Nonstationary Simulation Model of Absorber with Falling Film of Suspension

A nonstationary model of SO₂ absorption from a gas phase to a countercurrent falling film of absorbing slurry was developed. Laminar, wavy and turbulent film structures were considered based on published information. Resistances to the mass transfer on the gas and the liquid sides of the interphase were considered, together with chemical reactions in the liquid phase. Relevant chemical equilibria in the liquid phase were modeled. Original experimental data on the neutralization reagent dissolution rate presented as a polydispersed two‐phase system of solids and on the rate of dissolved sulfite oxidation were used. The model was verified with experimental data from a laboratory‐scale falling‐film absorber using a single vertical tube under various geometrical and operating conditions, and a very good agreement was found with the experiment. Parametric sensitivity analysis showed the critical parts of the model.     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Topical use of aprotinin in open heart operations

Among various pharmacological agents used to reduce bleeding after open-heart operations, high-dose aprotinin therapy seems most promising. However, its long-term effects are still obscure; there is almost always possibility of bypass graft occlusions produced by the hypercoagulable state induced by aprotinin in coronary bypass operations. Topical application of aprotinin into the pericardial cavity could prevent the adverse effects. Fifty patients were prospectively studied to evaluate the effects of topical aprotinin. One million KIU of aprotinin was poured into the pericardial cavity before closure of the sternotomy in group 1 (n = 25). Patients in group 2 (n = 25) served as controls. Total postoperative bleeding was significantly reduced in group 1 when compared with that of group 2 (722.7 +/- 230.8 versus 1,282.6 +/- 225.7 mL; p < 0.01). The use of banked donor blood products was significantly less in group 1 than in group 2 (0.33 +/- 0.67 versus 1.36 +/- 0.86 units; p < 0.01). These results show that topical use of aprotinin reduces post-operative blood loss and need for transfusion. It seems promising and warrants further studies to be done.     

Experimental observation of temperature gradients occurring in a single zeolite pellet

An experimental study has been made of temperature profiles incident within a zeolite adsorbent particle in the course of adsorption of n-heptan. Using thermocouple wires 0.1 mm in diameter it has been possible to measure simultaneously the temperatures of the surface and in the centre. It was observed that temperature differences between center of the pellet and ambient stagnant gas may be more than 20°C. The results of this work indicate that the overheating of an adsorbent particle is a very rapid process which is followed by a slow cooling of the hot particle. Experimental data are compared with predictions calculated from the theoretical model.     

Study of rotational mobility of stable nitroxide radicals in solid polymers

The rotational mobility of stable nitroxide radicals in PS, PMMA, PVC, PP and PE has been studied over a wide temperature range by the e.s.r. method. At temperatures T lower than T_g, spin probes act as kinetically independent particles, the rotational frequency of which is deter mined mainly by the micropore dimensions of the polymer and depends indirectly on the mobility of segments or side groups.     

Flash memory efficient LTL model checking

As the capacity and speed of flash memories in form of solid state disks grow, they are becoming a practical alternative for standard magnetic drives. Currently, most solid-state disks are based on NAND technology and much faster than magnetic disks in random reads, while in random writes they are generally not.So far, large-scale LTL model checking algorithms have been designed to employ external memory optimized for magnetic disks. We propose algorithms optimized for flash memory access. In contrast to approaches relying on the delayed detection of duplicate states, in this work, we design and exploit appropriate hash functions to re-invent immediate duplicate detection.For flash memory efficient on-the-fly LTL model checking, which aims at finding any counter-example to the specified LTL property, we study hash functions adapted to the two-level hierarchy of RAM and flash memory. For flash memory efficient off-line LTL model checking, which aims at generating a minimal counterexample and scans the entire state space at least once, we analyze the effect of outsourcing a memory-based perfect hash function from RAM to flash memory.Since the characteristics of flash memories are different to magnetic hard disks, the existing I/O complexity model is no longer sufficient. Therefore, we provide an extended model for the computation of the I/O complexity adapted to flash memories that has a better fit to the observed behavior of our algorithms.     

A Constraint-Based Approach for Deriving 3-D Structures of Cyclic Polypeptides

This paper presents an hybrid algorithm for deriving 3-D structures of cyclic polypeptides. The algorithm combines constraint-based techniques with the most widely used methods for non-cyclic polypeptides. The empirical results demonstrate that the proposed hybrid algorithm outperforms traditional methods especially with respect to running times.     

Observation of a half-quantum-flux periodicity pattern in an rf SQUID with small critical currents

We have found experimentally that rf SQUID's working in a nonhysteretic mode with small critical currents give exactly at resonance and at very low rf bias a triangular pattern with a period equal to half of one elementary quantum of magnetic flux. We discuss a possible explanation of this peculiar result.