Viscoelastic characteristics of mixed compositions based on polyethylene and polypropylene

VNIISV, Tver'. Institute of Chemical Physics, Moscow. Translated from Khimicheskie Volokna, No. 3, pp. 42–43, May–June, 1992.     

Temperature dependence of the effective coefficient of Auger recombination in 1.3 μm InAs/GaAs QD lasers

Semiconductor laser heterostructures containing five and ten sheets of InAs/GaAs QDs on GaAs substrates, with an emission wavelength of ～1.3 μm, have been studied. Dependences of the nonradiative lifetime and effective Auger coefficient in QDs are obtained from an analysis of temperature and current dependences of the efficiency of spontaneous radiative recombination. The zero-threshold Auger recombination channel in QDs is shown to dominate at low (below 200 K) temperature, whereas at higher temperatures the quasithreshold channel becomes dominant. The effective 3D Auger coefficient is estimated in the approximation of a spherical QD, and a good agreement with the experimental data is obtained.     

Broad-area InAs/GaAs quantum dot lasers incorporating intermixed passive waveguide

InAs/GaAs quantum dot lasers incorporating passive waveguide created by post-growth intermixing processing have been studied. Emission wavelength of the passive section shows relative blueshift as high as 135 nm with respect to the emission wavelength of the active section. Intrinsic losses in the section formed by the intermixing are very small. Broad-area lasers with 100 mum stripe width incorporating intermixed section have demonstrated improvements in far-field pattern under both pulsed and continuous wave pumping current     

A single-spatial-mode semiconductor laser based on InAs/InGaAs quantum dots with a diffraction filter of optical modes

The concept of a diffraction optical filter is used for prevention of high-order mode oscillation in a design of stripe laser diodes with an active region based on InAs/InGaAs quantum dots emitting in the 1.3-μm wavelength range grown on GaAs substrates. Incorporation of such a filter made it possible to increase the width of the stripe and obtain an output power as high as 700 mW with retention of a single-spatial-mode character of lasing.     

Continuous-wave lasing of single-mode metamorphic quantum dot lasers for the 1.5-μm spectral region

Lasers based on InAs/InGaAs quantum dots grown on metamorphic (In,Ga,Al)As layers deposited by MBE on GaAs substrates exhibited emission near 1.5 μm with a differential quantum efficiency of about 50%. The narrow-stripe lasers operate in a single transverse mode and withstand continuous current density above 20 kA cm^?2 without significant degradation. A maximum continuous-wave output power of 220 mW is obtained. Neither current nor beam filamentation was observed up to the highest pumping levels.     

Increasing the Efficiency of Dewaxing in the Deoiling Stage

During selective treatment, the content of high–melting paraffins and naphthenes that crystallize from solution when the temperature is decreased increases significantly in lube oil cuts after removal of resins and asphaltenes and polycyclic hydrocarbons with short side chains. These hydrocarbons, which have a high melting point, are removed during dewaxing to obtain low-pour lube oil cuts.     

Local triboelectrification of an n-GaAs surface using the tip of an atomic-force microscope

The method of scanning Kelvin-probe microscopy is used to show that the effect of triboelectrification is observed when the tip of an atomic-force microscope interacts with the surface of n-GaAs epitaxial layers. The sign of the change in the potential indicates that the sample surface after triboelectrification becomes more negative. The observed specific features of the phenomena can be attributed to the thermally activated generation of point defects in the vicinity of the sample surface due to deformation caused by the tip.