Selective removal of gallium (III) from aqueous solutions containing zinc or aluminum using sodium di-(n-octyl) phosphinate

Gallium was removed selectively from aqueous solutions containing zinc or aluminum using sodium di-(n-octyl) phosphinate as a ligand (NaL). At low pH or low mole ratios, the gallium was removed by complexation with the ligand as GaL(3(S)), while the zinc or the aluminum remained in the solution. Nearly complete separation of gallium was obtained. By increasing the amount of ligand or by increasing the pH, the zinc or aluminum remaining in the solution was then removed as a solid complex: ZnL(2(S)) or AlL(3(S)), respectively. At a pH between 1.5 and 2 and a mole ratio ligand to total metals of 0.75 for zinc solutions and 1.0 for aluminum solutions, more than 98% of the gallium was selectively removed with a high molar selectivity, alpha(Ga/Zn) and alpha(Ga/Al), respectively. Over 95% of gallium was recovered from the solid GaL(3(S)) complex by treatment of the complex with a 3M NaOH solution and diethyl ether. The gallium was concentrated in the aqueous solution to 4 times its initial concentration and the ligand was extracted into the ether phase. After evaporation of the ether, 95% of the ligand was regenerated in its sodium form as a solid.     

Classic and novel brominated flame retardants (BFRs) in common sole (Solea solea L.) from main nursery zones along the French coasts

Brominated flame retardants (BFRs) were investigated in juvenile common sole from nursery zones situated along the French coast in 2007, 2008 and 2009. Extensive identification was performed with regard to PBDEs, novel BFRs 1,2-bis(2,4,6-tribromophenoxy)ethane (BTBPE) and decabromodiphenylethane (DBDPE), and other non-PBDE BFRs, namely, hexabromobenzene (HBB) and 2,2′,4,4′,5,5′-hexabromobiphenyl (BB-153). Polybrominated diphenyl ether (PBDE) concentrations (Σ 14 congeners) ranged from 0.01 ng/g to 0.16 ng/g wet weight (ww) in muscle, and 0.07 ng/g to 2.8 ng/g ww in liver. Concentrations were in the lower range of those reported in the literature in other European locations. Lower PBDE concentrations, condition indices and lipid contents were observed in the Seine estuary in 2009, possibly in relation to a lower water flow. The PBDE patterns and ratios we observed suggested that juvenile sole have a relative high metabolic degradation capacity. Non-PBDE BFRs were detected at lower levels than PBDEs, i.e., within the < method detection limit - 0.005 ng/g ww range in muscle, and < method detection limit - 0.2 ng/g ww range in liver. The data obtained is of particular interest for the future monitoring of these compounds in the environment.     

Spatial and temporal trends of petroleum hydrocarbons in wild mussels from the Galician coast (NW Spain) affected by the Prestige oil spill

Polycyclic aromatic hydrocarbons (PAHs) were determined in tissues of wild mussels (Mytilus galloprovincialis) from the Galicia coast (NW Spain) in order to assess the extent of the environmental impact caused by the Prestige oil spill (November 13, 2002). Three sampling campaigns were carried out in February, June and November 2003 at 24 stations along the Galicia coast, from La Guardia (Pontevedra) to Ribadeo (Lugo). The spatial distribution of PAHs found in the first sampling period, clearly revealed the central area (Costa da Morte) as the most affected by the oil spill. In these stations, concentrations up to 7780 microg/kg dw of the sum of 13 parent PAHs were found 2-3 months after the spill. Molecular parameters within the aliphatic and aromatic fractions confirmed the presence of the Prestige oil in these samples. The levels markedly decreased at most of the stations in the second sampling and recovered to levels found before the spill in November 2003, 1 year after the accident (29-279 microg/kg dw, av. 133+/-83 microg/kg dw). However, a certain increase was observed in some sites which could be related to the remobilization of oil residues from still unclean intertidal spots or sediments due to the winter marine weather conditions.     

Spatial and temporal evolution of trihalomethanes in three water distribution systems

Spatial and seasonal changes in trihalomethane (THM) concentrations were investigated in three distribution systems of Quebec (Canada) which are supplied by different surface waters and which use a variety of physicochemical treatment strategies. The investigation was based on an intensive 25-week sampling programme, undertaken at a time of year when the temperature of southern Quebec surface waters exceeds 4 degrees C (April-November). THMs and other water quality and operational parameters were monitored at points along the distribution system--between the treatment plant and the system extremities--which represented variable residence times of water. Results showed that THM concentrations vary significantly (from 1.5 to 2 times, depending on the utility) between finished waters as they leave the plant and water at the system extremities. When water temperature exceeds 15 degrees C, spatial THM variations are particularly high (from 2 to 4 times, depending on the utility). The development of multivariate regression models showed that water temperature was a better predictor of THM seasonal variability than chlorine dose, surrogates of natural organic matter and pH. Also, initial THM formation (in finished waters leaving the plant) was a good predictor of THM levels at distribution system extremities.     

