliferation was provided by the increased nonembolized lobar volume (from 379 +/- 132 to 545 +/- 130 cm3; P < .01) and numerical density of hepatocyte nuclei (Nv) (5.38 +/- 1.26 vs. 3.11 +/- 0.85 x 10(5)/mm3; P < .01, nonembolized vs. embolized lobe, respectively). In conclusion, these results indicate that the favorable effect of PVE is attributable to a net gain of functional hepatocyte mass and/or early induction of hepatocyte proliferation following hepatectomy.     

Care of esophageal cancer patients with diabetes mellitus--preoperative management and treatment

The care of esophageal cancer patients with diabetes mellitus is described. The main points are as follows. 1. Prevention and control of infection. 2. Sufficient nutritional support (2000 Kcal/day) and hydration. 3. Control of plasma glucose level (150 mg/dl-250 mg/dl) by means of insulin. 4. An absence of ketone bodies and minimum glucose level (< 10 g/day) in the urine. 5. Prevention and control of hypoglycemia. Good control of diabetes mellitus in esophageal cancer patients may contribute to reduced surgical rislcs.     

Treatment of highly fouling waste waters with tubular membrane systems

Membrane fouling by suspended solids is a severe problem in reverse osmosis or ultrafiltration of highly fouling feed streams. Tubular membrane systems are inherently fouling resistant and can be automatically mechanically cleaned at regular intervals by a sponge ball cleaning device. The use of this type of system to process a number of highly fouling feed streams difficult to treat by membrane processes is described     

Measurement of the melting points of oligomers obtained in the manufacture of poly(ethylene terephthalate)

The melting points (T_m) were measured for oligomers obtained by a direct continuous esterification process between terephthalic acid and ethylene glycol. Multiple regression analyses of data were carried out, and an equation was obtained for predicting melting points with correlation coefficient of ～0.99.     

Effect of pressure on phase transition and morphology of bulk poly(trans-1,4-butadiene)

The effect of pressure on the melting, solid-solid transition, and crystallization of poly(trans-1,4-butadiene) (PTBD) was investigated using the pressure range of 1–3000 kg/cm². D.t.a. measurements showed that, the melting and transition temperatures increase with increasing pressure, whose pressure coefficients are 38°C per 1000 kg/cm² and 22°C per 1000 kg/cm², respectively. These values were in fairly close agreement with those calculated from the Clausius-Clapeyron equation. Morphological studies using electron microscope and small-angle X-ray scattering method revealed that, the samples crystallized with relatively small supercoolings under normal or high pressure, are formed of distinct lamellae 400–800 Å thick. The lamellar thickness was inappreciably dependent on crystallization pressure. The significant effect of pressure on crystallization was recognized in a tendency of the crystallinity to increase, with increasing crystallization pressure. This pressure effect was explained by the mechanism that, the increased pressure might make the packing of molecular chains in liquid, more dense and that the secondary crystallization might be accelerated, to increase the lateral dimensions of lamellae.     

An Estimation of Complexity and Computational Costs for Vertical Block-Cyclic Distributed Parallel LU Factorization

The Vertical Block–cyclic Distributed Parallel LU Factorization Method (VBPLU) is effectively processed on a distributed memory parallel computer. VBPLU is based on the two techniques, the block algorithm and the aggregation of communications. Since startup time dominates the data communication and the aggregation reduces communication isssues, the total performance has been much improved. Furthermore this method uses long vectors so that it is also advantageous on vector processors. In this paper, we have constructed a modeling of VBPLU using a simplified LogGP model with analytical formulae, and estimated accurately the computational cost taking into account load distributions caused by data layout and process mapping. Some knowledge for optimization of block algorithm has been obtained. Our estimations have been verified through numerical experiments on three different distributed memory parallel computers.