A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Estimation of wave fields of incident beams in a transmission electron microscope by using a small selected-area aperture

The direction of an electron beam in a nanometer-sized area is measured directly by utilizing a selected-area aperture. By the measurements at several areas in a beam, the wavefront curvature and thus the defocus value of the beam are detected. From the defocus value, the wave field at the specimen plane is also reproduced in consideration of the influences of the condenser aperture and spherical aberration of the illumination lens. The result shows that phase deviation of 2π is caused only at about 10?nm apart from the beam center in a beam with a typical diameter for high-resolution transmission electron microscopy. Based on the defocus value, the convergence angle of the beam is also estimated to be about 6?mrad without being influenced by the partial coherence, that is, independently of the type of the electron gun. Measuring the defocus values for only two beam diameters enables us to determine geometrical parameters peculiar to the illumination system, based on which wave fields of any beam diameters by any condenser aperture sizes can be estimated. The technique proposed in this paper is effective in evaluating the influence of wavefront curvature of incident beams on various kinds of precise measurements conducted in transmission electron microscopes.     

A mass separation of chondrocytes from cartilage tissue utilizing an automatic crushing device

Porcine articular cartilage tissue was crushed using Multi-Beads-Shocker^™ and digested with trypsin and collagenase type II. Chondrocyte cell yield was maximized by automatic crushing for 10 s, which was 4 times that by manual dicing with a surgical blade and might be useful for the automation of the cell processing.     

Combination of cytomegalovirus enhancer with human cellular promoters for gene-induced chondrogenesis of human bone marrow mesenchymal stem cells

High-expression plasmid vectors for human mesenchymal stem cells (MSCs) were constructed by combination of cytomegalovirus immediate-early enhancer with cellular promoters. MSCs transfected with the vector showed higher transgene production of a cytokine, which increased the differentiation level to chondrocytes.     

Optimal Digital Controller Design for a Servo Motor Taking Account of Intersample Behavior

A continuous‐time plant with a discretized continuous‐time controller does not yield stability if the sampling rate is lower than some certain level. Thus far, high‐performance electronic control has made use of expensive hardware needed to implement discretized continuous‐time controllers; low‐cost hardware generally does not have a sufficiently high sampling rate. This technical note presents results comparing performance indexes with and without intersample behavior, and provides some answers to the question of how a low‐specification device can control a plant effectively. We consider a machine simulating wafer handling robots, which is an electromechanical system driven by a direct drive motor, at a semiconductor factory. We illustrate the controller design for the robot with and without intersample behavior, and present simulations and experimental results using these controllers. Taking intersample behavior into account proves to be effective in improving control performance and makes it possible to choose a relatively long sampling period. Controller design in terms of the performance index with intersample behavior makes it possible to deal with situations in which a sufficiently short sampling period may not be employed, and freedom of controller design may be widened, especially regarding the choice of the sampling period.     

Analysis of the Microstructure of Mg2Si Thermoelectric Devices

High-performance Mg₂Si thermoelectric devices have been obtained by spark plasma sintering of high-purity, pre-synthesized, all-molten Mg₂Si powder. We studied the effects of source powder particle size on thermoelectric performance. To improve the performance, further investigation of the microstructure of the devices is needed. In this work we studied the microstructure of grain boundaries and interfaces between electrodes and Mg₂Si sintered bodies to increase understanding of Mg₂Si thermoelectric devices.     

Comparison of enteral nutrition with combined enteral and parenteral nutrition in post-pancreaticoduodenectomy patients: a pilot study

Background  

Many clinical studies have demonstrated that early postoperative enteral nutrition (EN) improved the postroperative course. Post-pancreaticoduodenectomy (PD), patients tend to suffer from postoperative nausea, abdominal distention, and diarrhoea, causing difficulty in the introduction of EN. In this pilot study, we investigated the appropriate nutritional mode post-pancreatic surgery.     

Calibration Curve for Quantitative Analysis of the Monoclinic-Tetragonal ZrO2 System by X-Ray Diffraction

A nonlinear calibration curve for volume fraction vs integrated intensity ratio was obtained for the monoclinic-tetragonal ZrO² system by using X-ray powder pattern-fitting and pattern-decomposition techniques. The empirical equation agrees well with the theoretical one. By using this equation, the deviation from linearity (6.8% maximum) resulting from the intensity difference of corresponding reflections of the two phases can be estimated quite accurately.     

Hydrothermal crystal growth of perovskite-type fluorides

Single crystals of perovskite-type fluorides were grown from potassium fluoride and di-valent metal chloride solutions by a hydrothermal method under a temperature gradient, at maximum temperature 600° C and pressure 98 MPa. Single-crystal cubes of KMnF₃, KFeF₃, KCoF₃ and KZnF₃, of cube edge sizes ranging from 0.2 to 2.0 mm, were grown. Crystals of KNiF₃ grew in rectangular prisms and those of KCdF₃ in anhedral form. Single crystals of KCuF₃ were grown in pure water from co-precipitated KCuF₃ powder. KMgF₃ crystals were not grown by this method.