Phenols in anaerobic digestion processes and inhibition of ammonia oxidising bacteria (AOB) in soil

This study focuses on the presence of phenols in digestate from seven Swedish large-scale anaerobic digestion processes and their impact on the activity of ammonia oxidising bacteria (AOB) in soil. In addition, the importance of feedstock composition and phenol degradation capacity for the occurrence of phenols in the digestate was investigated in the same processes. The results revealed that the content of phenols in the digestate was related to the inhibition of the activity of AOB in soil (EC(50)=26 microg phenols g(-1) d.w. soil). In addition, five pure phenols (phenol, o-, p-, m-cresol and 4-ethylphenol) inhibited the AOB to a similar extent (EC(50)=43-110 microg g(-1) d.w. soil). The phenol content in the digestate was mainly dependent on the composition of the feedstock, but also to some extent by the degradation capacity in the anaerobic digestion process. Swine manure in the feedstock resulted in digestate containing higher amounts of phenols than digestate from reactors with less or no swine manure in the feedstock. The degradation capacity of phenol and p-cresol was studied in diluted small-scale batch cultures and revealed that anaerobic digestion at mesophilic temperatures generally exhibited a higher degradation capacity compared to digestion at thermophilic temperature. Although phenol, p-cresol and 4-ethylphenol were quickly degraded in soil, the phenols added with the digestate constitute an environmental risk according to the guideline values for contaminated soils set by the Swedish Environmental Protection Agency. In conclusion, the management of anaerobic digestion processes is of decisive importance for the production of digestate with low amounts of phenols, and thereby little risks for negative effects of the phenols on the soil ecosystem.     

重庆菜袁路隧道模拟设计

本文论述应用平面变形条件下的模型试验结果,分析研究重庆菜袁隧道的初步设计,确定喷射混凝土和岩石锚杆的尺寸和二次衬砌的厚度,以及选择适合的施工方法。     

Fitting interrelated datasets: metabolite diffusion and general lineshapes

Objective

Simultaneous modeling of true 2-D spectroscopy data, or more generally, interrelated spectral datasets has been described previously and is useful for quantitative magnetic resonance spectroscopy applications. In this study, a combined method of reference-lineshape enhanced model fitting and two-dimensional prior-knowledge fitting for the case of diffusion weighted MR spectroscopy is presented.

Materials and methods

Time-dependent field distortions determined from a water reference are applied to the spectral bases used in linear-combination modeling of interrelated spectra. This was implemented together with a simultaneous spectral and diffusion model fitting in the previously described Fitting Tool for Arrays of Interrelated Datasets (FiTAID), where prior knowledge conditions and restraints can be enforced in two dimensions.

Results

The benefit in terms of increased accuracy and precision of parameters is illustrated with examples from Monte Carlo simulations, in vitro and in vivo human brain scans for one- and two-dimensional datasets from 2-D separation, inversion recovery and diffusion-weighted spectroscopy (DWS). For DWS, it was found that acquisitions could be substantially shortened.

Conclusion

It is shown that inclusion of a measured lineshape into modeling of interrelated MR spectra is beneficial and can be combined also with simultaneous spectral and diffusion modeling.

     

Territorial development in the Cape Verde archipelago under the Estado Novo dictatorship (1953–1974)

Despite Portugal's neutrality in the Second World War (1939–1945), the subsequent new world order meant that the Portuguese Government felt obliged to revise its overseas policies. A new regional awareness could be seen in the Six-Year National Development Plans launched by Estado Novo from 1953 until the revolution of 1974. The territory and its strategic potential were emphasized in the context of national policies of overseas urbanization. Interventions in Cape Verde are visible particularly in the First Development Plan, which was based on equipping the province's public facilities. The methodology of intervention involved setting up missions aimed at planning a set of specific public works which were essential to the development of existing settlements. A sharp increase in the development of the territory through the work of specialized brigades took place in the Third Development Plan, when a set of public works on road, hydraulic and electricity networks was undertaken. The planning of infrastructures that was undertaken in these years was essential to the development of the archipelago and the resulting regional and urban land-use planning of the various islands.     

Granite plates as structural slabs in Brazilian buildings: application of reliability concepts

Polished finishing granites are greatly accepted for claddings because of the plates’ shape, design and color variety. The features depend on the geological conditions that occur during the formation process, which include the mineralogy of the stone, the fluids formed during the process, the grain size of the minerals and the way in which the minerals interact with each other. One of the noblest uses of stone plates is in non-adherent covering systems (without mortar), such as ventilated façades and pedestrian paving systems. Currently, the methodology for non-adherent systems uses the allowable stress design criteria. In recent years, the number of papers indicating reliability analysis as an important design tool for natural stones has increased. However, a lack of information concerning the design methodology still happens. Therefore, the structural properties assessed as complementing these studies were: compressive strength, three-point flexural tensile strength, Young’s modulus and Poisson’s ratio. A granite slab design example was also presented. First, the thickness of the plates was determined based on the formulation proposed by Timoshenko [Strength of materials (original language, Portuguese), Volume II. Editora Ao Livro Técnico S. A., Rio de Janeiro, 1977], using the allowable stress design criteria. Next, the reliability analysis was performed by Monte Carlo simulation. Results showed that the Desireé White granitic plate presented a higher reliability index than the Capão Bonito Red granitic plate. This result seems to be paradoxical, owing that the Capão Bonito Red presented a higher value of mean flexural strength than the Desireé White. The minimal safety factors to satisfy the target reliability value of 3.8 as recommended by the standard EN 1990:2002 (Eurocode) were found to be 2.61, 1.98 and 2.72, respectively, for the three stone types.