Finite-difference time-domain simulation of scattering from objectsin continuous random media

A three-dimensional (3D) finite-difference time-domain (FDTD) scheme is introduced to model the scattering from objects in continuous random media. FDTD techniques have been previously applied to scattering from random rough surfaces and randomly placed objects in a homogeneous background, but little has been done to simulate continuous random media with embedded objects where volumetric scattering effects are important. In this work, Monte Carlo analysis is used in conjunction with FDTD to study the scattering from perfectly electrically conducting (PEC) objects embedded in continuous random media. The random medium models under consideration are chosen to be inhomogeneous soils with a spatially fluctuating random permittivities and prescribed correlation functions. The ability of frequency averaging techniques to discriminate objects in this scenarion is also briefly investigated. The simulation scheme described in this work can be adapted and used to help in interpreting the scattered field data from targets in random environments such as geophysical media, biological media, or atmospheric turbulence     

双时基频率校准电路

提供精确的时间基准是精密仪器和高精度设备计时和工作的关键技术之一。文中采用两套晶振电路，通过分频产生高频和低频两个频率信号，采用编码的方法对两个频率信号在每一个时钟周期内进行动态校核，只有两个晶振的频率在允许的精度范围内，或同时增大（缩小）相同的倍数，校核后频率信号才是正确的，且能给系统提供精确的时间基准。该方法能有效防止系统的时钟周期因意外的原因伸长或缩短。整个电路可以作为精密仪器或高精度设备的一个模块电路。     

Effects of flux enhancing polymer on the characteristics of sludge in membrane bioreactor process.

A newly developed membrane performance enhancer (MPE) was used to prevent membrane fouling in a membrane bioreactor (MBR) process. It transpired that 1,000 mg/l of MPE reduced polysaccharide levels from 41 mg/I to 21 mg/I on average under the experimental condition. Repeated experiments also confirmed that 50-1,000 mg/l of MPE could reduce membrane fouling significantly and increase the intervals between membrane cleanings. Depending on MPE dosages and experimental conditions, trans-membrane pressure (TMP) increase was suppressed for 20-30 days, while baseline TMP surged within a few days. In addition, MPE allowed MBR operation even at 50,000 mg/l of total solid and reduced permeate COD. However, no evidence of toxicity for sludge was found from respiratory works.     

Ionothermal synthesis of a three-dimensional zinc phosphate with DFT topology using unstable deep-eutectic solvent as template-delivery agent

A three-dimensional zinc phosphate compound with DFT topology, designated as ZnPO₄-EU1, has been synthesized by an ionothermal approach from the system HF-ZnO–P₂O₅-choline chloride-imidazolidone. Ethylenediamine, derived from decomposition of the imidazolidone component of the deep-eutectic solvent (DES) itself, is delivered to the synthesis and serves as an appropriate template for ZnPO₄-EU1. Experiments in which the synthesis conditions were varied showed that ZnPO₄-EU1 may be prepared over a wide molar ratio of P/Zn = 0.55–13.0. Powder X-ray diffraction patterns have been obtained at intervals to track the crystallization process of this material. The experimental data show that Zn₃(PO₄)₂ · 4H₂O (a dense phase) was first isolated from the DES after reaction for 1 h. Subsequently, the pure phase of ZnPO₄-EU1 was obtained with increasing crystallization time from 12 h to 72 h. The experimental results show that the nucleation and crystallization take place with relatively low levels of solvent degradation, demonstrating that zinc phosphate with a three-dimensional framework can be synthesized by in situ generation of an appropriate template using an unstable DES at high temperatures (150–200 °C).     

BC480-22/42支架液压系统的大流量技术改造

分析了BC-480支架在综采工作面使用中液压系统配置低的原因,提出了系统的改造原则和方案,比较了改制前后支架的动作速度.     

Robust State Feedback Control Through Actuators With Generalized Sector Nonlinearities And Saturation

In control systems, actuators often have nonlinear characteristics that can not be neglected. For linear systems driven by actuators satisfying the generalized sector condition, a robust state feedback controller synthesis method is proposed to achieve the ultimate boundedness control. The method is based on the linear matrix inequality approach and is easy to apply. As an important special case of the generalized sector condition, the saturation characteristic of actuators is discussed separately, and non‐conservative results are obtained.     

广义频率响应函数的鲁棒建模新方法

针对基于非线性谱分析的故障诊断技术的需要,研究了非线性系统的广义频率响应函数的鲁棒在线建模方 法。首先将次元分析算法应用于Volterra级数模型的辨识,并通过对此算法的修正,得到了一种改进的Volterra系统的鲁 棒辨识算法。对其鲁棒性能进行的分析表明,改进算法的鲁棒抗噪性能被明显提高。在此基础上,提出了一种广义频率响 应函数的两步鲁棒建模新方法。仿真实验表明,该方法具有良好的鲁棒收敛性能,能够有效解决GFRF的在线建模问题。     

广东省大型工程建设中天然放射性核素引起的环境问题

本文介绍了广东省境内几个大型基本建设工程项目中天然放射性核素引起的环境问题及有关治理对策，并就今后类似建设项目的辐射环境保护工作提出了建议。     

液氮制冷低气压试验箱的仿真设计

在采用液氮制冷的低气压试验箱的设计中,用常规工程设计方法计算的降温过程冷负荷过大,从而导致真空系统设计容量过大。本文采用分布参数模型对试验箱低气压条件下降温过程的冷负荷进行了精确仿真模拟,以此作为真空系统容量设计的基础,减小了设计规模,取得了良好的效果。     

A practical SPICE model based on the physics and characteristics of realistic single-electron transistors

A practical model for a single-electron transistor (SET) was developed based on the physical phenomena in realistic Si SETs, and implemented into a conventional circuit simulator. In the proposed model, the SET current calculated by the analytic model is combined with the parasitic MOSFET characteristics, which have been observed in many recently reported SETs formed on Si nanostructures. The SPICE simulation results were compared with the measured characteristics of the Si SETs. In terms of the bias, temperature, and size dependence of the realistic SET characteristics, an extensive comparison leads to good agreement within a reasonable level of accuracy. This result is noticeable in that a single set of model parameters was used, while considering divergent physical phenomena such as the parasitic MOSFET, the Coulomb oscillation phase shift, and the tunneling resistance modulated by the gate bias. When compared to the measured data, the accuracy of the voltage transfer characteristics of a single-electron inverter obtained from the SPICE simulation was within 15%. This new SPICE model can be applied to estimating the realistic performance of a CMOS/SET hybrid circuit or various SET logic architectures.