全文获取类型
收费全文 | 1418篇 |
免费 | 22篇 |
国内免费 | 3篇 |
专业分类
电工技术 | 81篇 |
综合类 | 2篇 |
化学工业 | 419篇 |
金属工艺 | 46篇 |
机械仪表 | 33篇 |
建筑科学 | 21篇 |
能源动力 | 97篇 |
轻工业 | 125篇 |
水利工程 | 9篇 |
石油天然气 | 1篇 |
无线电 | 117篇 |
一般工业技术 | 256篇 |
冶金工业 | 43篇 |
原子能技术 | 45篇 |
自动化技术 | 148篇 |
出版年
2023年 | 6篇 |
2022年 | 16篇 |
2021年 | 20篇 |
2020年 | 13篇 |
2019年 | 23篇 |
2018年 | 14篇 |
2017年 | 14篇 |
2016年 | 27篇 |
2015年 | 18篇 |
2014年 | 48篇 |
2013年 | 105篇 |
2012年 | 80篇 |
2011年 | 80篇 |
2010年 | 72篇 |
2009年 | 91篇 |
2008年 | 79篇 |
2007年 | 63篇 |
2006年 | 54篇 |
2005年 | 52篇 |
2004年 | 37篇 |
2003年 | 49篇 |
2002年 | 42篇 |
2001年 | 25篇 |
2000年 | 33篇 |
1999年 | 37篇 |
1998年 | 35篇 |
1997年 | 16篇 |
1996年 | 29篇 |
1995年 | 15篇 |
1994年 | 17篇 |
1993年 | 20篇 |
1992年 | 22篇 |
1991年 | 15篇 |
1990年 | 12篇 |
1989年 | 16篇 |
1988年 | 12篇 |
1987年 | 5篇 |
1986年 | 10篇 |
1985年 | 15篇 |
1984年 | 11篇 |
1983年 | 7篇 |
1982年 | 9篇 |
1981年 | 13篇 |
1980年 | 16篇 |
1979年 | 9篇 |
1978年 | 11篇 |
1977年 | 9篇 |
1976年 | 5篇 |
1968年 | 3篇 |
1967年 | 3篇 |
排序方式: 共有1443条查询结果,搜索用时 0 毫秒
1.
Shijie Zhu Yutaka Kagawa Jian-Wu Cao Mineo Mizuno 《Metallurgical and Materials Transactions A》2004,35(9):2853-2859
Time-dependent deformation in an enhanced SiC/SiC composite has been studied under constant load at high temperatures of 1200
°C, 1300 °C, and 1400 °C. Creep damage evolution was evaluated by a Young’s-modulus change of partial unloading and microscopic
observation. The addition of the glassy phase in the matrix is very effective for protecting the composite from oxidation.
The transient creep is dominant in creep life at all the temperatures. An empirical equation is proposed to describe creep
behavior of the composite. It is found that creep activation energy increases with creep time at stresses lower than matrix
cracking stress, but the activation energy remains constant at stresses higher than the matrix cracking stress. The creep
strain rate of the composite is considered to be controlled by creep of fibers based on examining the time, strain, stress,
and temperature dependencies of creep strain rates. 相似文献
2.
Hirokazu Ikeda Chikara Fukunaga Yutaka Saitoh Masahiro Inoue Junko Yamanaka 《Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment》1996,380(3):618-622
The radiation tolerance for prototype front-end chips designed for a silicon micro-strip detector was examined with a 60Co irradiation source to establish an allowable range of the radiation dose. The irradiated front-end chips were SMA2SH-64A, a 64-channel preamplifier array; SMA2SH-1, a single-channel preamplifier circuit with a comparator; and Control-C, a digital-control chip for the preamplifiers. 相似文献
3.
When West meets East: Contributions of Eastern traditions to the future of psychotherapy. 总被引:1,自引:0,他引:1
Bankart C. Peter; Koshikawa Fusako; Nedate Kaneo; Haruki Yutaka 《Canadian Metallurgical Quarterly》1992,29(1):141
Discusses 2 interrelated traditions as they are reflected in contemporary and traditional approaches to psychotherapy in Japan. One uses various meditational and self-focusing instructional sets whose common goal is to facilitate the slowing down, deepening, and clearer focusing of sensory and interpersonal awareness. The 2nd tradition focuses on physical self-regulation and autonomic self-control through exercises that foster enhanced voluntary control over physical states and processes. Eastern psychology offers a set of practices that help the individual overcome the inherent selfishness of his/her isolated experience. The goals of such work include recognition of gratitude to important people in the client's life, rediscovery of the joy of meaningful work, and the experience of a unifying cosmic consciousness. (PsycINFO Database Record (c) 2010 APA, all rights reserved) 相似文献
4.
