Duration of spinal anaesthesia is determined by the partition coefficient of local anaesthetic

We have compared the duration of motor block produced by four local anaesthetics administered into a chronically implanted subarachnoid catheter in rabbits. Each group (n = 6) received four different doses of amethocaine, bupivacaine, lignocaine or procaine, and the duration of the resulting motor block was assessed. Dose-response curves were plotted for each drug. As a measure of activity of the anaesthetics, we used the dose of each drug required to produce block of 60-min duration (D60 min) and the correlation between D60 min and different drug properties was examined. An inverse linear correlation (r = 0.995; P < 0.01) was observed between log D60 min and the log of the partition coefficient of the local anaesthetics. No correlation was found between the effect and degree of protein binding, pKa or molecular weight. These results suggest that, in spinal anaesthesia, the partition coefficient could be used as a predictor of the duration of anaesthetic action.     

裂缝性油气藏采收率：100个裂缝性油气田实例的经验总结

通过对世界上100个裂缝性油气藏的综合评价，研究储集层及流体本身的性质(包括孔隙度、渗透率、黏度、可动油比例、含水饱和度、润湿性及裂缝分布特征等)和驱动机制及油藏管理战略(优化日产量和采用不同类型的提高采收率技术)对其最终采收率的影响。将裂缝性油气藏分为4类：I类的基质几乎没有孔隙度和渗透率，裂缝是储存空间和流体流动的通道；Ⅱ类的基质有较低的孔隙度和渗透率，基质提供储存空间，裂缝提供流动通道；Ⅲ类(微孔隙)的基质具有高孔隙度和低渗透率，基质提供储存空间，裂缝提供流动通道；Ⅳ类(大孔隙)的基质具有高的孔隙度和渗透率，基质提供储存空间和流动通道，裂缝仅增加渗透率。对26个Ⅱ类油气藏和20个Ⅲ类油气藏的开采历史的研究表明：Ⅱ类油气藏的采收率受水驱强度和最优日产量控制，日产量过高会很容易破坏Ⅱ类油气藏，一些Ⅱ类油气藏如果管理得当，采收率可以很高，不需要二次或三次采油；Ⅲ类油气藏的采收率主要受岩石和流体本身性质的影响，特别是基质渗透率、流体重度、润湿性以及裂缝强度等，不进行二次或三次采油不可能完全开采，往往需要采用一些提高采收率的专门技术。以往将Ⅱ类和Ⅲ类裂缝性油气藏归为一类，认识它们的区别将有助于选择更好的开发策略。     

The Present Status and Potential of Kraft Lignin-Phenol-Formaldehyde Wood Adhesives

Kraft lignin (KL), a phenolic polymer formed during the kraft pulping process, is presently burned as a low value fuel. For decades, researchers have attempted to use KL as an inexpensive substitute for phenol in phenol-formaldehyde (PF) resins, but no one has produced a commercially satisfactory KL-PF resin. This paper reviews the literature on the present status of KL-PF adhesives and makes recommendations on needed research.

Kraft lignin solutions are complex mixtures which have broad molecular weight distributions, high viscosities, relatively low reactivities, and low solubilities. Attempts to overcome these inherent problems include methylolation of lignin to improve reactivity, the use of co-solvents to improve solubility, and ultrafiltration to yield more homogeneous molecular weight fractions. Future research efforts need to focus on understanding the fundamental chemical and physical properties of kraft lignin and its resins. The search for an economic lignin-based wood adhesive should continue.     

Toward bridging the science and practice of depression prevention: What can we learn from cognitive vulnerability?

Depression is a widespread disorder with devastating individual and societal consequences. Although a great deal of research and theory has focused on treatment of acute episodes, progress needs to be made in preventing the emergence of first episodes of the disorder. There has been considerable advancement in understanding psychological vulnerability factors associated with this mood disorder, especially on the basis of cognitive behavioural models and research findings based on this theoretical model. In this paper we review the concept of cognitive vulnerability, with a particular focus on what this body of research work suggests clinically for the prevention of depression. We outline, based on this science, what the effective ingredients of a prevention program could be. We also discuss some of the pragmatic aspects of developing an effective prevention program for depression. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Random sequence multisets for synchronous code-divisionmultiple-access channels

The effect of using randomly selected sequence multisets for the uplink of a synchronous code-division multiple-access channel is considered. A tight lower bound on the expected value of the sum capacity over the ensemble of randomly selected sequence multisets is given. For large systems, the sum rate penalty for using randomly selected multisets is shown to be at most 1 nat and to vanish as the number of users becomes large, compared to the sequence length     

Sexual dimorphism of circulating somatotropin, insulin-like growth factor I and II, insulin-like growth factor binding proteins, and insulin: relationships to growth rate and carcass characteristics in growing lambs

