Mechanical properties of alumina-fluorapatite composites with different titania additive amounts (0, 0.5, 1, 1.4, 2, 3, 4 and 5 wt%) have been investigated between 1200 and 1600℃. The optimum values of densification and mechanical properties of composites have been reached with 1.4 wt% of titania after the sintering process at 1500℃ for 1 h. Thus, the rupture strength of alumina-26.52 wt% Fap-1.4 wt% TiO2 reaches 75 MPa. At higher temperature and beyond 1.4 wt% TiO2 ,the densification and mechanical properties were hindered by the formation of both intergranular porosity and secondary phase. X-ray diffraction (XRD) analysis of alumina-Fap-TiO2 composites shows the formation of aluminium titanate (Al2O3-TiO2:Al2TiO5 ). The 27Al magic angle scanning nuclear magnetic resonance analysis of Al2O3-Fap-TiO2 composites reveals the presence of octahedral and pentahedral aluminium and novel environment relative to tetrahedral aluminium sites. 相似文献
This work aims to study the thermal behavior of basic-geopolymers derived from metakaolin (clay). The geopolymers were characterized by different techniques: thermal analysis (DTA, TGA), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR) and impedance spectroscopy. Some physicochemical properties of the products were also determined: the phases obtained after geopolymer heat treatment and their electrical properties. The results obtained after drying and heat treatment showed that the products kept their initial shapes, but revealed variable colors depending on the temperatures at which they were treated. The products obtained are amorphous between 300 up to 600 °C with peaks relating to the presence of nanocrystallites of muscovites and zeolite, thus at 900 °C it is quite amorphous but only contains nanocrystallites of muscovites. From the temperature of 950 °C, we notice that the geopolymer has been transformed into a crystalline compound predominated by the Nepheline (NaAlSiO4) with the presence of a crystalline phase by minor peaks of Muscovite, this crystalline character has been increased at 1100 °C to obtain a whole phase crystalline of a Nepheline. The treatment of this geopolymer for one hour at 1200 °C shows an amorphous phase again corresponding to corundum (α-Al2O3). This indicates that the dissolution of the grains by the liquid phase induces the conversion of the material structure from sialate [–Si–O–Al–O] to sialate siloxo [–Si–O–Al–O–Si–O–] and the formation of a new crystalline phase (α-Al2O3). This development of sialate to sialate-siloxo was confirmed by IR spectroscopy. As mentioned above, from 300 to 900 °C, Na-sialate geopolymer exhibits the same disorder structure of nepheline. The crystal structure of nepheline is characterized by layers of six-membered tetrahedral rings of exclusively oval conformation. The rings are built by Regularly alternating tetrahedral AlO4 and SiO4. Stacking the layer’s parallel to the c axis gives a three-dimensional network containing channels occupied by Na cations. This topology favors easy movement of Na+ ions throughout the structure. For this reason, ionic migration in nepheline is widely reported. The refinement of Na-Sialate geopolymer at room temperature gives bulk high ionic conductivity of about 5 × 10?5 S cm?1 and this is due to the probable joint contribution of H+ and Na+ ions. Above 200 °C, Na+ seems to remain the only charge carrier with a low activation energy of about Ea?=?0.26 eV. At higher temperatures, the characteristic frequencies become so close that it is impossible to distinguish the contributions. A total resistance comprising both grain and grain boundaries contribution is then determined.
This paper is concerned with fast and efficient computations for the solution of the two-point boundary-value problem that arises in optimal control of an aircraft longitudinal mode. The solution proposed is implemented on a T800 transputer network using parallel C and is shown to be adequate for real-time control purposes. 相似文献
In Tunisia, agar is produced from the species Gracilaria verrucosa. Other species, such as Gracilariopsis sp. which have a very similar morphology to Gracilaria, can be harvested in a mixture with Gracilaria with the result that the quantity and quality of agar extracted is different than initially expected. In this study, we tested the use of ITS sequences from 5.8s rDNA for species discrimination between G. verrucosa and Gracilariopsis harvested from two production sites (Bizerte and Tunis Lagoons). The amplification of genomic ITS sequences and sequencing shows that the samples collected from Tunis can be identified by PCR fragment of 1124 bp whereas the samples from Bizerte are characterized by the presence of two fragments of 1124 and 983 bp, respectively. A BLAST investigation in Genbank shows that the sequence similarities between the fragment of 1124 pb and G. verrucosa was 85% and between the fragment of 983 pb and Gracilariopsis sp. Plymoutn was 94%. Gracilariopsis sp. possesses a PCR fragment with a length of 983 bp, which discriminates it from G. verrucosa when these two species are collected in a mixture as in the lagoon of Bizerte. The RFLP method after EcoRI application provides a characteristic pattern for G. verrucosa, which is composed of two main fragments with respective sizes of 823 and 301 bp whereas amplified DNA of Gracilariopsis was uncut under these conditions. 相似文献
Tricalcium phosphate and synthesized fluorapatite powder were mixed in order to elaborate biphasic ceramics composites. The effect of fluorapatite addition on the densification and the mechanical properties of tricalcium phosphate were measured with the change in composition and microstructure of the bioceramic. The Brazilian test was used to measure the mechanical resistance of the tricalcium phosphate–26.52 wt% fluorapatite composites. The densification and rupture strength increase versus sintering temperature. The composites have a good sinterability and rupture strength in temperature ranging between 1300 and 1400 °C. Thus, the densification ultimate was obtained at 1350 °C and the mechanical resistance optimum reached 9.6 MPa at 1400 °C. Above 1400 °C, the densification and the mechanical properties were hindered by the allotropic transformation of tricalcium phosphate, grain growth and the formation of both intragranular porosity and many cracks. The 31P magic angle spinning nuclear magnetic resonance analysis of composites reveals the presence of tetrahedral P sites. 相似文献
Planetary gears are widely used in the transmissions of helicopters, automobiles, aircraft engines, etc. They have substantial
advantages such as compactness and a large torque-to-weight ratio. In this work, a plane model of a planetary gear was investigated.