Yutaka Kokai Akira Fukuhara Ken'Ichi Morita Tatsunori Kanke Mamoru Kata Tatsuo Hayashi Toru Takenuki 《Electrical Engineering in Japan》1992,112(6):59-74
Electric power systems are expanding in size and complexity, and the requirement for the energy management system (EMS) is becoming more important. In this computer control system, a single control computer is used mainly as the primary computer and its software is very complicated because of its hugh number of small, quick tasks to obtain high response speed. Therefore, much effort is needed to develop and modify the programs, and the responsiveness of this centralized architecture varies greatly when many faults occur in the power system. This paper describes a new distributed architecture for the EMS. Distributed processors execute the functions cooperatively with periodic access to the common bulletin board database in which information about the power system exist. This architecture facilitates the software development and maintenance, and it also enhances the performance by the parallel processing of the distributed functions. 相似文献
5.
When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected. 相似文献
6.
The behaviour of the amorphous chain in vulcanized natural rubber (NR) and styrene-butadiene rubber (SBR) under extension is studied by means of the cylindrical distribution function (CDF) derived from wide angle X-ray scattering (WAXS). In the case of the highly stretched vulcanized NR where the orientation-induced crystallization took place, the observed WAXS intensity was separated into a crystalline peak component and a broad amorphous one from which the CDF was obtained. The CDF calculated from the broad component shows that some of the amorphous segments of the highly stretched vulcanized NR are extended as fully as the crystalline chains and that the fraction of the segments increases with increasing extension. In the case of SBR, such fully stretched segments as in the case of the vulcanized NR show higher degree of an interchain packing order than those in the vulcanized NR. 相似文献
7.
The wax esters of sperm whale head oil have been characterized by gas-liquid chromatography on an APOLAR 10C column according
to their carbon number and number of double bonds. The novel technique permits the direct quantitative analysis of saturated
and unsaturated wax esters. 相似文献
8.
Somsak Vivatpanachart Hiroyasu Nomura Yutaka Miyahara Hisatsugu Kashiwabara Masato Sakaguchi 《Polymer》1981,22(7):896-901
E.s.r. spectra of chain-end spin labels on the surface of polyethylene powder were obtained for high and low density polyethylene samples at various stages of heat treatment process. The subsequent crystalline structures of the samples were examined with wide angle and small angle X-ray diffraction spectra. The effects of annealing on the motion of the labels were dependent on annealing temperature and the type of the samples. Higher temperature annealing decreased the rotational correlation times (τc) and their activation energy in high density polyethylene but did not affect those of low density polyethylene. Melting decreases the values of τc and ΔE for both high an low density polyethylene samples. The cause of these decreases were attributed to the changing of the sites of the chain-end labels. The motion of the labels appeared to be influenced by the local segmental motion of the polymer main chains. 相似文献
9.
Joo-Young Lee Yota Yamamoto Riichi Oe Su-Young Son Hitoshi Wakabayashi Yutaka Tochihara 《Ergonomics》2014,57(8):1213-1221
The purpose of this study was to investigate the physiological and subjective responses of the European, Japanese (JPN) and US firefighters' helmet, gloves and boots for international standardisation. Three experimental conditions were evaluated (clothing mass: 9.4, 8.2 and 10.1 kg for the three conditions, respectively) at the air temperature of 32°C and 60% relative humidity. The results showed that there was no significant difference among the three conditions in oxygen consumption, heart rate, total sweat rate, rectal temperature and mean skin temperature, whereas peripheral temperatures and subjective perceptions were lower in the JPN condition than in the other conditions (P < 0.05). These results indicate that a 0.5-kg reduction in helmet mass and a 1.1-kg reduction in boot mass during exercise resulted in a significant decrease in head and leg temperatures and subjective perceptions, while a 1.9-kg reduction in total clothing mass had insignificant influences on the metabolic burden and overall body temperature. 相似文献
10.
Tomohiro Hashiguchi Yutaka Takita Kazuyuki Tajima Toru Katagiri 《Journal of Network and Systems Management》2016,24(3):557-577
Shared protection/restoration is a promising solution for reducing protection resources and is supported at each layer of the current multi-layer networks. Software-defined networking is expected to reduce equipment cost as well as operational cost by orchestrating these shared protection functionalities. However, although protection resource sharing improves link utilization, it sometimes increases the required equipment. Meanwhile, traffic re-aggregation at each layer is an important technique for low volume traffic to utilize the underlying link capacity more efficiently, but re-aggregation also makes it difficult to share protection resources with traffic at lower layers. In this paper, we present multi-layer network design strategy and method that reduce equipment cost by means of both traffic re-aggregation at each layer and protection resource sharing among multiple service traffic at different layers. The strategy first prioritizes traffic re-aggregation at each layer, and then maximally delegates shared protection to lower layers as long as it does not increase the required capacity at the lower layer. Evaluation results from the example three-layer networks confirm that the proposed method can effectively reduce equipment cost compared to the conventional design method. Cost reduction is achieved by leveraging shared protection functions at multiple layers. 相似文献