The effects of sex and age on patterns of circulating somatotropin (ST) concentration and plasma IGF-I, IGF-II, insulin, and IGF binding protein-3 (IGFBP-3) were studied in ram, wether, and ewe lambs (n = 7 or 8) sampled at mean ages of 81 (I1) and 158 d (I2). Between 81 and 158 d of age, rams grew more rapidly than wethers (P < .01), and wethers grew more rapidly than ewes (P < .01). The sex differences in growth were reflected in empty body weight at slaughter: rams > wethers > ewes (P < .05). Mean plasma ST concentrations, ST pulse amplitude, and integrated plasma ST concentrations were greater (P < .05) in rams than in ewes at I1 and I2. Characteristics of the ST plasma profile in wethers were generally intermediate between those of rams and ewes. The interpulse interval was greater in ewes than in wethers at I2. The IGF-I and IGFBP-3 concentrations were greater in rams than in ewes at both sampling times. Plasma IGF-II was greater in ewes than in rams at I2. Mean plasma ST was approximately two thirds less at I2 than at I1 regardless of sex. Mean plasma ST and IGF-I at both ages were positively correlated with growth. Mean plasma ST at I2 was negatively correlated with fatness at slaughter. Sex and age significantly affected patterns of circulating ST and concentrations of IGF-I and IGFBP-3 in prepubertal growing lambs, under conditions for which growth rates and composition were also sexually dimorphic.     

Development and simulation studies of an unsteady state biofilter model for the treatment of cyclic air emissions of an α‐pinene gas stream

This paper describes the development and simulation of an unsteady state biofilter model used to predict dynamic behaviour of cyclically‐operated biofilters and compares it with experimental results obtained from three, parallel, bench‐scale biofilters treating both periodically fluctuating concentrations and constant concentrations of an α‐pinene‐laden gas stream. The dynamic model, using kinetic parameters estimated from the constant concentration biofilter, was able to predict the performance of cyclic biofilters operating at short cycle periods (ie, in the order of minutes and hours). Steady state kinetic data from a constant concentration biofilter can be used to predict unsteady state biofilter operation. At a 24 h cycle period, the dynamic model compared well with experimental results. For long cycle periods (ie, hours and days), removal efficiency decreased after periods of non‐loading: the longer the period of non‐loading, the poorer the biofilter's performance at the re‐commencement of pollutant loading. At longer time scales the model did not effectively predict transient behaviour, as adsorption and changes in kinetic parameters were not accounted for. Modelling results showed that similar biofiltration performance for the cyclic and constant concentration biofiltration of α‐pinene is expected for biofilters operating solely in the first order kinetics regime. Poorer performance for cyclic biofilters following Monod kinetics spanning the entire kinetics range is expected as the cycle amplitude increases. The most important parameters affecting the performance of a cyclically‐operated biofilter with short cycle periods are: amplitude of cyclic fluctuations, C_{g, max}/C_g, relative value of the half‐saturation constant in the Monod expression, K_s, and effective diffusivity of α‐pinene in the biofilm, D_e. Copyright © 2005 Society of Chemical Industry     

The use of Schottky barrier diodes for the detection of surface contamination and damage in the fabrication of GaAs MESFETS

The gates of GaAs MESFETS rely on the formation of a Schottky diode between the semiconductor surface and a deposited metal and so are extremely sensitive to the nature of this interface. For this reason an investigation of surface damage and contamination by the various processing stages involved in IC fabrication has been undertaken. This paper outlines the results obtained from processes involved in activation of ion implantation through annealing with a dielectric encapsulant, wet chemical etching, and metallization. Methods for removing or minimizing the effects of processing damage or contamination are also investigated.     

The reporting of the risks from genetically modified organisms in the mass media, 2002–2004

This paper describes an analysis of coverage of the risks from agricultural and food genetically-modified organisms (GMOs) from April 2002 to April 2004 in 14 news media from six countries (Canada, France, Germany, Spain, the UK and the USA) which was conducted as part of a review for the European Commission of the management of risk communication. A total of 597 relevant news articles were found and coded for their presentational tone, the types of risk (environmental, financial, health and political, in that order), the organisms described (mainly maize, rape and beet crops), and the documents, people and organisations cited. UK news media tended to be the most “scary” and Spanish ones the most “robust”. Articles quoting public perceptions, non-governmental environmental organisations and politicians tended to emphasize the risks of GMOs; those quoting scientists tended to downplay the risks and describe their potential benefits. Some suggestions for possible action by the European Commission are put forward, such as the facilitation of contact between journalists and scientists, but it is recognized that for some newspapers, their editorial wish to campaign will inevitably over-ride their reporters’ wish to present the truth.     

Measurement of Energy Expenditure in Elite Athletes Using MEMS-Based Triaxial Accelerometers

Fitness development and performance assessment of elite athletes requires an understanding of many physiological factors, many of these are direct and indirect measures of athlete energy expenditure. Many methods are physiological factor assessments and require the athlete to be constrained by laboratory equipment or periodic interruption of activity to take measurements such as blood samples are required to be taken. This paper presents a method that is entirely ambulatory and noninvasive, using microelectromechanical systems (MEMS) accelerometers. The commonly used output of commercial accelerometer-based devices (known as "counts") cannot discriminate activity intensity for the activities of interest. This, in conjunction with variability in output from different systems and lack of commonality across manufacturers, limits the usefulness of commercial devices. This paper identifies anthropometric and kinematic sources of inter-athlete variability in accelerometer output, leading to an alternate energy expenditure estimator based mainly on step frequency modified by anthropometric measures. This energy expenditure estimator is more robust and not influenced by many sources of variability that affect the currently used estimator. In this system, low-power signal processing was implemented to extract both the energy estimator and other information of physiological and statistical interest