The energetic Lagrange formulation was used to recover the equations of motion of the system. A modal analysis was performed,
and the influence of gyroscopic effect in particular was scrutinized. The dynamic response was computed by an iterative spectral
method. The excitation is induced by time-varying the gearmesh stiffness. The cases of a healthy planetary gear and one with
the presence of eccentricity and profile error were compared. The influence on the transmission ratio was also studied. 相似文献
This paper presents the first investigation on the effect of enrichment refined olive oil by chlorophyll pigment extracted from Chemlali olive leaves during storage (6 months). The changes that occurred in the quality indices, fatty acids, sterol, and phenolic content were investigated during the storage of refined olive oil under RT (20°C) and accelerated conditions (50°C) in the dark. Additionally, the pigments (chlorophyll and carotene) changes during 6 months of oil storage were evaluated. At the end of the storage, more than 90% of chlorophyll pigments decomposed in all samples, while, carotene pigment loss was lower showing up to 60 and 85% loss for oil stored at 20 and 50°C, respectively, at the end of storage. The reduction of total phenolic compounds exhibited similar degradation profiles, being reduced by 5% and up to 60% for the enriched refined olive oil stored at 20 and 50°C in 6 months, respectively. In the fatty acid composition, an increase in oleic acid and a decrease in linoleic and linolenic acids were less significant in enriched than non‐enriched refined olive oil. On the other hand, sterol composition was less affected by storage in enriched oil samples. However, the sterol concentration of the oil samples showed an increase in β‐sitosterol, 24‐methylene cholesterol, stigmasterol, and a decrease in cholesterol, Δ5, 24‐stigmastadienol percentage at the end of storage. Based on the Rancimat method, the oils with added leaf pigment extract had the lowest peroxide value and the highest stability. After 6 months of storage, the oxidative resistance of refined olive oil fell to 0.2 and to zero for enriched refined olive oil stored at 20 and 50°C, respectively. 相似文献
The kaolin-phosphoric acid mixtures with various percentages of phosphoric acid (5 wt%; 10 wt% and 15 wt%) have been investigated at room temperature. During the maturation and the sintering processes, acid reacts with aluminium of kaolin to give a new phase of aluminophosphate. This new phase's appearance has been confirmed by the thermal analysis, infrared spectroscopy, X-ray diffraction and scanning electron microscopy measurements before and after the sintering processes at different temperatures (800 °C, 1100 °C and 1250 °C). The rupture strength of the body-shaped samples made with the kaolin-phosphoric acid mixtures is higher than that of those made with only kaolin. The porosity decreases with both the sintering temperature rise and the addition of phosphoric acid in the mixture. The addition of 10 wt% of phosphoric acid to the kaolin decreases its calcined temperature by 200 °C. 相似文献
Date palm is an interesting source of bioactive compounds that could be used as ingredient in meat products; thus a campagne type pork liver pâté was elaborated using fresh date by-products (0, 5, 10 and 15%). Physicochemical properties, pigment and lipid oxidation, residual nitrite level, texture and sensory analysis during 4 days after the elaboration process were evaluated. Date paste mostly incorporated moisture, fibre and phenolic compounds. Physicochemical parameters, myoglobin content and heme iron stability were not severely affected. Addition of 10% of date was enough to avoid lipid oxidation through all storage times. Colour was the most affected parameter; however, in terms of overall acceptability, panellists preferred samples with added date. 相似文献
This article is devoted to the assessment of Tunisian agricultural production and food trade balance water-equivalent. A linear regression model relating annual rainfall to crop yields is developed to estimate the agricultural production water-equivalent. Its implementation is based on national data for crop and animal production, leading to food demand water-equivalent quantification. Results highlight the relationship between agricultural and water policies and provide a picture of food security in the country in relation to local agricultural production, and to virtual water fluxes related to foodstuffs trade balance. 相似文献