庄河地区水资源现状浅析

本文通过对庄河地区水资源的分析及未来需水量的预测,计算其区域余水量。以确定区域经济的规划。     

On the performance of band-limited asynchronous DS-CDMA over nakagami-m channels

In this paper we investigated the BER performance of DS-CDMA using various chip-waveforms, which include three time-limited chip-waveforms and two band-limited chip-waveforms. Closed-form formulae were derived for evaluating the achievable bit-error rate performance with the aid of the standard Gaussian approximation, when communicating over a Nakagami-m channel. The time-limited waveforms impose a low implementational complexity, since they maybe over sampled and read from a look-up table. However, they are outperformed by the frequency-domain raised-cosine waveform as well as the optimum waveform specifically designed by Cho and Lehnert for achieving the lowest possible bit error rate     

DVB-T调制器外码编码器的FPGA设计

设计并实现了一种DVB—T调制器的外码编码器，着重介绍了码流自适应接口、能量扩散、RS编码器及卷积交织器的设计方法，该设计方案最终在Altera的FPGA上进行验证。     

Tracing of the 1st IEC Secretariat Assumed by China

Introduction The IEC central office informed in 7/543/AC that the secretariat of TC 7 would be taken over by the Chinese National Committee on January 10, 2003 and affirmed subsequently in 7/544/AC that the secretariat of TC 7 has been taken over by the Chinese National Committee which appointing secretary in Shanghai Electric Cable Research Institute as no objection has been raised by the Standardization Management Board members. It's the first IEC secretariat that assumed by China, with great significance, just as commented by the media that the commitment indicate undoubtedly China is to play a much more active and important role in the world especially after its entry into world trade organization as well as the trend of global economic integration.     

纳米AlN粉末的制备与烧结

利用低温燃烧合成前驱物制备出平均粒度为100 nm的AlN陶瓷粉末,比较了该粉末的常压烧结和放电等离子烧结的特性.实验表明:以合成的AlN粉末为原料,添加5%(质量比)Y2O3作为烧结助剂,在常压、流动N2气氛下1600℃保温3 h,制备出平均晶粒尺寸为4～8 μm、密度为3.28 g·cm-3的AlN陶瓷;将同样的粉末不加任何烧结助剂,采用SPS技术在1600℃保温4 min,得到密度为3.26 g·cm-3的AlN陶瓷,晶粒度约为1～2μm.     

川合137井大修井工艺技术浅析

在川合137井的修井作业中，运用了多种修井工具和工艺技术。通过内捞、外捞、强提、倒扣、磨铣、套铣、开钻新井眼和铣锥通井的方法，充分解放了油气层，达到了修井目的。其独特的想法、施工和自制工具的成功应用对今后大修井作业具有很高的参考价值。     

Performance and Commercial Application of the Promoter LCC-A for Maximization of Propylene Yield

1 Introduction Propylene as an important feedstock for organic chemicals is mainly originated from steam cracking and catalytic cracking processes. During the FCC process the propylene content varies with the FCC catalyst and process technology adopted, resulting in significant difference in propylene concentration in the cracked product——LPG. The conventional FCC pro- cess generally gives a propylene yield of around 4%, while the FCC process with maximization of propylene yield can in…     

含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

相关条件下基于N-P准则的分布式检测理论研究

本文针对并行网络、二元局部判决的情况,研究了在相关条件下基于N-P准则的分布式检测融合算法,给出了在联合概率密度已知和未知两种情况下的最优融合规则的理论推导及相应的解决方案,并在实验仿真的基础上,得到了部分有益的结论。     

多带抗噪声语音识别算法研究

根据Flether等人的研究,基于感知独立性假设的子带识别方法被用于抗噪声鲁棒语音识别。本文拓展子带方法,采用基于噪声污染假定的多带框架来减少噪声影响。论文不仅从理论上分析了噪声污染假定多带框架在识别性能上的潜在优势,而且提出了多带环境下的鲁棒语音识别算法。研究表明：多带框架不仅回避了独立感知假设要求,而且与子带方法相比,多带方法能更好的减少噪声影响,提高系统识别性能。