HNO3和有机介质中U（Ⅳ）的稳定性研究

研究了ＨＮＯ＿３和ＴＢＰ－煤油介质中Ｕ（Ⅳ）的稳定性。测定了两种介质中Ｕ（Ⅳ）、ＨＮＯ＿３、ＴＢＰ浓度和气相中氧浓度对Ｕ（Ⅳ）氧化速率的影响。Ｕ（Ⅳ）的氧化速率都随温度提高而明显增加．其表观活化能分别为９１ｋＪ／ｍｏｌ（ＨＮＯ＿３介质）和４２ｋＪ／ｍｏｌ（ＴＢＰ－煤油介质）。对两种介质中Ｕ（Ⅳ）的氧化速率规律进行了比较。     

偏高岭土的研究现状及展望

简要介绍了偏高岭土的反应机理和在国内外的研究现状。同时对偏高岭土的研究进行了展望 ,提出因麦特林水泥原料丰富 ,污染小 ,加工简单 ,性能优越 ,其应用前景广阔 ,应对其加强研究。     

Determination of the width of the transition layer between the crystalline and amorphous zones in nylon 1010 by SAXS

The width of the transition layer between the crystalline and amorphous zones in nylon 1010 was determined by SAXS with point collimation and long-slit collimation, respectively. The width of the transition layer, E, was found to be 1.7 nm. The results show that the width of the transition layer is independent of crystallinity.     

Synthesis and characterization of molybdenum disulphide formed from ammonium tetrathiomolybdate

An investigation has been carried out into the possibility of in situ formation of MoS2 within porous anodic films on aluminium, to improve subsequent tribological behaviour, by re-anodizing in thiomolybdate electrolyte. Acidification of thiomolybdate was employed to simulate the conditions for formation of the sulphide at the anodic film/electrolyte interface, followed by appropriate vacuum heat treatments to study possible temperature effects on the sulphide due to either friction or Joule heating during anodizing. The products of both acidification and heat treatment, characterized by X-ray powder diffraction and scanning electron microscopy, were compared with those formed by direct thermal decomposition of ammonium tetrathiomolybdate crystals. The precipitate formed by acidification was mainly amorphous molybdenum trisulphide (MoS3), which on heat treatment at 450 and 850°C yielded 3R-MoS2. 3R-MoS2 also formed by the thermal decomposition of thiomolybdate crystals. Thermogravimetric and differential thermal analyses showed that the decomposition of MoS3 to MoS2 occurred in the range 220–370°C and revealed the sequence of reaction steps. The findings suggest that mainly amorphous MoS3 is formed as a consequence of changes in the pH of the film/electrolyte interface during re-anodizing but the product is relatively easily transformed to crystalline MoS2 on moderate heating which may occur during wear processes.     

超薄SiO2层的热生长

隧道小孔中超薄ＳｉＯ２的生长是ＥＥＰＲＯＭ电路制造的关键工艺之一。采用ＳＵＰＲＥＭ－Ⅲ工艺模拟程序对超薄ＳｉＯ２的热生长进行了工艺模拟，经过大量的工艺实验及优化，确定了超薄ＳｉＯ２的最佳生长条件，生长出的ＳｉＯ２性能良好，完全可满足ＥＥＰＲＯＭ研制的要求。     

人支气管上皮靶细胞形态学参数的测量

支气管上皮靶细胞形态学参数对计算受氡子体照射的支气管的剂量是很重要的。本文介绍利用奥尔新兰-PAS 染色的外科切除人肺组织切片,测量基底细胞粘液细胞和的胞核深度与数目。结果表明,叶、段和小支气管的粘液细胞核深度分别为相应节段基底细胞的61%、69%和73%;此三节段粘液细胞的数目分别为基底细胞的53%、29%和28%,平均为37%。     

清华屏蔽实验反应堆中子注量率能谱的调节和测量

叙述了采用多种屏蔽过滤方法,通过实验获得多种条件下的中子注量率能谱的调节和测量。     

Influence of Billet Size on Flow, Solidification and Solute Transport in Continuous Casting

ListofSymbol　　B———Buoyancy ,m·s- 2 ;　　c———Concentrationofsoluteelement ;　　Cμ———Turbulentconstant;　　D———Diffusivityofsoluteelement ,m2 ·s- 1 ;　　fl,fs———Liquidandsolidfraction ;　　fμ———Turbulentcoefficient ;　　h———Enthalpy ,J·kg- 1 ;　　k———Turbulentkineticenergy ,m2 ·s- 2 ;　　kp———Equilibriumpartitioncoefficient;　　Kp———Permeabilityofmushyzone ,m2 ;　　K0 ———Permeabilitycoefficient;　　p———Pressure ,Pa ;　　Pr———Prandtlnumber ;…     

U(Ⅳ)-U(Ⅵ)同位素交换反应动力学研究 Ⅰ.Fe~(2+)对U(Ⅳ)-U(Ⅵ)同位素交换反应的催化作用

一、前言由于U(IV)-U(VI)同位素交换体系具有相当大的同位素效应和很好的稳定性,并且容易实现两相回流,这对于分离U同位素的工业应用都是十分有利的。但是,U(IV)-U(VI)同位素交换反应速度非常慢,常温下H~+浓度为1.0—4.0 mol/l时,速度常数为1.0×10~(-4)l~2/mol·s。因此要用U(IV)-U(VI)交换体系浓缩铀同位素,必须研究U(IV)-U(VI)交换反应动力学,找到加快交换反应的方法。     

Comparisons of PWM and one-cycle control for power amplifier with multilevel converter

Based on the concepts of cascade multilevel converters and one-cycle technique, comparisons are conducted to characterize the distortion of the pulsewidth modulation (PWM) and one-cycle control methods that were applied to converters. Simulation results for the different control schemes are obtained in PSIM software initially to see the effect of one-cycle control different from that of PWM control. Through the comparisons, the advantages and disadvantages are identified for each method. The one-cycle scheme is better than PWM control in reducing undesirable harmonics and tracing dynamic waveforms. Simulation and experimental results are also provided to verify the conclusions.