Identification of the adverse effect of nitrate on the phosphate release rate and improvement of EBPR process models.

The adverse effect of nitrate on the phosphate release rate in the anaerobic phase was observed and was hardly explainable with conventional EBPR process models. Four possible mechanisms were proposed including substrate competition, reduced fermentation, parallel reaction and sequential reaction. Batch experiments were designed and conducted to identify the dominant mechanism. Results showed that the sequential reaction was the only possible mechanism where only denitrification occurred if any nitrate existed in the anaerobic phase. Then the phosphate release following after the nitrate was completely removed. Nitrate inhibition effect was added into the PHA storage rate to incorporate the sequential reaction in the conventional ASM3 plus EAWAG bio-P module (ASM3 + P). Nitrate inhibition coefficient, K(I,NO,PAO) was found to be as low as 0.05 mg/L. This correlated well with experimental observation where no also meant that the anaerobic compartment of a continuous flow reactor could be seriously affected by the residual nitrate contained in the sludge recycle flow. This phenomenon caused overestimation of the phosphate uptake rate and consequently underestimation of PO4(3-) -P concentration. This problem was resolved by incorporation of a nitrate inhibition term in the ASM3 + P for more accurate simulation of the EBPR process.     

Reducing cycle times in manufacturing and supply chains by input and service rate smoothing

A key performance parameter of a manufacturing network or supply chain is its cycle time; the time that a typical item spends in the network. A previous simulation study on a semiconductor assembly and test facility showed that cycle times could be reduced by having smooth input and service rates. This suggested that there is a “cycle time principle” that, for a system with a specified throughput or input rate, the shortest cycle times are obtained when the input and service rates do not vary over time. We prove that this principle is true for the M/G/1 and M/M/s queueing systems and Jackson networks. The analysis involves establishing several results on the concavity of waiting time probabilities and the convexity of expected waiting times and queue lengths, as functions of input and service rates. These results also have natural uses in other optimization problems.     

Transient behavior of subthreshold characteristics of fullydepleted SOI MOSFETs

It has been found that the subthreshold currents of fully depleted silicon-on-insulator (SOI) MOSFETs show a transient behavior under certain front-gate and back-gate voltage conditions. The cause of this anomaly is explained, and applications for the phenomenon are pointed out. Particularly, a simple way to measure the silicon film thickness is suggested     

Suppression of boron penetration in p+ polysilicon gateP-MOSFETs using low-temperature gate-oxide N2O anneal

It has been reported that high-temperature (~1100°C) N₂ O-annealed oxide can block boron penetration from poly-Si gates to the silicon substrate. However, this high-temperature step may be inappropriate for the low thermal budgets required of deep-submicron ULSI MOSFETs. Low-temperature (900~950°C) N₂O-annealed gate oxide is also a good barrier to boron penetration. For the first time, the change in channel doping profile due to compensation of arsenic and boron ionized impurities was resolved using MOS C-V measurement techniques. It was found that the higher the nitrogen concentration incorporated at Si/SiO₂ interface, the more effective is the suppression of boron penetration. The experimental results also suggest that, for 60~110 Å gate oxides, a certain amount of nitrogen (~2.2%) incorporated near the Si/SiO₂ interface is essential to effectively prevent boron diffusing into the underlying silicon substrate     

Synthesis and characterization of a novel proton‐exchange membrane for fuel cells operating at high temperatures and low humidities

The synthesis of a p‐toluidine/formaldehyde (PTF) resin was performed, and the effects of the molar ratio of the individual monomers and the polymerization conditions on the structure of the PTF resin were studied. Fourier transform infrared and ¹³C‐NMR spectra were used to characterize the PTF. Wide‐angle X‐ray diffraction patterns revealed the crystalline structures of various PTFs. Polarized optical microscopy revealed that the molar ratio of the monomers had a strong effect on the crystalline morphologies. A longer polymerization time turned out a polymer with a higher intrinsic viscosity and molecular weight, which led to differences in the proton conductivity. All of the PTFs showed a higher proton conductivity than a commercial Nafion membrane at 90–100°C and 0% relative humidity. The proton conductivity of the PTF series could be improved by sulfonation with sulfuric acid and could be maintained after blending with polyurethane. Pure methanol could be used as a fuel source because of the insolubility and nonwetting properties of PTF in methanol to increase the output current density for a PTF membrane electrode assembly. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Methacrylic acid–acrylamide-g-poly(ethyleneterephthalate) fibres for urea hydrolysis

This paper presents the results of urease immobilization onto methacrylic acid–acrylamide grafted poly(ethyleneterephthalate) fibres. The graft yield strongly affected the maximum activity of the immobilized enzyme up to a value of 70·2%. Higher grafting caused a decline in urease activity and led to the degradation of the fibres. The minor changes observed in K_m and V_max demonstrated that the conformational changes existed during immobilization were not extensive. However, 70·2% methacrylic acid–acrylamide-g-fibres containing urease were more stable towards acidic and alkaline pH, high temperature and storage conditions compared with free enzyme. Apart from the increase in stability to heat inactivation, the initial enzymatic activity of the urease–fibre system remained almost unchanged even after 40 repeated assays corresponding to 10 h of operation in 4 months, indicating the excellent durability of the system.     

Intelligent copyright protection system using a matching video retrieval algorithm

Many video service sites headed by YouTube know what content requires copyright protection. However, they lack a copyright protection system that automatically distinguishes whether uploaded videos contain legal or illegal content. Existing protection techniques use content-based retrieval methods that compare the features of video. However, if the video encoding has changed in resolution, bit-rate or codec, these techniques do not perform well. Thus, this paper proposes a novel video matching algorithm even if the type of encoding has changed. We also suggest an intelligent copyright protection system using the proposed algorithm. This can serve to automatically prevent the uploading of illegal content. The proposed method has represented the accuracy of 97% with searching algorithm in video-matching experiments and 98.62% with automation algorithm in copyright-protection experiments. Therefore, this system could form a core technology that identifies illegal content and automatically excludes access to illegal content by many video service sites.